最佳系统

By simplifying air spring mechanics model, We analyze the damping characteristics for air spring suspension system of single degree of freedom, then educe optimal damp of air spring suspension with throttle hole under various situation and optimal diameter of throttle hole. The capability opinion guideline of air spring suspension system is analyzed.

通过简化空气弹簧的力学模型，对单自由度有阻尼空气弹簧悬架系统的阻尼特性分析，得出带有节流孔的空气弹簧在各种工况下的最佳阻尼及节流孔的最佳直径，并分析了空气弹簧悬架系统的性能评价指标。

This dissertation theoretically demonstrates the feasibility to achieve constant direct current-stimulation-circuitry under microampere , bring forward design scheme software and hardware system using in cellular electrical stimulation. In order to further quantitatively research on direct current-stimulation and ascertain the best intensity and density and stimulative current , the quantitative and qualitative analyse for gained diagnostic data are also been discussed in this paper.

本文正是从该理论基础出发，论证了实现微安级直流电刺激的离体组织细胞生长培养实验系统的可行性，提出了用于刺激实验的软硬件系统的开发放案，并对采集数据的定量和定性的分析作了初步的探讨，希望通过实验能够初步确定适合该组织细胞生长培养的最佳刺激电流和最佳刺激时间。

We have the best manufacturing system, QC system and the integrity of the testing equipment is the best quality assurance.

我们最佳的制造系统、QC系统及完整的测试仪器是最佳的品质的保证。

The key technologies of ABS based on slip-ratio consist of processing of wheel speed and calculation of wheel acceleration, estimation of vehicle velocity, estimation of the optimal slip-ratio, and the control strategy of ABS. In order to improve the performance of conventional ABS, the above mentioned key technologies and corresponding realization algorithms had been investigated in this paper, and the ABS product equipped in vehicle for performance test had been manufactured.

结合车辆动力学控制的最佳ABS系统是以车轮滑移率为控制目标的ABS系统，它涉及到一系列关键技术研究，如轮速信号的处理方法和轮加速度信号的计算方法、车身速度估计方法、最佳滑移率估计方法和ABS的控制方法等。

Such as: calibrating the laser system, calibrating the measurement region and focusing the CCD camera for the diffuser passage with complex shape, selecting the best incidence angle for the laser sheet,, setting the time parameter including the time between pulses and the time between records, designing the laser system, and selecting water fog with 1～5μm diameter as seedings for PIV measurement after comparing several particles. All of the work is useful to accumulate the PIV measurement experience in turbomachinery. 2. Experimental research of the unsteady flow in diffusers The instantaneous velocity fields within the vaneless and vaned diffuser were measured by using PIV technique.

本文在国内首次进行PIV测量系统对离心风机扩压器内部非定常流动的测量，为此，作者作了必要的实验前期工作：双谐振激光器工作特性的标定；针对扩压器复杂的流道形状，解决了片光源照射区域位置的标定和CCD相机的聚焦等问题；为复杂流道形状的扩压器内部流动的PIV测量选择了最佳片光源入射角度；选择了合适的PIV测量时间参数；为实现非定常内流的PIV测量设计了PIV系统的光路布置；根据非接触测量示踪粒子的选取原则，对几种示踪粒子进行了筛选，最终1～5μm的水雾粒子在本文实验条件下获得最佳效果。

The results from the experiment are: the amount of all micro-powders that grain sizes are less 0.044 mm should be less than 35% in weight, and the value of coarse q and attenuate q should be respectively 0.23 and 0.32, and the additive amount of active a-alumina and calcium alumina cement should be respectively 7% and 4% in weight, meanwhile, the best dispersant is PMAA-NH4 in the non-microsilica system; while the value of two q should be respectively 0.21 and 0.29, the amount of active a-alumina, microsilica and calcium alumina cement should be respectively 6%, 2% and 4% in weight, the best dispersants are sodium hexamer taphosphate and Na2P3Oio in the microsilica system.

依照上述实验方法得出刚玉自流浇注料所必备的条件：刚玉自流浇注料中的细粉(-0.044mm)总量应小于35％；在无硅微粉系统中的Andreassen公式的粗端q值和细端q值分别为0.23和0.32，氧化铝微粉、水泥的最佳加入量是7％、4％，且所使用的分散剂为改性聚丙烯酸钠最好，而在含硅微粉系统中的Andreassen公式的粗端q值和细端q值分别为0.21和0.29，氧化铝微粉、硅微粉和水泥的最佳加入量为6％、2％和4％，最好合用三聚磷酸钠和六偏磷酸钠作为分散剂。

The transmission system model of car is deduced.Considering the strong non-linear characteristics of system model and coupling effect on car dynamics between engine throttle opening and CVT ratio,the synthesized control algorithm which can keep car performance and fuel economy is given.

建立了汽车传动系统模型，研究了实现发动机最佳燃油经济性的算法，考虑到系统模型的强非线性特征以及发动机节气门与变速器速比对汽车动态性能的耦合作用，给出了保证实现汽车的动力性能和最佳燃油经济性的综合控制算法。

Energy requirement for drying could be reduced by a dryer with a heat recovery device. In order to analyze the optimum operation conditions, the effect of fan speed on the temperature, airflow distribution and effectiveness of the heat recovery device was investigated in the drying system. The optimum fan speed would be at maximum speed during initial heating stage and at lower speed during steady stage in order to improve the performance.

具有热能回收装置的乾燥系统能降低乾燥所需的能量，为了分析此乾燥系统的最佳操作条件，测试其风扇转速对於乾燥室内温度、风速和热能回收装置效能的影响，归纳出风扇最佳运作应是在加热启动阶段应用最快转速，到达稳定阶段后，以较低转速可提升乾燥机的性能。

For the auto mentioned in the paper, we analyze and establish the dynamic equations under different power systems, respectively discuss the system efficiency of HEV under the conditions of whether the storage battery power is zero or not, utilize the SQP to compute the corresponding optimal decelerating rate and optimal storage battery power under the conditions of different speeds, different demand torsions and different storage battery SOC; then use the optimal computation results to summarize the rules of auto optimal control, provide the foundations for the optimal control rules in the future.

对于本车，分析并建立了在不同动力系统工作模式下的动力学方程；分别讨论了当蓄电池功率为零和蓄电池功率不为零两种情况下的HEV的系统效率；利用序列二次规划法来求解出在不同车速、不同汽车需求转矩和不同蓄电池SOC情况下对应的最佳减速比和最佳蓄电池功率；利用优化计算结果，初步总结了一些车辆优化控制规则，为将来更好的优化控制规则提供了依据。

The general model denoting the influence of network operation on the security and stabi-lity of power system dur...

提出了在系统动态过程中网络操作切换对电力系统安全稳定性影响的一般模型，并以重合闸操作序列为例，给出了利用广域动态信息保障网络结构强壮性及系统稳定性的最佳操作序列和最佳操作时间的捕捉方法。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。