最大变化

Fine varieties were reselected including three kinds of varieties from Lin′an, Anji and Chun′an areas, which have high and stable yield, early maturation and large fruit.

结果表明： 1所试山核桃优系有进一步选育品种的潜力，鲜果质量的变异系数最大，粗脂肪的变异系数最小； 2经济性状在地区间的变化没有一致性，但地域分布对山核桃出籽率，粗蛋白含量有显著影响。

The results showed that the species number of periphyton was the greatest in summer and the density of dominant species was the highest in summer and autumn, and the water quality was generally consistent with the tendency of the changes both in the indices of diversity and evenness. There were significant negative correlations between the contents of N and P in water, and the indices of diversity, evenness, algae density, total biomass, while CODcr and BOD5 did not show any significant relationship with these four biological indices.

研究结果显示，着生生物种类数以夏季最多，优势种密度以夏、秋季最大，多样性指数、均匀度指数的变化趋势与水质指标的监测结果基本一致；经相关性分析表明：水体中氮、磷含量分别与生物多样性指数、均匀度指数、藻类密度和总生物量四项指标呈显著负相关， CODcr、BOD5与四项生物指标均无相关性。

The bulk transfer coefficients change during a day, reach the maximum at noon and the minimum at night.

总体输送系数具有明显的日变化特征，中午时段最大，夜晚最小；总体输送系数与大气稳定度存在明显关联，文中给出它们之间的拟合关系式；随着高度的增加总体输送系数减少，但减少幅度逐渐变小。

The focusing beam radius' ratio between the telescope lens compound system and the single lens increases via length (70~400mm) increasing, and the maximum ratio is 30, meanwhile the ratio between the telescope-lens compound system and the single lens decreases via length (70-400 mm) shorting, but the maximum difference of the focusing beam radius' is 0.043μm.

结果表明，随着距离(70~400mm)的增加，两者的聚焦效果相差增大，最大为30倍；随着距离(70~400mm)的减小，两者的聚焦效果相差减小；经望远镜和薄聚焦透镜组合系统聚焦的高斯光束束腰处光斑半径随距离(70~400mm)变化的最大值为0.043μm。

The results indicate the mutual effect exists between the single coals, which could increase the maximum of thermal weight loss obviously and has a small effect on the temperature extent of the weight loss. The main pyrolysis production of coal is coke, but the main production of waste plastics is tar; the yield of water became decrease and the gas became increase by adding the waste plastics. And the CRI and CSR decreased with the ratio of waste plastics in coal. The main ingredients of tar from blend coal are aromatic hydrocarbon and alkane, while those of waste plastics are alkane and alkene. The result of co-coking with coal and waste plastics make the light tar and the aromatic hydrocarbon increase obviously. The combustible ingredient(CO、H2、CH4) of gas from co-coking with coal increase at different ratio; Co-coking with coal and waste plastics could increase the combustible ingredient and thermal value of gas.

结果表明，废塑料与煤混合物在煤的塑性温度区间内存在明显的相互作用，使最大热解失重峰迁移，热解速率变大，且随着废塑料配比的增加呈现规律性的变化；煤热解产物固体焦炭为主，而废塑料的热解产物以焦油为主，废塑料的添加使得总体焦炭和水产率下降，焦炉煤气和焦油的产率增加，即共焦化呈现出明显的&增油减水&效应；随着塑料添加量的增加，焦炭热强度呈现劣化趋势；废塑料代替瘦煤配煤炼焦可使其比例提高到3%而不影响焦炭的质量；纯煤焦化所得焦油以芳香烃类和烷烃类为主，而废塑料热解焦油以烷烃和烯烃为主；废塑料配煤炼焦，可使得的焦油呈现&环构化&和&轻质化&趋势；废塑料的添加可使煤气中的可燃组分(CO、H2、CH4)的含量均有不同程度的增加；废塑料配煤炼焦可以优化焦炉煤气的组成，增加煤气中的可燃组分，提高焦炉煤气的热值。

The complexity of bodywork decides variety of it's error. The station and primary factor which cause error is inconstant change and using correlation analysis can find out the primary factor. With an project given, the theory of correlation analysis for dimension variation of bodywork is discussed through correlation analysis and the layer structure of the bodywork,the state in which the error happened can be found out. How to use eigenva...

车体装焊的复杂性决定了误差产生的多因素性，车体制造过程中产生误差的工位和主要因素是不断变化的，采用相关性分析方法从众多的误差根源中准确地发现最主要的误差源；结合工程实践，论述了车体尺寸波动的相关性分析方法的原理，根据测量点的相关性分析和车体焊接工艺的层次结构，可准确地找到产生车体尺寸误差的工位；讨论了如何利用相关系数矩阵的特征值和相应的特征向量判断尺寸波动的模式，指出测量数据的波动主要按最大特征值所对应的特征向量方式波动，引起这种波动的原因是车体误差产生的主要原因，应重点采取措施加以控制；提出了应用计算机进行相关性分析的解决方案。

The experiment shows that:(1) In certain light intensity and electric field ranges (145～305V/cm) the material Si∶ with a resistivity of 1E4Ω·cm exhibits a current oscillation phenomenon at liquid nitrogen temperature;(2) At a certain electric field,the waveform of the current oscillation is stable and does not change with time;(3) The dependence relation between the oscillation frequency and light-intensity can be expressed by f=f0(L/L0)α where L0 is the minimum light-intensity needed to stimulate oscillation,f0 is the frequency under L0,L is the intensity of the light,and α is a coefficient that increase with electric field;(4) The modulating coefficient K K=(Imax-Imin/Imax decreases as the light increases;(5) The maximum value of the oscillation Imax decreases with the increase of the light-intensity while the minimum value of oscillation Imin increases slowly.

结果表明：在一定光照和电场范围内（276～305V/cm ，电阻率为10.4Ω·cm的材料在液氮温度下显示出电流振荡特性；在一定的电场下，电流振荡波形是固定的，不随时间变化；振荡频率随光照强度的增大而线性增大；调制系数随着光强的增强而减弱；振荡的最大值随着光照强度增大而减小，最小值随着光强增大而缓慢增大。

By using dynamics analysis software RecurDyn to establish a model for the prototype of a belt conveyor, this essay reaches through simulation research the conclusion that during the initial startup phase, it is necessary to maintain a lag between the speed of the tail pulley and that of the head pulley, mainly because it takes a certain amount of time for the elastic wave to travel through the belt to reach the tail of the conveyor.

应用动力学分析软件RecurDyn建立了带式输送机的样机模型，通过仿真研究，得出在起动初始阶段，尾部滚筒速度要滞后于头部滚筒速度一定时间，这主要是由于弹性波在输送带中进行传播到达尾部需要一定的时间；并且在起动阶段，输送带的张力比稳定运行时变化大，起动时间越长，输送带出现的最大张力越小。

B galvanising greater attention and efforts towards adaptation at all levels to minimise the adverse impacts of climate change, to assist in building climate resilient communities and to enhance sustainable development.

鼓励各级更加重视适应并为此作出更大努力，尽最大限度减少气候变化的不利影响，协助建设具有气候抗御能力的社区，促进可持续发展。

In many fields, the evapotranspiration have been applied.

蒸散是地表水循环中最大、最难估算的分量，同时也是陆面循环过程中地气相互作用的重要过程之一，在全球气候变化的认识和研究中，其重要性日益得到重视，并且在许多领域中得到了不同的应用。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。