最佳工况

The traditional refitted ignition products (for example, high-pressure cylinder line without diffraction, refittedly-complicated products that mix the spark plug and ignition power) are the primang products with no dynamic adjusted ability, which can't meet different requirements of motor under different conditions, thus impossibly causing the motor to be in the best condition.

传统点火改装产品（如：无内阻高压缸线、改装用火花塞及仿冒点火王动力复合仪等产品）均为无动态调节能力的初级改装产品，无法动态满足发动机在不同工况下的不同需求，因而无法使发动机持续工作在最佳状态。

The main contents and results of this paper are listed as follows:Based on the finite element analysis software ANSYS establish a bridge of three-dimensional mechanical model of CWR;Based on an actual project,calculate different conditions of three forms of bridge and research the reasonable removal scope of fastener;Research on the allowed lock temperature rail track construction of partial maintenance of range.By analyzing the result obtain the best way to replace the support of a bridge and the range of removal of the bearing and permission of rail temperature of construction.It supports some recommendations for the replacement of city construction maintenance.

本文主要研究内容为：基于有限元分析软件ANSYS建立了桥上无缝线路三维力学模型；依据某实际工程，分析计算了三种桥梁形式在不同顶升工况下的钢轨和扣件受力，研究了扣件的合理拆除范围；对维修后局部钢轨施工锁定轨温的允许范围进行了研究；分析得出了城轨桥梁更换支座施工的最佳顶升方式、扣件拆除范围和允许施工轨温，为城轨桥梁更换支座的施工维修提出了一些建议。

The pinch point temperature differences analysis method was introduced in this paper, the major equipments of system was designed in term of the guide line that the best general efficiency of cooling and heating mode should be achieved.

本文首先按照使制冷制热两种典型工况下综合效率最佳的原则，利用挟点温差分析的方法设计了系统的主要部件。

The relation between the best Injection Timing and the speed is analyzed, the influence factors about Spark Advance and Spark Close"s in different work conditions are studied, and the relation between Spark Advance and engine"s knocking is found.

论文还分析了最佳喷油时刻与发动机转速的关系，研究了点火提前角和闭合角在发动机不同工况下的影响因素，找出了点火提前角与发动机爆震之间的关系。

In pumping high-viscosity oil, with the increase of the shaft speed, the efficiency of the pump at the optimum operating point is improved, and the flow rate and hoisting height at the optimum efficiency point rises, therefore the rated speed of the viscous oil pump should be remarkably higher than that of the water pump.

输送高粘油时，随着泵轴转速的提高，离心泵最优工况点的效率提高，最佳效率点的流量和扬程也相应提高，因此，输送粘油用的泵的设计转速必须比水泵有较大幅度的提高。

Electrojet system is to provide the best fuel quantity and ignition advance angle to the engine in the accurate digital mode through different operating conditions, change of environment and the intention of rider sensed by various sensors.

电喷系统是通过不同的传感器感知各种工况和环境的变化以及骑乘者的意图，以数字化的精确方式向发动机提供最佳的燃油量和点火提前角。

Start-up working condition is the key to the research of optimal engagement of automatic clutch for AMT.

起步工况是汽车AMT系统自动离合器最佳接合规律研究的难点。

Start-up working condition is the key to the research of optimal engagement of automatic clutch for AMT.

摘 要：起步工况是汽车AMT系统自动离合器最佳接合规律研究的难点。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。