最大误差

The average error, maximum error and the error standard deviation regarding the test data decrease by 37%(45%), 34%(40%) and 35%(40%), respectively.

对测试数据的平均误差、最大误差和标准差较传统ANFIS分别下降了37%(45%)， 34%(40%)和35%(40%)。

Practical results show that the proposed method lowers both average error and maximum error and improves forecasting precision.

对预测结果的分析表明，多点外推法不仅减少了平均误差，也使最大误差降低，能有效提高预测精度。

The maximum error of this method was 15%. A preliminary investigation for effect of direction of the dosimeter pair showed that it was not ...

方法的最大误差为15％，初步进行了该剂量计对的方向性试验，在一定误差范围内可以认为方向性的影响不是严重的。

For distorted book image under random twisted status,by comparing its margin-gray-curve data with the stored margin-gray-curves data,a group of multinomial coefficients whose corresponding twisted status is proximal to that of the to be corrected image can be selected out to determine automatically a group of distortion parameters that is suitable for distortion correction.

任意弯曲状态下的书籍扫描图像可以在数据文件中搜索到与其最接近的弯曲状态，并利用对应的多项式系数自动求得最佳畸变参数，用于图像的畸变校正实验，获得了较好的校正效果，最大误差由未校正时的63%下降到了4.4%。这使得在无需人工测量或调整畸变参数的条件下可自动校正书籍扫描图像。

In optimum operating condition, the maximum variation of computational head compared with experimental one is 2.52%, and averaged absolute variation is 4.5%.

CFD计算的曲线与试验曲线的趋势基本一致，最优工况点计算扬程相对试验扬程的最大误差为2.52%，误差绝对值的平均值为4.5%。

The question of searching characteristic points or straight lines on moving rigid body is decomposed into two relatively independent sub-questions. The first one is to evaluate the characteristic of points and straight lines on moving rigid body, whose mathematics model is a kind of special non-differential max-mini optimal problem with inequality constraints. By the method of Saddle-point Programming and maximum entropy, the problem can be transformed as a differential optimal problem with single objective. The second oner is to search approximative character points or straight lines on moving rigid body within design space, whose mathematic model is nonlinear and non-differential problem with multiple constraints.

本文将在运动刚体上寻找特征点或直线的优化问题分解为两个相对独立的子问题，一是对运动刚体上点或直线的特征性评定，其实质是平面曲线的圆度或直线度的评定问题，优化模型是以最大误差为最小作为优化目标的约束不可微的优化问题，本文采用鞍点规划和极大熵方法，将其转化为单目标可微优化模型；二是在设计空间内，寻找运动刚体上特征性评定指标最小的近似特征点或直线，其优化模型是非线性、多约束的不可微优化问题，本文提出用遗传算法和BFGS局部搜索法相结合来求解。

Besides, useful information including the linear range, the maximum trapping force, and the error associated with the linear approximation of trapping force when the particle was in the nonlinear regime was deduced from the experimental data for each polystyrene bead size. In the 2nd part, we report the application of oscillatory optical tweezers to trap and oscillate three different types of E.

此外，我们也从一些曲线的讯息得到有用的资讯，如每种聚苯乙烯小球量测的线性范围、最大光钳力以及允许10%最大误差时的线性趋近光钳力等等。

The horizontal and vertical first derivatives of magnetic anomalies of an infinite cylinder are calculated by the cosine transform method, in which the maximum errors are -028 nT/m and 047nT/m, respectively and the percent errors are generally within -357%～327% and -194%～188%, respectively except several data of the boundary and part are bigger because of remains of Gibbus effect. The calculating curve and theoretical curve are approximately coincident, and there is no influence by effective magnetic dip angle in computing.

利用余弦变换法计算的无限长水平圆柱体磁异常水平和垂向一阶导数的最大误差分别为-028 nT/m、047 nT/m；水平一阶导数的误差一般在-357%～327%之间，垂向一阶导数的误差一般在-194%～188%之间；计算的磁异常一阶导数值与理论值大致重合，而且不受有效磁化倾角的影响。

Based on the analysis of working process of ejection gun of rocket ejection seat ,the physical and mathematical models of interior ballistics of ejection gun were established and the interior ballistics parameters of a rocket eject seat were validated by test and calculation.

在分析火箭弹射座椅弹射动力系统的工作过程的基础上，建立了其内弹道的物理模型和数学模型，并对某型火箭弹射座椅弹射动力系统内弹道进行了试验验证与计算，试验所测膛内气体压力随时间变化曲线与计算曲线基本吻合，弹射过程最大压力pm、工作时间tg、出口压力pg和出口速度vg分别为24.20(24.57)MPa，157(155)×10-3s，22.27(21.83)MPa，16.61(16.59)m.s-1，各特征参数的计算值最大误差小于3%。

But the errors with the Fourier transform method are -1062nT/m and 1442nT/m, there is large departure between the calculating curve and theoretical curve and evident influence by effective magnetic dip angle in computing.

而Fourier变换法计算的水平和垂向一阶导数最大误差分别为-1062 nT/m、1442 nT/m，计算曲线与理论曲线偏离大，受磁化倾角的影响也较大。

They weren't aggressive, but I yelled and threw a rock in their direction to get them off the trail and away from me, just in case.

他们没有侵略性，但我大喊，并在他们的方向扔石头让他们过的线索，远离我，以防万一。

In slot 2 in your bag put wrapping paper, quantity does not matter in this case.

在你的书包里槽2把包装纸、数量无关紧要。