最后分析

Furthermore, it also compares engaging force between complete knife chain and sprocket, and colliding process of the complete knife chain contact with the pin. Analyzing and comparing the condition of chain engaged with the driving and driven sprocket can help to understand the contact force and tension in entire progress of transmission.

讨论完整刀链与链轮之啮合受力比较，及完整刀链与连接销碰撞之过程情形，并分析比较链片与驱动链轮及传动链轮啮合之情形，以了解其整个过程的啮合碰撞受力关系及所受之张力情形，最后进行结构强度分析。

Finally, the design is completed, the analysis of force and the bending torque, axis of the drum check, on the chain drive chain plate ansys conducted by the finite element analysis.

最后，在设计完成后，通过受力分析和弯扭矩的计算，对滚筒轴进行了校核，对链传动中的链板通过ansys进行了有限元的分析。

Preferential dissolution of α phase for specimens processed less than 12 hrs were revealed by using ICP-MS (inductively coupled plasma-mass spectroscopy). Hydrides having precipitated in the α-phase at the near surface peeled off into the electrolyte, and thus resulted in reduced HUE for specimens having experienced longer charging periods. In order to increase HUE, the hydrogenation promoter, Na2S2O35H2O, was added into the electrolyte to see the effect on the hydrogen absorption.

感应耦合电浆质谱分析术(inductively coupled plasma-mass spectroscopy； ICP-MS)分析发现，渗氢前一阶段（12小时）铝元素有较明显之溶释现象，此一现象肇因於渗氢作用使近表面层α-相中析出之氢化物体积逐渐扩大膨胀，最后剥落而溶於硫酸水溶液，也因此造成长时间之渗氢效率未随渗氢时间增加而增加。

Based on the results of exploration and in-site test of typical waste dump in southwest mountainous area,the analysis theory and method of waste dump rainfall infiltration are discussed beginning at analysing coal waste's mechanics characteristic and seepage theoty. Fllowed estimating method of waste dump stability is discussed influenced by rainfall. At last a typical engineering example of coal waste dump landslide influenced by rainfall is researched, acquiring research fruit hereinafter.①Particular exploration of typical waste dump in chongqing area and analysis estimate to its area engineering geology are done. Granule gradation、water content、nature density、dry densit etc parameter of waste granular media are tested. The mechanics characteristic of waste are researched by in-site shear experimentation、compressibility experimentation and infiltration experimentation.②The coal waste dumping is different from other consecutive solid material as incompact granule structure. Its shear strength and transforming characteristic also have itself characteristic.

本文针对山区矸石山，结合踏勘和现场试验，从分析矸石散体的力学特性以及渗流理论出发，研究了矸石山降雨入渗的分析理论与方法，在此基础上提出了矸石山体降雨作用下的稳定性评价方法，最后进行了降雨作用下典型矸石山滑坡工程实例研究，取得了以下研究成果：①对重庆山区中梁山、万盛、荣昌、天府、綦江等矿区代表性的矸石山进行详细踏勘，对矸石山的堆放形态及其区域的工程水文地质情况进行调查；针对重庆山区矸石山，测试矸石散体的颗粒级配、含水量、天然密度、干密度等参数、并在此基础上，通过现场剪切、压缩、渗透试验等研究矸石散体的力学特征。

With the full and accurate data, the fourth part had forecasted the development tendency of Nanjing residential real estate market from three aspects of supply, demand and price. On the basis of gray relational analysis method, it demonstrated the main factors affect the commodity housing demand. The paper applied the GM(1, 1) model to establish the gray forecast model of Nanjing commodity housing sales. Finally, based on regression analysis, the result indicates that the housing price was not caused by supply and demand.

第四部分通过大量详实的数据，从南京市住宅市场的供给、需求及价格三方面，预测了南京市未来住宅商品房的供给量，并运用指数增长模型分析了南京市未来住宅房地产开发投资和销售面积的波动趋势；运用灰色关联度实证了显著影响南京市住宅商品房需求的因素，同时，借助灰色预测方法，建立灰色预测模型预测了未来几年南京市住宅商品房销售面积；最后运用回归分析方法实证了南京市住宅商品房价格增长过快并非完全受供求关系影响，同时将定量和定性分析相结合预测了南京市住宅商品房价格的发展趋势。

In this project, the selection criteria of matrix and reinforcement for obtaining composites with high strength and toughness are determined. The as-cast and aged microstructures of composites reinforced with particles of different strength are observed, and their metallurgical conditions and stabilization mechanisms are analyzed. The aging precipitation behaviors and mechanisms are studied. Some characteristics of nano-materials (micro-distortion areas) are found in 150nm- Al2O3p/Al composites and their formation mechanisms are expatiated. The "flexible" restriction to the deformation of the matrix by low strength AlN particle is observed by in-situ TEM and SEM techniques, and the mechanisms of its resist on cracks propagation and its contribution to composite strength are revealed. The high temperature deformation behaviors of Al2O3p/Al composites are studied. A rare-earth coating is established on sub-micron Al2O3 particles, leading to an improvement in wettability between coated Al2O3 and liquid aluminum and a decrease in infiltration pressure. The strength and ductility of coated particles reinforced composite are also increased. The interfacial characteristics, bonding structures and their formation mechanisms are studied, and the crystal orientation relationships between reinforcement particles and aluminum matrix are investigated. Finally a lighter composite with better balance of strength and damping properties is reinforced with hollow ceramic microballoons of ultra-lower strength.

本项目发现了获得高强度和高韧性复合材料的基体、增强体选择依据；观察了各种强度质点增强复合材料的铸态和时效态微观组织，分析其微观结构形成的金属学条件及稳定性机理，研究了其时效析出规律和时效机制，发现了150nmAl2O3颗粒增强铝基复合材料基体中的纳米材料特征，并解释了其形成机理；利用TEM和SEM动态拉伸技术发现了低强度质点AlN颗粒对变形协调的&柔性强化&机制，揭示了其对裂纹扩展的阻碍作用和对复合材料高强度的贡献；研究了中强度质点的Al2O3颗粒增强铝基复合材料的高温变形行为，并对其进行了稀土界面层设计与制备，改善了颗粒与铝合金之间的界面润湿性，降低了复合材料铸造渗透压力，提高了复合材料的强、韧性；研究了多种复合材料界面结构及形成机理，确定了增强体与基体之间的界面结合机制，分析了复合材料界面处的晶体学位向关系；最后制备了含微孔的中空型陶瓷颗粒增强的特种复合材料，得到了强度和阻尼综合性能较好的轻质复合材料。

Nowadays, with the great-leap-forward development of the railway transport industry, for Jingxing Train Operation Depot which is one of the organizations at the grass-roots level, how to fit in with current situation needs to tap the potential, enhance the efficien...

本文运用绩效管理的相关理论，以井陉车务段现行绩效管理办法作为研究对象，在认真分析了井陉车务段的绩效管理现状的基础上，结合当前实际，对井陉车务段的绩效管理体系进行了设计研究，最后针对实施绩效管理体系进行了效果评价分析并提出了进一步的改进建议。

Mahalanobis- Taguchi System; MYT Orthogonal Decomposition; Potential causes analysis of abnormal observations

首先，介绍了马氏田口方法的四大基本步骤；接着介绍了MYT正交分解法，并将MYT正交分解法应用于多元系统的马氏田口方法异常值潜在原因分析；最后，利用拓展后的马氏田口方法对某医院血粘度诊断系统进行了优化，同时对利用优化后的测量表进行诊断时发现的异常值进行了潜在原因分析，取得了良好的效果。

It is not enough to resolve all of the problems related to the hydraulic stability only to analyze the stable field in passing components. Finally, the paper numerically simulated the transient field in prototype's draft tube under different operating conditions by means of Reynolds stress turbulence model and analyzed the law of motion of vortex rope as well as the performance of low-frequency pressure pulsation and compared with field test results.

仅仅对机组的过流部件进行稳定场的CFD数值分析还不足以解决所有与水轮机水力稳定性有关的问题，因此在本论文的最后，采用雷诺应力湍流模型对真机尾水管在不同运行工况下进行了非稳定场的CFD数值解析，分析涡带的运动规律及其产生的低频压力脉动特性，并与真机的试验结果进行了比较，结果比较吻合。

According to the common process of software metric,a research on software reliability metric which is based on the real defect is made firstly.Then the quantitative defect statistic method is applied which is based on ODC.This method can describe the information of defect well and can be used for process improvement.At last, the qualitative method of defect analysis is showed,which can dredge up underlying information.

首先将缺陷度量方法按照软件度量的一般方法进行研究和探讨；其次，以正交缺陷为基础，提出了定量的缺陷统计方法，这种方法能够更好地描述缺陷的性质，对相关信息可进行分类统计、分析，为过程改进提供依据；最后，提出了一些定性的缺陷分析方法，可充分挖掘缺陷的潜在信息。

I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""

客人们在卡罗利娜·埃凯家里，举止就文雅一些，因为卡罗利娜的母亲治家很严厉。

Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.

由著名品牌 Herm è s 设计，这件高贵的制服是香港本土制造，是我们第一套不配帽子的制服。