最大值的

The higher the concentration of Cefotaxime was, the lower the rate of differentiation was; when the concentration of Cefotaxime was high 400~500mgL^(-1, the growth of callus was inhibited. However, the effect of Carbenicillin on callus was little and the differentiation of adventive buds was promoted under appropriate concentration. When the Carbenicillin's concentration was 200mgL^(-1), the differentiation rate reached the maximum 68.8%.

头孢霉素浓度愈大，213品种不定芽分化频率愈低，当头孢霉素浓度较高400~500mgL^(-1时，愈伤组织生长受到抑制；而羧苄青霉素对愈伤组织影响很小，在适宜的浓度下能促进不定芽分化，213品种在羧苄青霉素浓度为200mgL^(-1)时，分化频率达到最大值68.8%。

Each cell was mapped by the center point on the cell of transverse section with extended up and down for four pixel(nine-pixel lengths in total) and two pixels in width,and thereafter line convoluted dot map was obtained.

把每个纤维细胞都用其中心的一个长9个像素点、宽2个像素点的线段点图表示，进行傅立叶变换，其能量光谱图在水平和垂直方向上的频率分布，除零值以外的最大值，即为细胞径向、弦向直径。

Each cell was mapped by the center point on the cell of transverse section with extended up and down for four pixel (nine-pixel lengths in total) and two pixels in width, and thereafter line convoluted dot map was obtained. Through Fourier transformation, the frequency distribution of power spectrum pattern from both horizontal and vertical direction was obtained, and the cell diameter in radius and tangential direction was known from the maximum value except 0 in the distribution.

把每个纤维细胞都用其中心的一个长9个像素点、宽2个像素点的线段点图表示，进行傅立叶变换，其能量光谱图在水平和垂直方向上的频率分布，除零值以外的最大值，即为细胞径向、弦向直径。

Methods An unsupervised local and global features extraction method was adopted for the localization of facial features of frontal view face image. First, a threshold was used to segment the image into foreground and background, and the nose was localized by considering the symmetry of the face. Second, Harris operator was adopted to detect interest points in a rectangular area covering all the facial features, and then local maximum of the interest points were detected. And finally, Kmeans clustering method was used to cluster the points and obtain the facial features localization.

针对红外正面脸部图像，采用一种无监督的局部和全局的特征提取方法，首先通过阈值法区分出前景和背景，并根据面部特征对称性在前景中确定鼻区；然后在面部确定一个包含所有特征的矩形区域，利用Harris算子在该区域检测出角点，并找出这些点的局部最大值点；最后用Kmeans方法对这些点进行聚类。

Firstly,effectively edge information was picked-up by comparing and choosing maxima from colour weight gradient images.Then,a method based on multi-threshold segmentation was proposed,which can eliminate inefficacious gradient information.Finally,procedures and results of the algorithm were introduced.

首先比较并选取彩色分量图像梯度信息的最大值，达到提取图像有效边缘信息的目的；然后提出基于多阈值分割的方法消除无效梯度信息；最后介绍了算法的步骤及结果。

Through comparing the calculated values with experimented results, the research result indicates that the actual situation of the lattice beam can be well reflected by using two stages Moreover, the simplified foundation pressure is of benefit to the hand labor calculation.

通过对比分析理论计算最大值、采用简化的地基反力计算值和实测值，结果表明采用两阶段设计能较好地反应格构梁的实际受力情况，且设计安全，而简化的地基反力为手工计算带来了方便。

The optimal policy is also investigated by using Pontryagin's maximal principle.

最后运用Pontryagin最大值原理，给出系统的最优捕获策略。

The advantage of this measure is that the optimum rational reparameterization's parametric speed satisfies that the maximum deviation from unity is the minimum in this family.

利用该方法求得的最优参数化在曲线的重新参数化曲线族中，参数速度偏离单位速度的最大值达到最小。

When the system starts, the speed outer ring saturats non-functional, the current inner ring plays a major role to regulate the starting current to maintain the maximum so that the speed linear change, to reach a given value; when it operates steadily, the speed negative feedback from the outer ring plays a major role ,to let the speed changes with the given speed voltage , at the same time the current inner ring regulates the armature current of motor adjustment to balance the load current.

该系统起动时，转速外环饱和不起作用，电流内环起主要作用，调节起动电流保持最大值，使转速线性变化，迅速达到给定值；稳态运行时，转速负反馈外环起主要作用，使转速随转速给定电压的变化而变化，电流内环跟随转速外环调节电机的电枢电流以平衡负载电流。

Therefore, the accelerations and decelerations along with maximums and minimums are presented for consecutive strokes, and the full transient response is cut off to allow the key information to be presented as single plot.

所以，与最大值和极小值一起的加速度和减速为连贯冲程被提出，并且充分的瞬变响应被切除允许关键信息被提出作为唯一剧情。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。