最后分析

Mountain climbing, keep healthy, kill free time, find beautiful scene, inhale fresh air, be away from job pressure, enjoy my life

结构： 仍用总-分-总的形式，可以先点题指出你的爱好是爬山，然后分析你为什么喜欢爬山的原因，最后以再次点题，爬山对自己有好处。

Our data revealed glucose and beef extract to be the most influential parameters, and the composition of the optimal fermentation medium (100 mL) was determined to consist of 4.46 g glucose, 2 g soluble starch, 4 g silkworm powder, 2.93 g beef extract, 0.10 g KH2PO4 and 0.15 g MgSO4·7H2O.

最后通过中心组合设计和响应面分析法，确定了主要影响因子的浓度。优化后的培养基组成为：葡萄糖4.46 g/100 mL，可溶性淀粉2 g/100 mL，蚕蛹粉4 g/100 mL，牛肉膏2.93 g/100 mL，KH2PO4 0.1 g/100 mL和MgSO4·7H2O 0.15 g/100 mL。

Finally, the thesis gives a practical compensation system according to the fact of the enterprise and the before-mentioned analysis. At the same time, the author also gives some suggestions about the problems that may be met in the practice of the system.

最后，本文依据众城石化的实际情况，结合前述的分析依据，给出一套较为结合企业实际的薪酬方案，并对该方案以后实施过程中可能遇到的问题提出相关建议。

Finally, the effects of the geometric and physical parameters on the distributions of deflection and the bending moment in plates are investigated.

最后，分析了结构几何参数和物理参数挠度和动弯矩分布的影响。

K-ATPase is the last passageway of gastric acid secretion.On the basis of synthesis of the H+K-ATPase inhibitor pantoprazole,twelve benzimidazole derivatives were synthesized for the first time,and their structures were proved by IR,1H-NMR and elementary analysis.

摘 要 H+/K+-ATP酶是胃酸分泌的最后环节，在合成H+/K+-ATP酶抑制剂泮托拉唑的基础上，设计合成了12个未见文献报道的苯并咪唑类衍生物，经红外光谱、核磁共振氢谱和元素分析确定了结构。

Last,the compare of reconstruction results respectively adopting new matrix,Gaussian measurement matrix and Bernoulli measurement matrix is conducted.

最后给出了新的测量矩阵与一般采用的高斯和贝努里测量矩阵的重建结果比较和分析。

In chapter 5, the design of oscillator is discussed. First introduced the condition of how to make circuit oscillate and keep stabilization. And compared the advantage and shortcoming of design oscillator with S parameter or Bessel Function method.

第五章主要是讨论了射频前端关键模块本振源振荡器的设计，分析了反馈振荡器的起振、平衡条件，比较了用晶体管S参数和时域贝塞尔函数法设计振荡器的优缺点，最后以科尔皮兹型振荡器为例用ADS软件进行设计仿真，给出了设计结果。

The tangent stiffness matrix is obtained from the engineering strain and the principle for determining the limit point and bifurcation point is given.

由工程应变推导出几何非线性的切线刚度矩阵，并给出判断分歧点与极限点的准则，最后用一数值例题说明该方法的分析过程。

In this kind of incomplete information system, a new kind of binary relation based on relative degree is proposed according to the set pair analysis, this binary relation is only reflective.

在此基础上，分析了这种二元关系在两种特殊情形的不完备信息系统中的表现形式，然后根据新建立的基于联系度的粗集模型，使用决策矩阵讨论了规则生成方法，最后用一个实例说明了此方法的有效性。

Finally, a calculation example of Bingham oil was shown the numerical difference of the two methods.

本文以Bingham流体为例，对非牛顿流体的差分方法进行了研究，从理论上分析了势梯度分量差分方法的错误，并提出了正确的势梯度模差分方法，最后给出了显示二种方法差别的数值计算实例。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。