最厚处

In the axisymmetric section, the axial strain in excircle is maximum, but the maximum radial strain is in inner bore, and the radial strain contrast is used to reflect the variation trend of wall thickness in this ring section.

在轴对称截面的外圆上轴向拉应变最大，内孔处径向压应变最大，并用径向应变对比度来反映该环形截面壁厚的变化趋势。

Studied present measuring methods" advantages and disadvantages, and presented the necessity and importance of researching propellant transient heat transfer.2.according to 130 and aeronautic 90 rocket projectiles" structure, analysed and acquired physical and mathematical models for propellant transient heat transfer, also designed propellant temperature field simulation units for test.3.acquired discrete transient heat balance equation and temperature calculation program, and gave contrasting curves between experimental temperature values and program calculating temperature values as well as maximum errors and average square root errors between them.4.by programs based on the first class boundary condition, worked out temperature distribution in propellant temperature field simulation units at different time, analysed temperature field distribution law and main elements affecting heat transfer, acquired propellant mass weighted average temperature and one at the half position of propellant maximum thickness as well as maximum errors and average square root errors between them.5.established transient heat transfer mathematical model and temperature calculation program for the third class boundary condition, drew contrasting curves between temperature experimental values and calculation values and gave maximum errors and average square root errors between them, got temperature distribution in the simulation unit at different time and main elements affecting heat conduction, figured out propellant mass weighted average temperature and one at the half position of propellant maximum thickness as well as maximum errors and average square root errors between them.

分析了现有测试方法的优缺点，提出了研究推进剂瞬态导热的必要性和重要性。 2。根据130和航90两种火箭弹的结构，分析得到了推进剂传热的物理模型和数学模型，设计了推进剂温度场模拟实验装置。 3。得到了离散形式的瞬态热平衡方程和温度场计算程序，给出了实验温度与程序计算温度值的对比曲线及其最大偏差与均方差。 4。利用程序求出了第一类边界条件下、不同时刻推进剂温度场模拟装置中的温度分布，分析了温度场的分布规律和影响传热的主要因素，求出了推进剂质量加权平均温度和最大肉厚1／2处的温度时间曲线并给出了两者之间的最大偏差与均方差。 5。建立了第三类边界条件下的瞬态导热数学模型和温度计算程序，求出了温度实测值与计算值的对比曲线并给出了两者之间的最大偏差与均方差，得到了不同时刻温度场模拟装置的温度分布与影响导热的主要因素，求出了推进剂质量加权平均温度和最大肉厚1／2处温度及两者之间的最大偏差与均方差，讨论并确定了能代表130和航90推进剂温度的特征点的位置。

"71" Glacier is located 116 kilometers southwest of Jiayuguan City Department Qilianshan hinterland, it is by the Lanzhou Branch of Chinese Academy of Sciences of the scientific and technological workers and the former Soviet Union experts in glaciology July 1, 1958 discovered and named after the date of discovery of a Plateau glaciers.xie gua in the slope of the glacier is less than the slopes of 45 degrees, the average ice thickness of 78 meters, the Department up to 120 meters thick, Bingfeng 5150 meters above sea level, 4300 meters above sea front tongue.

"七一"冰川位于嘉峪关市西南116公里处的祁连山腹地，它是由中国科学院兰州分院的科技工作者和原苏联冰川学专家于1958年7月1日发现、并以发现日期命名的一座高原冰川。该冰川斜挂于坡度小于45度的山坡上，冰层平均厚度78米，最厚处达120米，冰峰海拔5150 米，冰舌前沿海拔4300米。

Results: The labrum was the widest at the point of anterosuperior 90°(8.82±2.20) mm and the thickest at the point of midsuperior (5.56±1.56) mm.

结果：髋臼唇在距髋臼顶点前90°最宽(8.82±2.20)mm，在髋臼顶点处最厚(5.56±1.56)mm。

Bamboo variation ofmicrodensity of all age-degree and all height bamboo from bamboo green tobamboo yellow as follows:The downtrend ladder of microdensity the firststage from bamboo green to bamboo yellow is relatively large,normally at theplace 0.35 from bamboo hull(the thickness of from bamboo hull to bambooyellow is 1)micro-density downtrend ladder begin to get smaller,variancerange of microdensity is smaller.When reaching near bamboo yellow area,microdensity reaches its minimum value,and when reaching bamboo yellowsection density increase rapidly,the minimum density of bamboo is only 50% orless of maximum density.Bamboo yellow is comprised of stone cells whichhave thick cell wall,so its density is high,normally 50% to 100% more thanminimum density.Bamboo yellow′s lay thickness is thin,normally the samethickness for all age-degree and all height bamboo,about 0.8mm.From 1 age-degree bamboo to 2 age-degree bamboo during growth,the increase of averagedensity is mainly in bamboo pulp section,from 3 age-degree bamboo to 4 age-degree bamboo,the decrease of average density is mainly decrease in the pulpsection.Same age,same height,the less the density ladder of bamboo radialthickness,the higher the mechanical strength.

所有年龄所有高度的竹材微密度从竹青到竹黄对材性变异规律如下：从竹青到竹黄开始下降梯度较大，一般到相对竹皮距离0.35左右处(整个竹壁厚度为1)，竹材微密度下降梯度减小，微密度的变化范围变小，到近竹黄处，微密度达最小值，而后到竹黄部位密度大幅上升，竹材最小密度一般只有最大密度的50％或更低，竹黄由厚壁的石细胞组成，所以密度较大，一般比最小密度增大约50％-100％，厚度较薄，不同年龄不同高度竹材的竹黄厚度相差无几，约在0.8mm左右；竹材从1度竹到2度竹生长过程中，平均密度的增长主要发生在竹肉部分，从3度竹到4度竹生长过程中，平均密度的下降主要发生在竹肉部分，同一年龄同一高度，竹壁厚径向的密度梯度越小，力学强度越高，随着年龄的增大，密度梯度越来越小(1度竹除外)，随着高度增加，密度梯度越来越大。

The smaller bismuth ruthenate partical is, sheet resistivity is lower and temperature coefficient of resistance is more positive and the refiring change ratio is nearer to zero.

铅硼硅玻璃粉体平均粒径对厚膜电阻的性能影响有一极值点，约为1.51μm，在该点处膜层的方阻值最小，电阻温度系数绝对值最小，重烧变化率最接近零值。

Series BDS roller screen which obliquities of screen face are changes in turn. The maximal one in inlet then become small gradually. It can realize fast filter and not easy blocking. Best for washy coal.

BGS 变倾角等厚系列滚轴筛，筛面倾角依次变化，入煤处最大，角度逐渐变小，实现快速等厚筛分，不易堵筛，适用于大水分弱粘煤的筛分。

Horny layer is the outmost layer of epidermis, its thickness is decided by different parts of human body, it's about 0.02mm at the thinnest parts, and 0.5mm at the thickest. It is made up of 5-10 layers of enucleated cornified cells that contains keratin and horny fat, which has the capability of resisting weak acids and weak bases , they array closely and become a natural barrier to moisture content and some chemical substances, so as to prevent the water logging of bodily fluids and endosmose of chemical substances.

角质层是表皮的最外层，其厚度依身体部位的不同而定，最薄处约0.02mm，最厚处约0.5mm由5-10层含有角蛋白和角质脂肪的无核角化细胞组成，角质层细胞有抵抗弱酸弱碱的能力，角质层细胞排列紧密，对水分及一些化学物质有天然屏障作用，因而可以阻止体内液体的水渗和化学物质的内渗。

The paper discusses the design thoughts about the mixing proportion of big volumed concrete. The causes of concrete's heat of hydration and contraction are analyzed even the corresponding settlement methods are offered and compartment analysis is made.

临汾污水处理厂是我公司承建的一大型污水处理工程，它不但工程量大(80 0 0m3 以上)，而且其中大部分为大体积混凝土(最厚处达 3 。3m)，抗渗要求P6，同时多为暴露工程(要求混凝土具有高耐久性)。

On the termination date, the cultured explants were all examined by Western blot, HE and transmission electron microscope. Our results showed that after 12-days in culture, the cultivation treated with AS-ODN reduced the synthesis of AMBN and had a deformed dental cusp with thinner enamel matrix. Ultrastructure analyses showed that there was hardly any cisternae of the rough endoplasmic reticulum in the ameloblasts at the tip of the cusp of AS-ODN treatedexplants. However, on average the enamel matrix was thinner compared with that in the control group. Furthermore, the collagen fibers in extracellular matrix were found disorganized. These findings seemed to provide a direct experimental evidence that tended to indicate that the arrested AMBN translation in cultured tooth germs might result in the delay of the tooth development.

经用Western蛋白印迹检测表明，所设计的反义核酸对AMBN InRNA具有良好的封闭效果并成功阻断了牙胚对AMBN的表达；在缺乏AMBN情况下，与对照组相比，实验组牙胚在体外可以继续生长发育至钟状晚期，出现成釉细胞和成牙本质细胞的分化，成釉细胞可以分化成为分泌期型成釉细胞，胞浆中缺少合成蛋白质所必需的粗面内质网和高尔基氏体，缺乏溶酶体，表明对蛋白合成和脚的能力降低；实验组牙胚有牙尖形成和基质分泌，但牙尖形态异常，基质形成减少，牙尖周围基质最厚处为O.6卜m，明显薄于对照组的5.spin，基质中胶原纤维粗细不等，排列稀疏， 3 第四军医大学硕士学位论文未见钙化现象，充分证明了AMBN在牙胚发育中参与釉质基质形成和矿化过程，影响胶原纤维和牙本质基质的合成，促进成釉细胞对蛋白质的合成和釉质基质蛋白降解。

I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""

客人们在卡罗利娜·埃凯家里，举止就文雅一些，因为卡罗利娜的母亲治家很严厉。

Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.

由著名品牌 Herm è s 设计，这件高贵的制服是香港本土制造，是我们第一套不配帽子的制服。