最小
- 与 最小 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
In this paper, firstly, the theory and the discretization schemes of LBIE and the concepts of MLS and GMLS are introduced; secondly, LBIE method is applied to solve the thin plate-bending problems and four typical examples are given to demonstrate the applicability and validity of the method. The results obtained from numerical examples agree well with the exact solutions and have an excellent rate of convergence.
本文首先介绍了无网格局部边界积分方程方法的理论基础和离散步骤,以及移动最小二乘近似法和广义移动最小二乘近似法等概念;其次将该方法初步应用于计算薄板的弯曲问题,建立了完整的积分公式,求解了四个典型算例,结果同精确解非常接近,且收敛快。
-
The focus is on applications of linear models, including generalized least squares and two-stage least squares, with probits and logits for binary variables.
重点是线性模型的应用,包括广义最小二乘和两阶段最小二乘probits和二元变量logits。
-
The bulk transfer coefficients change during a day, reach the maximum at noon and the minimum at night.
总体输送系数具有明显的日变化特征,中午时段最大,夜晚最小;总体输送系数与大气稳定度存在明显关联,文中给出它们之间的拟合关系式;随着高度的增加总体输送系数减少,但减少幅度逐渐变小。
-
The three-sided measurement method and the least squares estimation method based on the three-sided method are improved for a specific set of assumptions.
在一定先验假设情况下,对三边测量法以及由其衍生出最小二乘估计进行改进,并将抗差最小二乘估计方法引入到节点定位计算之中。
-
A three-sided measurement method,a weighted least squares estimation method and a robust least squares estimation method are used to make wireless sensor network node localization more accurate.
为提高无线传感器网络节点定位精度,提出3种基于距离信息的改进定位算法:改进三边测量法、加权最小二乘估计、抗差最小二乘估计。
-
Surface relief caused by the formation of lower bainite in an Fe-C-Si-Mn alloy has been investigated by STM. It was discovered that the subunit which is the lowest structural unit observed by TEM is actually made up of sub-subunits. The surface relief due to the formation of sub-subunit is tent-shaped, and of a non-IPS type, which indicates that the sub-subunit cannot be formed by shear. The height of relief is 60-140nm, and the maximum shape deformation is ca.
用扫描隧道显微镜对Fe-C-Si-Mn合金中的下贝氏体浮突进行了观察研究发现用透射显微镜观察到的最小结构单元——亚单元是由更小的超亚单元组成的超亚单元的浮突为&帐篷&型,而非不变平面应变型,表明它不是切变形成;超亚单元的浮突高度为60-140nm,最大形状变型量约为0.23。
-
By putting forward the concept of the superimposed effect of the stress dispersion, this paper has pointed out that there was a minimum reinforced space, and gave the formula of it at this foundation.
本文提出扩散应力&叠加效应&的概念,指出在加筋土结构中存在最小加筋间距,在此基础上给出最小加筋间距的计算公式。
-
All factors affecting relative sensitivity are analyzed.The sensitivity of slide bridge and its influence on the measured resistance Rx are discussed.The condition of the minimum relative error is theoretically given.
并在此基础上讨论了滑线电桥的灵敏度及其对所测电阻 Rx 的影响,从理论上给出了滑线电桥最小相对误差的条件:要使滑线电桥灵敏度所引起的相对误差最小,电桥平衡点的位置应按待测电阻 Rx 与检流计内阻 Rg 的比值来确定。
-
Then, we take forward to the Distributed Merging Algorithm, a hierarchical structure to discover the stream synopsies from all leaves to root node, through setting the precision gradient to optimize the communication load and overhead of distributed system.
并提出了基于Lossy Counting算法的、分布式的合并算法DMA的一种分层结构来发现从叶子结点直至根结点的概要结构,并通过设置精确梯度使网络数量最小及数据中心和网络链接所消耗的计算资源最小来优化分布式系统的通信负载。
-
The reason of low system efficiency of the mechanical lifting is: unavailable match between transformer and asynchronous motor with large capacity of equipment and large self-consumption; large average no load less of Y series electrical machinery (31.4% of the total oilfield electrical machinery) with 2.86kw; limited adjustable extent of stroke of the electrical machinery in low-liquid produced wells with minimum value of 4 times per minute for limitation of minimum rotation of the electrical machinery and minimum arc of contact of pulley. Energy consumption will be waste for 1 to 1.5 times per minute is enough.
分析显示,造成抽油机系统效率低的原因主要是:变压器与异步电动机之间匹配方式不合理,设备容量大,自身损耗大;占油田电机总量31.4%的Y系列电机的平均空载损耗大,为2.86kW;低产液井电机的冲次可调范围有限,受电机最低转度和皮带轮最小包角限制,其最小冲次仅可调到4次/min,但1~1.5次/min的冲次即可满足生产需要,造成能耗浪费。
- 推荐网络例句
-
Do you know, i need you to come back
你知道吗,我需要你回来
-
Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.
1〕 杨银书,王祥生,李德昌。安徽省首次发现嗜群血蜱。
-
Chapter Three: Type classification of DE structure in Sino-Tibetan languages.
第三章汉藏语&的&字结构的类型划分。