最大

Correctional checking formula of melt flow ratio in injection molding was obtained by introducing a correction coefficient β which reflected the complexity degree of mold cavity. The results show that, the maximum flow ratio of 486 can be obtained when injection pressure ranges from 150 MPa to 160 MPa in Archimedes spiral mold for PP, while maximum flow ratio of 419 can be obtained when injection pressure ranges from 160 MPa to 170 MPa for PE. There is a local fluctuation phenomenon for flow ratio and corresponding injection rate in square spiral mold when injection pressure of 100, 120 and 150 MPa for PP and 130, 140 MPa for PE are reached respectively,and this phenomenon is more serious for good fluidity of melt. The average flow ratio in Archimedes spiral mold is 6% larger than that in square spiral mold for PP, and 4% for PE, the average flow ratio of PP is 19% bigger than PE in Archimedes spiral mold, and 15% in square spiral mold. The influence of the cavity profiles on the melt flow ratio is more significant for good fluidity of melt.

研究结果表明：在阿基米德螺旋线模具中，PP在注射压力为150~160 MPa时取得最大流动比485，PE在注射压力为160~170 MPa时取得最大流动比419；在方形螺旋线模具中，PP在注射压力为100，120和150 MPa，PE在注射压力为130和140 MPa时流动比及所对应的注射速率出现波动，且流动性好的熔体波动更为严重；PP在阿基米德螺旋线模具中的流动比均值较其在方形螺旋线模具中大6%，而PE大4%；在阿基米德螺旋线模具中流动比均值PP比PE的流动比均值大19%，而在方形螺旋线模具中PP的流动比均值比PE的大15%；流动性好的熔体受模具型腔轮廓特征影响大。

The lag correlation indicates that the eastern Pacific SST in winter correlates with the WPSH anomaly two or three months later to the highest degree; the SST in the tropical Indian Ocean and the WPSH anomaly in the corresponding period significantly correlates with each other in winter; and the SST in the western Pacific in winter and spring negatively correlates to the WPSH anomaly in the corresponding period.

选取各关键海区分析海温与西太副高在不同时段上的超前滞后相关，结果表明，冬季东太平洋海温与滞后其2—3个月的副高异常达最大正相关，热带印度洋海温异常与冬季同期副高异常的正相关最显著；西太平洋海温在冬春季与同期的副高负相关最显著；北太平洋海温在冬春季滞后副高1—2个月时存在负相关，大西洋暖池区6月与西太副高的同期正相关最大；对南太平洋来说，冬季的西太副高与从前秋到春季的SST都存在最大负相关。

The measurement results show that the general characteristics of the present crustal stress field of the project area are as follows: the horizontal principal stress is the maximum principal stress, and the preferred orientation of the maximum horizontal principal stress is NW-WNW, the maximum principal stress of surrounding rocks of the plant buildings and high-pressure branch tunnel area is generally 14.5±0.5 MPa and the minimum principal stress is 9±0.5 MPa; the dead oad-bearing capacity of surrounding rocks is 10—14 MPa; and the surrounding rocks are essentially impermeable at high pressures of 8—10 MPa.

测量结果表明，工程区现今地壳应力场的总体特征为：水平主应力为最大主应力，最大水平主应力的优势方向为NW-NWW向；厂房和高压岔管区围岩的最大主应力值一般为14.5±0.5MPa，最小主应力值一般为9±0.5MPa；围岩自身的抗载强度一般为10～14MPa；在8～10MPa高压力作用下围岩基本不透水。

This vehicle adopts Yiqi Jiefang CA5275JQZ special purpose chassis which has full-view driver's cab, high pressure electric spray engine ,Euro Ⅲ emission standards, fits the requirement of the national environment protect announcement the maximum lifting capacity is 20t, the minimum working range is 3.1m, the maximum height of main boom is 31.8m, the maximum lifting height of main and jib boom comes up to 39.2m, the length of all-extended boom is 31.4m,the turning radius is 3.62m and it can 3600rotate continuously .

最大起吊重量为20吨，最小作业幅度3.1米，主臂最大起升高度31.8 米，主臂加副臂最大起升高度达到39.2米，全伸臂长31.4米，回转半径3.62米，360度连续回转。2、采用一汽解放CA5275JQZ全景驾驶室汽车起重机专用底盘，高压共轨电喷发动机，欧Ⅲ排放标准，符合国家环保公告要求。

Maximum likelihood detector is the optimal detector and has the best performance. The challenge of MLD is the high computational complexity. K-Best decoding algorithm has been proposed to reduce the computational complexity. K-Best decoder algorithm computes Partial Euclidean Distance and only keeps the best K nodes that have the smallest accumulated PEDs. After completing breadth-first tree search, we will have K leaves with the smallest PEDs.

最大相似度侦测法是公认最佳化的演算法，有著最好的侦测效能，但运算复杂度将会随著调变群集和传送天线数目大小而呈指数型增加。K-Best球型解码演算法因而被提出来，得到近似最大相似度侦测法的结果，解决最大相似度侦测法运算复杂度过高的问题。K-Best球型解码演算法在计算完部份欧几里德距离后，需要取最小K个值做为候选点，再往下层去找候选点。

Royce also offers this tip: The largest car dealership in your area will most likely have the biggest inventory and therefore, they have the biggest incentive to move their cars out at a discount.

Royce还提供了这条建议：在当地最大经销商最可能有最大的库存，所以，他们在对卖车的打折会给出最大的鼓励政策。

To the gradations with the same maximum nominal grain size,grey correlation was used to analyze the results. The conclusion showed that,except the 9.5 mm-maimum-nominal-grain-size gradation,Jf was influenced mostly by the subtotal triage of coarse aggregates in the third large sieve pore.

对于颗粒最大标称粒径相同的级配，使用灰色关联分析，得出结论：除颗粒最大标称粒径为9.5 mm级配外，Jf受级配中第3大筛孔分计筛余百分率影响最大。

People's life, the biggest success, the success of marriage is, The greatest happiness is the happiness of the family, The greatest love is the husband and wife, The most important way of communication, and communication, The most important is the understanding, and understanding, The most valuable way of tolerance and dissensions. The most effective self-surrender is and tolerance, The most neglected is concerned, and care.

人的一生，最大的成功，莫过于婚姻的成功；最大的幸福，莫过于家庭的幸福；最伟大的亲情，莫过于夫妻之情；最重要的沟通，莫过于夫妻间的沟通；最为重要的理解，是夫妻间的理解；最有价值的宽容，莫过于夫妻间的宽容；最有成效的忍让，是夫妻间的忍让；最不容忽视的关心，是夫妻间的关心。

The results indicated Paecilomyces farinosus was aerobic fungus and rotate speed of rocking bed exceeded 150r/min would benefit the mycelium growth.Initial inoculum could affect the time of reaching maximal mycelial bioass and could not affect the maximal mycelial bioass.inoculum exceeding 5% would benefit t...

结果表明粉拟青霉是一种好气性真菌，摇床转速大于150r/min有利于该菌生长；接种量对菌丝最大产量影响不大，但是能够影响菌丝量达到最大值的时间；接种量大于5%，有利于菌丝产量迅速达到最大值；粉拟青霉菌在pH值为3～10的培养基中都能够生长，生长过程中能够分泌代谢产物主动调节pH值，该菌在pH为5～7的微酸环境中生长最快；液体发酵过程中粉拟青霉生长量与发酵时间的关系符合逻辑斯蒂生长模型。

All the methods make the model more comply with the actual situation and avoid the onesidedness of single load operation condition.

根据分解协调原理，把这一复杂问题分解为最大负荷方式，一般负荷方式和最小负荷方式三个子模型，其投资费用在最大负荷方式下考虑，对于三个子模型用最大负荷损耗时间来协调统一，使得模型更符合实际情况，避免了只考虑单一负荷方式的片面性，具体求解方法采用非线性规划中的梯度法。

Finally, according to market conditions and market products this article paper analyzes the trends in the development of camera technology, and designs a color night vision camera.

最后根据市场情况和市面上产品的情况分析了摄像机技术的发展趋势，并设计了一款彩色夜视摄像机。

Only person height weeds and the fierce looks stone idles were there.

只有半人深的荒草和龇牙咧嘴的神像。