最大长度

Increasing the calcining temperature at 1500℃ 5h, the morphologies of the product became the big and wide vermiform-fiber form particles, the length was about 2.5 μm, and the width was about 700 nm. In addition, the vermiform-fiber form particle could be found in the filtrated precipitate with the additional ammonium sulfate. If the ratio of ammonium sulfate to alum is above 1, the vermiform-fiber form particle was formed. After calcined at 1500℃ 5h, the particle grow up to 2μm. Adding ammonium sulfate was also reduced the particles size of alumina because the surface area of the products was increased by increasing the quantity of ammonium sulfate.

在明矾与氨水沉淀物经过滤后再额外添加不同硫酸铵的比例，1200℃ 1hr煅烧后，发现添加硫酸铵比例在1以上，其型态亦为蠕虫状纤维，当以1500℃ 5hr煅烧，蠕虫状纤维型态粒子亦变为又大又胖，其粒子尺寸长度约为 2 μm 宽度约为 500 nm；且将煅烧1200℃ 1hr测其比表面积值，会随著硫酸铵的添加量增加，粉体的表面积会增加且粉体变细，添加硫酸铵比例为 4 者所得粉体粒径最小，从比表面积所得结果估计约 150 nm 。

Furthermore, stress, horizontal displacement and deflection of bridge structure are analyzed.

摘要］ 针对多跨连续刚构桥悬臂长度长、悬臂梁体重、施工荷载大等特点，结合重庆朝阳寺特大桥实际情况，通过理论分析和有限元数值模拟，对中跨、次中跨、边跨不同合拢顺序下，所需顶推力和顶推位移进行计算，并对桥梁结构的应力、水平位移及挠度进行了比选分析，提出并论证了采用计算预推值时先中跨再次边跨最后边跨的合拢方案，其突出优点是边跨合拢施工以挂篮和导梁代替搭设支架施工，措施简单易行、安全可靠。

Results The total length of femur medullary cavity were (33.51±0.63)cm and (33.13±0.64)cm; the length of the narrow point were (5.61±0.49)cm and (5.17±0.46)cm; the narrowest part were located on the proximal end of medullary cavity the distance of them were (3.55±0.15)cm and (3.52±0.27)cm; the sagital diameter were longer than the coronal diameter of the narrow point medullary cavity, the front one were(1.215±0.113)cm and the other one were (1.077±0.116)cm; the arc semidiameter of medullary cavity were(120.608±6.089)cm.

结果 股骨骨髓腔全长为(33.51±0.63)cm和(33.13±0.64)cm；狭窄段长度为(5.61±0.49)cm和(5.17±0.46)cm；髓腔最狭窄点位于髓腔中点近侧，距离为(3.55±0.15)cm和(3.52±0.27)cm，狭窄点髓腔矢状径较冠状径大，分别为(1.215±0.113)cm 和(1.077±0.116)cm，髓腔弧度半径为(120.608±6.089)cm。

Maxillary second molar has five subtype, Type A: absence of root fusion, Type B: presence of mesiobuccal and distobuccal root fusion, Type C: palatal root with anyone of buccal root fusion of molar with three roots, Type D:complete root fusion of molar with three roots, Type E:pseudofusion of molar.

分析其牙根发育沟之发生率、牙根发育沟之长度、牙根发育沟至牙骨质牙本质交界的距离，以及牙根发育沟最深点的深度、占牙根长的位置、与到牙根根管的距离，并且将牙根分类为上颚第一大臼齿，仅一种分类。

The coarsened long strip-like Cu6Sn5 with a length of more than 80μm growing from upper interface of IMC layer to solder matrix and its length of more than 80μm in the matrix are observed in the solder with 1.5wt-%Cu addition after thermal storage.

在含Cu量大於1.0 wt%时，会有金属间化合物Cu6Sn5在焊料内析出，大小随Cu量的增加而增大，当添加量达最高的1.5 wt% Cu时，焊料在长时间热储存后，从焊料/Cu界面的IMC层上表面向焊料成长的Cu6Sn5长度超过80μm，而焊料内最长的甚至超过100μm。

METHODS: Silicon chambers were sutured respectively to the distal stumps of motorial branch of femoral nerve and saphenous nerve to collect NRCF, namely MD-NRCF and SD-NRCF. The rats cortex motoneuron were divided into 4 groups and cocultured with MD-NRCF, SD-NRCF, b-FGF and serum-free medium respectively. The cultured cells were photoed under phase-contrast microscope, their longest neurites and cell-body areas were measured by cell image processing computer system.

建立运动及感觉神经再生室模型，收集术后7天的运动及感觉神经再生条件液(MD-NRCF，SD-NRCF)，将两者以及bFGF分别加入分散培养的SD大鼠运动神经元的DMEM无血清培养基中，在倒置相差显微镜下观察并摄片，运用细胞图像分析系统测量各组细胞的胞体面积及最长突起长度；并采用MTT法检测各组神经元的细胞活性。

To address this situation, I believe that the operation could be improved on are: the installation and adjustment of measuring, the first sub-scale do to adjust the nominal cylinder liner size, and then dial indicator card installed and well well inserted under the initial installation of the traffic card directly into the cylinder table by measuring the smallest cylinder liner wear, the cylinder table adjust the volume of the extended length of rod inserted, so that the volume of the dial indicator cylinder table has small hands around 1.5-2.0 preloading cell volume and cylinder volume table mother under lock locking plug, the final table and then measured the volume of cylinder rod and rod card inserted at the anvil micrometer measuring bar between the seat and the large dial and adjust the dial indicator to zero.

针对这种情况，笔者认为，操作上可改进为：安装和调整量具时，先将干分尺调整到气缸套的公称尺寸，再将卡装好百分表和初步安装好插杆的量缸表直接卡入所测气缸套磨损最小处，调整量缸表插杆的伸出长度，使量缸表的百分表小表针有1.5-2.0格左右的预压量并将量缸表的插杆锁母锁紧，最后再将量缸表的测杆和插杆卡在千分尺的砧座和测杆之间并将百分表的大表盘调整到零。

The Ms8.1 earthquake occured in the west to Kunlun mountain pass in 2001 created a fault of about 400km. The epicenter region which is the most west part of the fault is selected as studied area. Using the Multi-temporal European ERS-2 SAR imagery and shuttle-based SRTM DEM data, the surficial displacements are estimated with two-pass and three-pass DINSAR methods respectively.

2001年11月14日发生的昆仑山口西8.1级大地震造成了长度近400km的破裂带，以断裂带最西端的震中地区为实验区，选取多时相ERS-2 SAR影像和航天飞机SRTM DEM数据，采用两路和三路雷达差分干涉处理方法分别提取了地震形变信息。

Using different constraint lengths,trellis factor search PTS exhibits different PAPR reduction performances.A larger LC results in a better performance and LC=V-1 results in the optimum.

采用不同的约束长度，格形搜索在抑制峰均比方面呈现出不同的性能，LC 越大其性能越好，而LC=V-1对应最优的结果。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。