最远的

The details as follow: 1.Based on rules about form error in GB, mathematical models of form error are established including straightness error on the base of minimizing zone method、least-squares method and two dots linked method ; flatness error based on minimizing zone method、lease-squares method、diagonal line and three dots method; circularity and cylindricity error based on minimizing zone method、lease-squares method、minimum circumscribed circle and maximum inscribed circle.

具体内容如下：根据国标中形状误差的相关规定建立了各种要素评定方法的数学模型包括：直线度的最小区域法、最小二乘法、两端点连线法；平面度的最小二乘法、最小区域法、对角线法、三远点法；圆度和圆柱度的最小区域法、最小二乘法、最小外接圆法、最大内切圆法。

The results showed that the best carbon source was sucrose in which sporulation (16.13×10^7 conidia/cm^2) and extracellular protease 117.38 μg/(minmL reached the highest. The bean cake was the best nitrogen nutrition in which the quantity of conidium (15.62×10^7 conidia/cm^2) and extracellular protease 74.01 μg/(minmL were much higher than that of the contrast and inorganic salts.

综合各项指标得出，HFW-05菌株生长的最适碳源为蔗糖，产孢量与产酶量最大，分别为16.13×10^7孢子／平方公分和117.38μg/；最适氮源为豆粕粉，其产孢量和酶活远高于对照和无机盐类，分别为15.62×10^7孢子／平方公分和74.01μg/。

The three groups were loaded and analyzed under the same loading according to the mean value of the bite force of incisors. RESULTS:(1)The maximum stress of dentin in group A was twice higher than that in group B. The maximum primary stress, minimum primary stress and maximum shear stress of group A were respectively 236.35, 228.83 and 218.05 percent of those in group B. The difference of maximum stress values of group B and group C was neglectable.(2) The maximum stress distribution of dentin in group A and group B was quite different (the stress was concentrated in labial and lingual side of the cervical dentin in group A, otherwise in group B it was concentrated in the area around the alveolar and the labial and lingual side of the dentin which was opposite to the tip of the cast metal post and core). The maximum stress distribution of dentin in group A and group B was almost the same.

结果：(1)从牙本质的应力大小来看，A组中牙本质最大应力值比B组中牙本质最大应力值增大了1倍以上（最大主应力、最小主应力和最大剪切应力A组分别是B组的236.35%、228.83%和218.05%），而B组与C组的牙本质最大应力值相差极小；(2)从牙本质的应力分布位置来看，A组与B组的牙本质最大应力分布位置相差甚远（A组主要集中在牙颈部唇舌侧肩台部的牙本质上，B组主要集中于牙槽嵴顶附近及铸造桩核尾端相对应的唇舌侧的牙本质上），而B组与C组的牙本质最大应力分布几乎在同一位置。

Synoptophore combined with Yans randomdot stereograph was employed for distant stereopsis. Furthermore, the identifying time for minimal threshold of distant stereopsis was measured simultaneously.

200608/200612间观察在我院行 LASIK 手术的46例中、高度近视患者，于术前，术后1wk，术后1mo检查远体视锐度（包括交叉视差和非交叉视差）及测量远立体视锐度最小辨别阈值的辨认时间。

And more recently, it has been working in monocularly camera system have developed out of the interchangeable lens type digital camera, a journalist or professional photographer, because the old cameras equipped with and it is compatible with the camera, but in monocularly motorsied and rich control in place, and to use this old advanced in monocularly camera, the only disadvantage is that there is still a lens multiplication problem, to the wide angle shooting embitterthe, but improvement of aircraft and will soon be listed but by large camera with digital back systems are commercial photography only because the file is large, and you can control the level of the grass, and so on up-dip perspective, but price and a gateway to nearly one million, and the economy.

而最不远由老牌不复眼相机编制所成长不入的可互换镜头式数字相机，是故事记者或副业影相师的最爱，因为旧有镜头等配备和其编制兼容，而不复眼相机的机动性与丰裕的操控功用包罗万象，和搁置原有矮档不复眼相机实在一模差别，独一弊端是仍有镜头倍率的题目，给广角拍摄时甚为悲苦，但保守机种很快不离会上市！而由不小型相机配上数字机不面的编制是贸易影相的钝器，因为其档案较不小，又可把持仰俯等透视角度，但代价不远百不一，经济门坎较矮。

Lv Baiwang expresses, although Yang Zhiyuan ever was " Microsoft Yahoo is bought case " one of the biggest anti, but Yang Zhiyuan is nonofficeholding buy to this case had affected without materiality.

吕伯望表示，虽然杨致远曾是&微软雅虎并购案&的最大反对者之一，但杨致远是否下台对该并购案已经没有实质性影响。

Four thin-layer drying models were investigated for the description of FIR-assisted freeze-drying characteristics. The models were exponential model, Page model, diffusion model, and approximation of the diffusion model. Tests were conducted using a three-level, three-factor (drying temperature, distance between sample and FIR heater, and sample thickness) design, and quadratic polynomial analyses were performed to relate the drying parameters of thin-layer drying model. The performance of these thin-layer drying models was evaluated by comparing the coefficient of correlation (R2), the sum of squares, and the RMSE amongst four models. Drying parameter K of the Page model gave the best results in describing freeze-drying with FIR of Tylose and sweet potato.

运用四种薄层乾燥模型（指数、Page、渗透模型及近似渗透模型）研究远红外线冷冻乾燥之乾燥特性，实验采用三阶层、三因子（远红外线加热器设定温度、远红外线加热器至样品表面之距离及样品之厚度）的实验设计，对於薄层乾燥模型的乾燥参数以二次多项式函数表示之，乾燥参数之二次多项式函数的最适性判断主要是藉由决定系数、模式缺乏适合性及均方根误差等值的比较而加以评估，以Tylose及甘薯样品而言，其中四种薄层乾燥模型的乾燥参数以Page模型之K值的结果为最佳。

Base Station type Software versionTypes of carrier frequency board adoptedTypes of combiner adoptedWhether had obtained the network license or notIndoor type or outdoor type Whether the master port is separated from the remote-port The maximum carrier frequency capacity of single cabinet The maximum supportable sector numbers of single cabinetWhether it is dual-carrier frequency board or notMust it be paired configuration if it's dual-carrier frequency board (namely, the type of single carrier frequency station could only configure the dual-carrier frequency on hardware) The maximum achievable configuration of a single station of the single cabinetReceiver sensitivity The maximum expand capacity of a single base station (the maximum number of TRX in configuration / the number of cabinets which is required)(fill in according with the three sectors) Top box transmitted power (given separately a grade one combine and a grade two combine) The maximum output power of amplifier (voice, a single logical carrier frequency) The maximum output power of amplifier (EGPRS, a single logical carrier frequency)Whether it has tower-interfaceWhether it has built-in lightning protectionWhether it support the ultra-long cover / whether it need for software support (give simple description that how hardware and software could achieve this) The supporting condition of EGSM (it should be supported including by the carrier frequency, combiner) Dual-band carrier wave (whether it supports the mixed use of 900 M/1800M in the same cabinet) The commonality of duplicate parts Whether it can built-in transmission unitThe single cabinet size (high × width × deep) Installation method Whether it can place against the wallThe basic frame full-configured weight and the supportable number of carrier frequencyThe expansion frame full-configured weight and the supportable number of carrier frequency

基站型号软件版本号采用载频板型号采用合路器型号是否已取得入网许可室内型or室外型是否是主远端分离单机柜最大载频容量单机柜最大支持的扇区数是否是双载频板如是双载频板，是否必须成对配置(即单载频站型只能硬件配置双载频)单机柜可达到的单站最大配置接收机灵敏度单基站最大扩展能力(最大配置TRX数/需机柜数)(按3扇区填写)机顶发射功率(分别给出一级合路与两级合路)功放最大输出功率功放最大输出功率(EGPRS，单个逻辑载频)有无塔放接口有无内置避雷装置是否支持超远覆盖/是否需要软件支持(简单描述软硬件如何实现)EGSM支持情况(包括载频、合路器均应支持)双频段载波（是否支持900M/1800M在同一机柜内混合使用）备件通用性是否可以内置传输单元单机柜尺寸安装方式可否靠墙放置基本架满配重量及支持载频数扩容架满配重量及支持载频数是否支持基本架与扩容架跨扇区满配功耗满配时重量供电方式机柜进出线方式合路器损耗合路能力：几合一单扇区最大支持几载频合路到一副天线/采用几个合路器单扇区载频达到需要增加一副天线时，是否支持两级合路换以不增加天线如两级合路插损为是否支持基带跳频和合成跳频每单个合路器在从低载频数向高载频数扩容时，是否还需要增加硬件可用性指标MTBFMTTR系统中断服务时间硬件是否支持EGPRS本次报价软件版本号开始支持EGPRS的软件版本号其他特点注： 1 应分别填写出来按照本次报价要求所采用的全部BTS型号和采用的合路器型号 2 列出本报价要求的全部室外型基站与高功放单元

It will decrease when the pointing angle increases,and vice versa.By giving a pixel size of 20 μm for a detector,an orbit altitude of 600 km and a beam deflexion angle low than 30° for the imaging spectrometer, the effective focal length of the telescope was calculated(400,470 or 435 mm),and the relation curves between the relative ratios of ground resolution and the beam deflexions were presented.

给定成像光谱仪探测器像元尺寸为20 μm，飞行轨道高度为600 km，光线摆角≤30°，以星下点、最大摆角和整个运动补偿段地面分辨率中值为30 m为依据来计算望远系统的焦距，求得望远系统焦距为400、470、435 mm，并给出了此时的地面分辨率相对比值与光线摆角的关系曲线。

Several unusual properties make this object particular interesting:(1) ultra-luminous near and far infrared (L〓≈10〓L〓, and L〓≈10〓 L〓) emission,(2) very strong optical Fe Ⅱ emission (R〓≈4.35),(3) apparently blueshifted optical Fe Ⅱ multiplets (several hundred km/s),(4) the strongest radio emission among radio-FIR selected NLS1's and extreme Fe Ⅱ emitters,(5) composite Balmer lines with both narrow and broad components (the latter blueshifted by about 1000 km s〓).

我们发现2MASS0153+260为首例超强光学FeⅡ线射电类星体，具有如下极为有趣特征：(1)远红外和近红外光度非常高，L〓≈10〓 L〓且L〓≈10〓 L〓；(2)光学FeⅡ线发射特别强，R4570≈4.35；(3)光学FeⅡ线相对于禁线和氢Balmer线窄成分有明显蓝移，Δυ～4×10〓kms〓；(4)在射电-远红外选NLS1和超强光学FeⅡ线AGN中射电辐射最强；(5)具有复杂的Balmer发射线轮廓，宽成分相对于窄成分和禁线有～1000km s〓的蓝移。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。