最佳化的

RE modified multicomponent microalloy low chrome cast iron was subcritically treated to expect its hardmess and toughness to be an optimal match.

摘 要：对经稀土复合变质的多元合金化低铬铸铁进行亚温处理，以求其硬度与韧性的最佳匹配。

By minimizing expected total sample size for fixed significance level and power, optimal sample size and cut-off parameters were obtained.

在固定的显著水准以及检定力之下，藉由最小化期望总样本数，可以得到最佳的样本数以及参数组合。

Objective To investigate the optimum condition and properties of immobilization of acetylcholinesterase with chitosan as its carrier.

目的 探讨以甲壳胺为载体固定乙酰胆碱酯酶的最佳条件及固定化酶的理化性质。

To avoid this, a robustness index is proposed as a replacement for the gain margin. Optimal controller design is the achievable by minimizing a designated error integral criterion for a load disturbance subject to inequality constraints on phase margin and the new robustness index.

因此，本文提出一强韧性指标来取代传统的增益边距，最佳强健控制器即可在相位边距和此指标的不等式限制下，透过将负载扰动产生之特定误差积分最小化来取得。

The river, the waterfall, reservoir NaDuJiang: ChangHuaJiang, scenery, WanQuanHe etc, beach tam, river, water is clear, winding is a good place, junketing to WanQuanHe nationally famous for best scenery.

Peninsula，大河、瀑布、水库风光：南渡江、昌化江、万泉河等河流，滩潭相间，蜿蜒有致，河水清澈，是旅游观景的好地方，尤以闻名全国的"万泉河风光"最佳。

Methods The donor rat spleen was continuously perfused with WZD to select the best protocol. Then the lymphopoiesis was examined with mixed lymphocyte culture and the splenic cells were observed microscopically and immunohistochemically.

以WZD溶液持续灌注移植脾，筛选最佳方案，并观察灌注后混合淋巴细胞培养（mixed lymphocyte culture，MLC）淋巴细胞增殖情况及脾细胞的超微结构，以及灌注后移植脾细胞的免疫组化情况。

The feasibility of chromium residue as cement mineralizer was proved theoretically and practically.

研究对比了掺加铬渣前后水泥制品、"三废"排放和装置消耗的各项性能指标，得出了铬渣作水泥矿化剂的最佳掺加量。

The best orientations and sections in TEE based on the visible heart are helpful to simplify the operation procedure of multiplane TEE and to shorten the examination time.

可视化心脏模型与多平面TEE进行对照研究所确立的多平面TEE最佳方位和常用切面，简化了诊断法洛四联症的操作过程，缩短了检查时间。

The experimental result shows that in the spectra region between 6500 cm~(-1) and 5300 cm~(-1),the best model is built by the standard normal variate ...

试验结果显示，通过标准归一化预处理，选取6500~5500 cm-1波长范围内的光谱经过主成分分析后，提取11个主成分，选用径向基函数作为核函数建立的模型最佳。

According to the microstrure and properties, it is concluded that the optimal homogerinzing process is 400 ℃×15 h.

根据均匀化退火后的组织与性能变化确定了最佳的退火工艺为400℃×15h。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。