最小值

The results showed that:(1) The characteristic frequency of IC neurons of house mouse was increased with increasing recording depth, and the masker intensity used was positive relevant to the IC neurons\' minimum threshold. When the minimum threshold was high, the masker intensity needed was loud, vice versa.(2) According to the masking rate at MT+10dB of IC neurons to frequency modulation and tone burst, the IC neurons were classified as three types: type I neurons ( 72/113, 63.7%), in which the masking effect of TB was better than frequency modulation ;type II neurons (32/113, 28.3%), in which the masking effects of the two maskers were same; type III neurons( 9/113, 8.0%), in which the masking effect of FM was better than TB.(3) Type I neurons, the minimum threshold of which was low, but the Q_(10) and DR values of which were large; in type III neurons, the minimum threshold was high, the Q_(10) and DR values were narrow; in type III neurons, the MT Q_(10) and DR values were in between.(4) Both FM and TB could make the MT of type I neurons shift upward distinctively, but the effect of TB was more significant than FM.(5) The Q_(10) values of type I neurons became narrower under the influence of TB, were unaffected under the influence of FM.

结果显示：(1)小鼠下丘神经元的特征频率随着记录深度的增加而增高，掩蔽声强度与神经元的最小阈值呈正相关，即对高最小阈值的神经元进行掩蔽时需要的掩蔽声强度高，对低最小阈值神经元进行掩蔽需要的掩蔽声强度低：(2)根据调频声(frequency modulation， FM)和短纯音(tone burst， TB)对下丘神经元阈上10dB处反应的掩蔽，将小鼠IC神经元分为三类：Ⅰ类神经元(72/113，63.7％)，短纯音的掩蔽效果比调频声更好；Ⅱ类神经元(32/113，28.3％)，两者对神经元声反应的掩蔽率相同；Ⅲ类神经元(9/113，8.0％)，调频声的掩蔽效果更好；(3)Ⅰ类神经元的最小阈值低、Q_(10)值和动态范围大，Ⅲ类神经元最小阈值高、Q_(10)值和动态范围小，Ⅱ类神经元的最小阈值、Q_(10)值和动态范围介于Ⅰ和Ⅲ类神经元之间；(4)短纯音和调频声都可以使Ⅰ类神经元声反应的最小阈值明显上移，但短纯音使神经元最小阈值的上移更显著：(5)短纯音使Ⅰ类神经元的Q_(10)值变小，调频声使神经元的Q_(10)值增大不显著，短纯音与调频声对神经元Q_(10)的影响差别显著；(6)短纯音与调频声都使神经元的动态范围减小，并且作用显著，但短纯音的效果更显著：(7)短纯音与调频声都使神经元反应的潜伏期延长，效果显著，但TB的延长作用更为显著；(8)随着探测声强度的升高，短纯音和调频声对Ⅰ类神经元声反应的掩蔽率都降低，但在各个探测声强度短纯音的掩蔽率都比调频声高。

The three groups were loaded and analyzed under the same loading according to the mean value of the bite force of incisors. RESULTS:(1)The maximum stress of dentin in group A was twice higher than that in group B. The maximum primary stress, minimum primary stress and maximum shear stress of group A were respectively 236.35, 228.83 and 218.05 percent of those in group B. The difference of maximum stress values of group B and group C was neglectable.(2) The maximum stress distribution of dentin in group A and group B was quite different (the stress was concentrated in labial and lingual side of the cervical dentin in group A, otherwise in group B it was concentrated in the area around the alveolar and the labial and lingual side of the dentin which was opposite to the tip of the cast metal post and core). The maximum stress distribution of dentin in group A and group B was almost the same.

结果：(1)从牙本质的应力大小来看，A组中牙本质最大应力值比B组中牙本质最大应力值增大了1倍以上（最大主应力、最小主应力和最大剪切应力A组分别是B组的236.35%、228.83%和218.05%），而B组与C组的牙本质最大应力值相差极小；(2)从牙本质的应力分布位置来看，A组与B组的牙本质最大应力分布位置相差甚远（A组主要集中在牙颈部唇舌侧肩台部的牙本质上，B组主要集中于牙槽嵴顶附近及铸造桩核尾端相对应的唇舌侧的牙本质上），而B组与C组的牙本质最大应力分布几乎在同一位置。

In the studying of image segmentation, six crucial technologies havebeen developed successfully. 1 In one dimension histogram of original DRimage of luggage, there remain maximum-value wave crest havingapproximately stationary position, and the first minimum to the left of thewave crest performs excellently to be used to get rid of background of DRimage. 2 Open operation, one type of math morphology, is the right idea toerase luggage disturbance in DR image and at the same time, can be retaininteresting region appropriately. 3 After open operation, there are only a few minimums on image histogram, one of which can be to segment image furtherand achieves satisfying result. 4 Method of histogram analyzing and that oferosion performs well in the re-segmentation of conglutinative region in DRimage. 5 Method of image distance switch can ensure Luggage CT sectionautomatically obtained to have rich suspicious region information. 6 Todecompose structure element of math morphology is a way to save a great dealrunning time for automatically discerning interesting regions algorithm,apparently improving implementation efficiency.

在对图像可疑区域分割研究中，主要开发成功以下几项关键技术：1发现原始箱包DR图像的一维直方图中，均具有位置相对稳定的最大值波峰，以波峰左边第一个极小值为分割阈值，去除DR图像背景，效果非常好。2运用数学形态学中的开运算能够非常有效地去除箱子的干扰，同时能够比较好地保留可疑区域。3发现开运算后的DR图像直方图只有若干个极小值点的特点，其中用最大值波峰左边的第二个极小值点进一步分割DR图像，能够更有效地提取箱包中的可疑区域。4运用直方图分析法和腐蚀法，对粘连区域实行再分割，效果较好。5运用距离变换法，能确保自动设定的箱包CT截面包含丰富的可疑区域信息。6运用形态学结构元素分解技术，大幅度减少可疑区域的自动判别算法运行时间，提高算法软件执行效率。

The measure of top dressing KNO_3 can increased potassium contents of cured tobacco's leaves.

美国烤烟的含钾量一般为4%～6%，有的甚至高达8%～10%[1，2]；而云南烤烟的含钾量(K2O)平均为2 05%，最小值

Credit card debt remains minimal — 85% of cardholders pay the full balance off each month.

信用卡债务仍然维持在最小值-----有85%的持卡人每月支付相抵保持平衡。

Simulation annealing is a technique which can be applied to any minimisation or learning process based on successive update steps where the update step length is proportional to an arbitrarily set parameter which can play the role of a temperature.

即：模拟退火算法是一种能应用到求最小值问题或基本先前的更新的学习过程。在此过程中，每一步更新过程的长度都与相应的参数成正比，这些参数扮演着温度的角色。

As we know, if one mode of the electromagnetic field is prepared in a squeezed state, the quantum fluctuation of one of its quadrature components can be lower than that of the corresponding part in a coherent state and that of the other is higher, and we can tune the signal-to-noise ratios of its quadrature components: one of the quadratures can be used to absorb the quantum-mechanical noise, while the other one serves to transmit an extremely well-defined signal.

由于压缩态中光场某一分量的量子涨落可以小于相干态中的量子涨落，即可以小于量子涨落的最小值，因此可以用来改变信号传递的信噪比，从而在低噪声通讯、弱信号探测、高精密测量等方面具有重要的应用前景。

The results show that the plasticity zone and dynamically quiescent layer become fine equiaxed recrystallisation under the thermo-mechanical effect, the grains in the heat-affected zone grow up because of the effect of friction heat. When the rotation speed is 2 500 r/min and the welding time is 12 s, good joint is achieved, and the tensile shear strength of the joint reaches 9.24 kN. The tensile shear strength of spot increases with increasing tool rotation speed, with increasing welding time, the strength increases first, while then reduces. The microhardness of plasticity zone is high, but is slightly lower than that of the base metal, the minimum value of microhardness is in the heat affected zone. When the energy input of joint is high, the fracture type of spot is mode Ⅰ, and the tensile shear strength is high; on the contrary, when the energy input of joint is less the fracture type of spot is mode Ⅱ, and the strength is low.

结果表明：塑性区和动态静止层的晶粒在热和力作用下发生动态再结晶形成细小的等轴晶，热影响区的晶粒在摩擦热作用下长大变粗；搅拌头旋转速度为2 500 r/min，焊接时间为12 s时，可以获得力学性能较好的焊点，焊点的剪切强度达到9.24 kN；焊点的剪切强度随搅拌头旋转速度的增大而增大，随焊接时间的延长先增大后减小；塑性区的显微硬度较高，但略小于母材，接头显微硬度的最小值分布在热影响区；焊点热输入量较多时，接头为Ⅰ型断裂，焊点的剪切强度较高；焊点热输入量较少时，接头为Ⅱ型断裂，焊点的强度较低。

The type of the limit state function is set up according to the Mohr-Coulomb yield criterion which can consider the direction of the slip surface; and the derivatives of the stress to the basic stochastic variables of the slope are computed by using partial differential method based on the incremental tangent stiffness method and the accelerating convergence method of Aitken.

其中功能函数的形式是以考虑滑面方向的Mohr-Coulomb屈服准则来建立的；导数的求解采用的是基于增量切线刚度法及Aitken加速算法的偏微分法；边坡整体可靠指标取的是所有可能滑面的可靠指标的最小值。

The energy which drives the evolution of a curve is constructed based on local image information,the alignment term enhances the speed of curve evolution,and the improved data fitting term which is based on the competition between of the shifted Heaviside functions,makes the curve converge to a better global stationary minimum.

该算法基于图像局部化信息创建驱动曲线演化的能量，引入的配准项提高了曲线的演化速度，基于曲线演化竞争的数据拟合项，使得曲线能更稳定地收敛到一个全局静态最小值，且算法对水平集函数初始化位置不敏感。

I didn't watch TV last night, because it .

昨晚我没有看电视，因为电视机坏了。

Since this year, in a lot of villages of Beijing, TV of elevator liquid crystal was removed.

今年以来，在北京的很多小区里，电梯液晶电视被撤了下来。