最大

Printing equipment: water-based printers: Taiwan Yu Li four-color printing slotting machine (most large format: 3600X2450 mm), three-color printing Korea SAI slotting machine (most large format: 2800X1900 mm), Shanghai long four-color printing mode cutting machine (most large format: 2400X1200 mm), two-color printing proofer Jinchang Shanghai (most large format: 2800X1600 mm).

水性印刷机：台湾裕力四色印刷开槽机（最大幅面：3600X2450 mm）、韩国世昌三色印刷开槽机（最大幅面：2800X1900 mm）、上海鼎龙四色印刷模切机（最大幅面： 2400X1200 mm）、上海金昌双色印刷打样机（最大幅面：2800X1600 mm）。

A model of continuous beam with spring supports is put forward to analyse time-dependent structural systems.

针对施工期现浇钢筋混凝土结构的时变性，定义楼板刚度与模板支撑的刚度比为施工时变结构体系的弹性特征值，建立了以施工时变结构体系弹性特征值为参数的现浇钢筋混凝土结构施工受力性能分析的弹性支撑连续梁模型，基于该模型，分析了施工期现浇钢筋混凝土结构的受力特性，发现在特定施工方案下，当施工时变结构体系的弹性特征值较小时，最大施工荷载出现的楼层位置会提前，而拆模时间也会改变最大施工荷载出现楼层的位置；施工时变结构体系的弹性特征值和拆模时间都影响楼层承担的最大施工荷载比率(荷载比率定义为结构承担荷载与楼板自重的比值)；施工期楼层承担的最大施工荷载随楼层位置呈现波动特性，随楼层位置增高波幅逐渐减小，最后趋于稳定。

Bamboo variation ofmicrodensity of all age-degree and all height bamboo from bamboo green tobamboo yellow as follows:The downtrend ladder of microdensity the firststage from bamboo green to bamboo yellow is relatively large,normally at theplace 0.35 from bamboo hull(the thickness of from bamboo hull to bambooyellow is 1)micro-density downtrend ladder begin to get smaller,variancerange of microdensity is smaller.When reaching near bamboo yellow area,microdensity reaches its minimum value,and when reaching bamboo yellowsection density increase rapidly,the minimum density of bamboo is only 50% orless of maximum density.Bamboo yellow is comprised of stone cells whichhave thick cell wall,so its density is high,normally 50% to 100% more thanminimum density.Bamboo yellow′s lay thickness is thin,normally the samethickness for all age-degree and all height bamboo,about 0.8mm.From 1 age-degree bamboo to 2 age-degree bamboo during growth,the increase of averagedensity is mainly in bamboo pulp section,from 3 age-degree bamboo to 4 age-degree bamboo,the decrease of average density is mainly decrease in the pulpsection.Same age,same height,the less the density ladder of bamboo radialthickness,the higher the mechanical strength.

所有年龄所有高度的竹材微密度从竹青到竹黄对材性变异规律如下：从竹青到竹黄开始下降梯度较大，一般到相对竹皮距离0.35左右处(整个竹壁厚度为1)，竹材微密度下降梯度减小，微密度的变化范围变小，到近竹黄处，微密度达最小值，而后到竹黄部位密度大幅上升，竹材最小密度一般只有最大密度的50％或更低，竹黄由厚壁的石细胞组成，所以密度较大，一般比最小密度增大约50％-100％，厚度较薄，不同年龄不同高度竹材的竹黄厚度相差无几，约在0.8mm左右；竹材从1度竹到2度竹生长过程中，平均密度的增长主要发生在竹肉部分，从3度竹到4度竹生长过程中，平均密度的下降主要发生在竹肉部分，同一年龄同一高度，竹壁厚径向的密度梯度越小，力学强度越高，随着年龄的增大，密度梯度越来越小(1度竹除外)，随着高度增加，密度梯度越来越大。

Study shows that,pH smallest coefficient of variation was 12.95%,coefficient of variation of soil available phosphorus was the largest,varia...

研究表明，pH的变异系数最小为12.95%，土壤有效磷的变异系数最大，变异值达到了122.18%；经克里金插值分析，研究区土壤养分的空间相关性减弱，朝均一化发展，这说明了红花套镇土地养分变化受人为因素影响较大，当地的土壤适合并已形成大面积的发展种养殖业，传统的稻、麦、棉种植数量和产量都与红花套镇的人平纯收负相关，对当地人平纯收贡献最大的是柑桔总产，相关系数分别为0.822，0.966，土地利用效率最大的是水产品养殖，相关系数分别为-0.760，0.870。

The results revealed that screwdrivers with triangle shaped handle could help subjects produce the maximum torque. Besides, using screwdrivers with hexagon shaped handle spent the least time, generated the minimum biceps muscle activity, and bad the least subjective fatigue rating. Moreover, wearing an anti-static glove or being barehanded can produced the maximum torque and spent the least time as well. Experiment 2 evaluates the handle diameter of screwdriver (30 mm, 34 mm or 38 mm) and operation plan. The results showed that the torque increased with the increase of the radius, the operation time and the brachioradialis muscle activity also increased with the increase of the radius.

本 研究共分为三次实验，实验一分析握把造型(八角形、锐角六角形、圆角六角形、枪型、圆角三角形)与手套(棉质手套、防静电手套、赤手)的影响，结果显示三角形造型握把可产生最大扭力，六角形造型握把的锁附螺丝时间最短、二头肌肌肉活动度最低、主观整体疲劳评比最低，防静电手套与赤手状态的扭力最大并且锁附螺丝时间最短；实验二比较握把直径(30 mm、34 mm、38 mm)与作业面的影响，结果显示直径越大扭力越大，但直径越小锁附螺丝时间则越短，且肱桡肌肌肉活动度越低。

The results indicate that the largest deformation appear on the middle region of the addendum, the position of largest stress appears at the dedendum region of loaded tooth. As the curvature radius of transition curve rising, both the largest deformation and the largest dedendum stress reduce.

结果表明，内齿圈的最大变形出现在齿顶的中间部位，而最大应力出现在受载齿的齿根部位；内齿圈的最大变形和齿根最大应力随着齿根过渡圆角半径的增大而减小。

Under condition of different temperature and sulphur consumption, the brown coal and gypsum can promote oxidation of sulphur,the oxidational rate of sulphul is the highest under the condition of applying brown coal and gypsum;The sulphur is oxidized for SO42~ the oxidational rate of sulphur during 0-15 days' incubtation was the highest on the whole,reach the maximum basically within 30 days,up to the extension of time,SO42"""" the content is reduced to some extent;Final SO42 -content, Ig sulphur / kg treatment of soil greater than 0.5g sulphu/kg treatment of soil,become multiple increase,the sulphur is higher than the room temperature in the efficiency of oxidizing of 30 degrees Centigrade (10-20 degrees Centigrade).

在不同温度和硫磺用量的条件下，褐煤与石膏对硫磺的氧化有促进作用，其中褐煤与石膏配合施用对硫磺氧化的促进作用最大；在硫磺氧化为SO_4~(2-)的过程中，0-15天内氧化速率最大，30天内基本达到最大值，随时间的延长，SO_4~(2-)含量有所降低；硫磺在30℃的氧化效率高于室温(10-20℃)，在1克硫磺的处理中，30℃时最大SO_4~(2-)的含量是室温(10-20℃)的1.24倍，在0.5克的处理中有同样的规律，30℃时SO_4~(2-)的含量是室温的1.6倍。

Comparison of Insecticidal Activities between Cyfluthrin and Its Preparation of Sample ( beta-cyfluthrin ) by Epimerization for the Army Worm;2. Toxicity and Field Effect of Different Ratios of Rotenone to Beta-cyfluthrin against Uroleucon gobonis;3. The relationship of the content of mixed surfactant , the content of co-surfactant and the maxium addition content of beta-cyfluthrin in the formation of beta-cyfluthrin microemulsion were studied, and a math theory model was established by using multivatiable linear regression analysis.

通过研究高效氟氯氰菊酯微乳剂形成过程中表面活性剂混剂、助表面活性剂与高效氟氯氰菊酯最大加入量的关系，利用多元回归处理方法，建立了表面活性剂混剂、助表面活性剂与高效氟氯氰菊酯最大加入量三者之间的数学模型；通过测定不同温度下高效氟氯氰菊酯的最大加入量，得出高效氟氯氰菊酯最大加入量随温度升高而增大的规律。

The maximal excitation wave of atriums and ventricles are 482.58±0.64 nm and 570.10±0.45nm respectively.

确定了激发心房组织的最大激发峰为482.58±0.64 nm，而最大荧光峰为570.10±0.45nm；而心室组织的最大激发峰为485.45±0.12 nm，而最大荧光峰为574.05±0.33 nm。

are gained that after widening, the settlement of two sides of the old road pavement is contrary, cross slope of old road is different, horizontal displacement of the old road pavement is minishes, the area of maxium settlement, maxium lateral displace and disease of old road is different as before widening.

分析结果指出：在拓宽段作用下，靠近老路中心一侧老路路面沉降逐渐减小，远离老路中心一侧沉降逐渐增大，相应横坡也在发生变化；老路路面的水平位移有较大幅度的减小；而且老路最大沉降、最大水平位移、最大剪应力及最易发生病害的位置与拓宽前也发生了较大的变化。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。