最大长度

For a flat plate the maximum deflection shall be limited to one half of the plate thickness and 1/400 of the unsupported length for a beam.

对于扁板的最大挠度应限制在板厚的一半，对于梁的最大挠度应限制在未支撑长度的1/400。

Integrated with the calculation methods of soil pressure, the mechanism of soil pressure of fale is studied systematically and detailedly based on the mode of axial stress distribution of wholly grouted anchor.

在全长粘结式锚杆拉力分布模型基础之上，结合本文的土钉土压力计算方法，本文对面层土压力机理进行了系统详细的研究，提出了面层局部土压力、面层土压力及土钉最大拉力的计算公式和分布模型，理论分析和实例分析表明，本文提出的轴力分布模型和面层土压力机理是合理的，解决了面层土压力取值标准问题，为面层设计提供了定量的依掘，土钉最大拉力可直接用于土钉长度设计。

Mangium is of the greatest average vessel length, which are 1179.6μm and 333.1μm respectively. Fiber morphology of all four Acacia species is in accord with the requirement on pulping and papermaking so the 4 Acacia timbers can be used for pulpwood.

结果表明，厚荚相思的纤维平均长度最大为1179.6μm，而马占相思的导管平均长度333.1μm为最大。4种相思木材的纤维微观形态可以满足制浆造纸的要求，可以作为纸浆材使用。

S.From all the patients with MB-MCA and whose MCA were encased by the myocardium completely,30 patients were choosed randomly,their datasets were reconstructed seriatim by every 5%R-R interval,the whole cardiac cycle were reconstructed by 20 phases,the diameter of the mural coronary arteries of every phase was reviewed and measured,the phases were found out where the diameters were maximal and minimal,the systolic compression rate was calculated,Pearson correlation analysis was used to analyze the relation between length,depth,and degree of systolic compression of the mural coronary artery.

s表示。在所有存在MB-MCA并且MCA被心肌完全包饶的病例图像中，随机抽取30例图像的数据，以每隔5%R-R间期为一个重建时相，对每个病例0.100%整个心动周期分20个期相进行重建，观察并测量MCA在整个心动周期中管径的变化，探索管径最大和最小时的时相显示规律，计算MCA最大狭窄程度，应用Pearson相关统计分析MCA狭窄程度与MB的长度及厚度之间的相关关系。

D1.1 of the AISI Specification limits the maximum longitudinal spacing of connections to ... where smax = maximum permissible longitudinal spacing of connectors L= unbraced length of compression member rI = radius of gyration of I-section about the axis perpendicular to the direction in which buckling would occur for the given conditions of end support and intermediate bracing rcy = radius of gyration of one C-section about its centroidal axis parallel to the web.....

因此，AISI规范第D1.1节限定连接的最大纵向间隙为：，式中 smax =连接体允许的最大纵向间隙 L=抗压构件的自由长度 rI =工字钢对垂直于给定端承和中间肋条件下可能产生纵向弯曲方向的轴的回转半径 rcy =一段U型钢对其平行于筋的质心轴的回转半径。。。。。。。

In practice, if the current string is shorter than the previous one or if the matching length is longer than the farmost index distance or if it's the best matching, searching operation is ended.

在实际中，终止寻找匹配应符合：当前匹配长度小于前一匹配长度，超过最远索引距离，达到最大匹配等3个条件。

Measurements of the length of the hindlimb bones indicated that the tibiotarsus is invariably the largest among the three major leg bones.

即在所有鸟类的后肢骨骼中，胫跗骨的长度占3块骨骼的比例为最大；地栖鸟类后肢骨骼中股骨的长度要短于跗跖骨；树栖鸟类后肢骨骼中股骨的长度要长于跗跖骨。

The marginal division was a flat fan-shaped structure with a volume of (0.48±0.02) mm3, a maximum rostral-caudate axis of 1.6 mm, a maximum dorsal-ventral axis of 2.158 mm, and a widest axis (the diameter at lateral-medial coronal brain section) of 0.17 mm. The marginal division also moved progressively externally from the rostral section to the caudate section, but its scope was larger than that of others. The whole marginal division changed evenly from the rostral section to the caudate one. Its flat structure widened progressively and its dorsal-ventral diameter narrowed gradually and became plate-shaped.

边缘区呈现一个片状扇形结构，体积为(0.48±0.02) mm3，最大嘴尾径为1.6 mm，最大背腹径为2.158 mm，最大内外径为0.17 mm；同尾壳核和苍白球一样从嘴侧到尾侧随着脑平面的增宽边缘区亦逐渐向外侧移位，其移位的幅度亦明显大于脑平面增宽的幅度；整个边缘区从嘴侧到尾侧呈均匀变化，其片状逐渐变宽，长度逐渐变小，从而形成一个盘状结构。

The main research tasks and results are as follows:(1) Through comparing the stress intensity factor of compact tension specimen calculated by finite element software with the theoretical value, the feasibility of calculating fracture parameters of crack tip in ABAQUS software was verified.(2) The relationship between the elastic modulus of the material and research scale was studied based on deriving the cohesive stress theory and other relevant theories. And the elastic modulus of the material on meso-scale was determined.(3) Global model and sub-model of the finite element were built in th...e macro-scale, and stress-strain field nearby the crack tip was analyzed, and the results show that the detailed stress-strain in the crack tip could be obtained by using the sub-model technique.(4) In meso-scale, the crack growth model was also established by assuming the crack propagating along the grain boundary, and the detailed stress-strain field in the crack tip was obtained.(5) The effect of crack length on Von Mises stress, and maximum principal stress and strain was analyzed in meso-scale when equivalent KI equals 30MPa.m1/2. And the results show that except for crack tip area, the stress-strain distribution in whole specimen is not affected.

主要完成研究内容和取得成果如下：(1)利用有限元软件计算出紧凑拉伸试样的裂纹尖端应力强度因子KI值，其结果与理论值一致，从而验证了利用ABAQUS计算裂纹尖端相关断裂参量的可行性；(2)在研究内聚应力等相关理论的基础上，推导出了研究尺度与材料弹性模量的近似关系，并确定了介观尺度上的弹性模量；(3)在宏观尺度上建立了全局有限元计算模型和子模型，得到了裂纹尖端应力应变场分布，结果表明利用子模型技术获得比较准确的裂纹尖端应力应变场分布是可行的；(4)在介观尺度上利用平均晶粒尺度的方式建立了裂纹沿晶扩展模型，得到了裂纹尖端断裂过程区的微观应力应变场；(5)当应力强度因子为30MPa.m1/2时，分析了介观尺度上在裂纹沿晶扩展过程中裂纹长度对Mises应力、最大主应力和应变的影响，结果表明，裂纹扩展长度对试样整体应力应变分布影响不大，而对裂纹尖端区域有较大影响；(6)介。。。

Recent Chinese media reports, however, offer the following: length, 16.43 meters (53.9 ft.); wingspan, 8.78 or 9.75 meters; maximum takeoff weight, 19,227 kg.(42,300 lb.); maximum weapons load, 7,000 kg.; combat radius, 1,100 km.(683 mi.); maximum speed, Mach 2; maneuverability, 9g.

尽管如此，最近中国媒体报道了，提供了以下数据：长度16.43米（53.9英尺）、机翼幅8.78或9.75米、最大起飞重量19，227公斤（42，300磅）、最大武器载重量7000公斤、战斗半径1100公里（683英里）、最大速度2马赫、机动性能9G。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。