最佳化的

Our company provides different additional services such as sub-distribution, technical consultant and product scheme. We continue our cooperation with giant semiconductor producers, work at providing manufacturers and assemble producers of electronic spare parts with high qualities. We continue promote our competitiveness, challenge ourselves and promote acknowledgement and skills of stuff in order to provide the best services and qualities for our clients.

公司将为你提供代理分销、技术咨询、产品解决方案及多种个别差异化服务加值；继续与世界各大半导体厂商合作，致力提供高素质电子零组件给生产制造及系统整合厂商；不断强化核心竞争力，自我挑战，致力于提升员工的专业知识及技能，为客户提供最好的服务以达到品质最佳化目标。

As compared with the pressure of carrier gas, the subatmospheric pressure is more favourable condition to atomize the hydride, so the atomization temperature was lower (about 650℃).

由於硒化氢的原子化是在负压下完成的，它将比常压或载气压力下更有利於氢化物的原子化，因而使硒化氢原子化的最佳温度降低。

The technique of reducing the design space was used to achieve the best approximation efficiently.

将应用回应表面法於旋翼叶片最佳化设计上，并且采用增加实验观察点的数目、缩小设计空间等技巧寻找出最佳设计的值。

This dissertation aims to probe into the warpage of flash memory card connecter, forecast the possible question through CAE analysis, and select the most proper type of gate, and optimize it through the differentiation caused by the molding condition regulation with Taguchi-methods.

本论文的目的是在改善与探讨快闪记忆卡连结器架构之翘曲变形现象，应用CAE模流分析软体预测可能发生的问题，选择出最佳的进浇模式，并利用田口方法探讨不同的成型条件设定所可能产生的差异性，并予以最佳化。

Results show that the best value of w is 7~10% and 5~7%, i is 0.08~0.2 A/cm^2 and 0.03~0.05 A/cm^2 respectively, during the electrolysis fluorination of pyridine and tributylamine; the addition of N-butyl mercaptan into the organic mixture can stabilize electrolysis process with its mass fraction 15~20% at best; impulse current polarization work status of low load is helpful to the electrolysis process and reduces corrosion rate of anode; electrolysis temperature is suitable at 0~20℃; electrobath can use electrolyte inner circulation structure, exterior circulation structure or blending structure.

结果表明：吡啶和N-三丁胺电解氟化的最佳值w分别为7%~10%和5%~7%，i分别为0.08~0.2A/平方公分和0.03~0.05A/平方公分；有机混合物中添加N-丁基硫醇可稳定电解过程，其质量分数最佳为15%~20%；采用低负荷的脉冲电流极化工况有利电解过程，降低阳极的腐蚀速度；电解温度0~20℃为宜；电解槽可采用电解液内循环、外循环结构，或其混合结构。

The effects of the corrosive accelerator,acid ratio,phosphatizing temperature,phosphatizing time and the additives on zinc phosphatization of aluminum alloy were investigated.

以LY12铝合金为试样，讨论了腐蚀加速剂、酸比、磷化温度、磷化时间、磷化添加剂对铝合金磷化的影响，得出了相应的最佳工艺参数。

Convention V-belt Continuously Variable Transmission, shifts gears the travel mechanism property fixed constraint, unable full into full play initiative control advantage, to engine and Transmission on the go to hold optimum match, Also takes into consideration acceleration and fuel consumption performance, so this paper research Motorcycles with an Electronically-Controlled Continuously Variable Transmission shift gears planning, to use motor power screw, we shall revolve motion changes rectilinear motion, to push driving sheaves achieved to change speed ratio; Comparison between analysis convention CVT speed ratio shift gears curves of acceleration and fuel consumption performance optimum curves, use engine can hold high performance output or low fuel consumption region run.

中文摘要传统皮带式无段变速器(Continuously Variable Transmission， CVT)，换档行程由於机械特性的限制，无法完全发挥主动控制的优点，让引擎与变速器随时保持在最佳的匹配状态，同时顾及加速性能与燃油消耗，所以本文主要研究机车用电子控制式无段变速系统(Electronically Controlled Continuously Variable Transmission， ECVT)最佳换档规划，利用马达与动力螺杆，将旋转运动改变为直线运动，以推动主动滑轮达到改变减速比；分析传统CVT减速比换档曲线与最佳化曲线之加速性能及燃油消耗比较，使引擎能够保持较高性能输出或较低油耗区间运转。

The mechanism ofcopolymerization and the best technological condition for copolymerization and sulfonation were studied .

重点研究了树脂基体合成及基体磺化制备阳离子交换树脂，找出了基体合成及磺化的最佳工艺条件。

First, a domain-pipelined scalability technique is used to optimize the pipelined structure according to the number of processing cycles.

第一，我们使用区域管线化调整技巧以依照处里的周期来最佳化管线化的结构。

First, we study the optimization of the estimate mean-square error of the polynomial interpolation. We introduce a window shift concept, derive the optimal window shift, and propose the estimation method of the value under a given interpolation order.

首先，我们探讨多项式内插通道估计演算法的估计误差之最佳化，提出滤波器窗口漂移概念，在给定内插阶数的情况下，推得最佳漂移量的理论值与其值估计方法。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失