最佳化的

The factors such as the quantity of coal fly ash, types of acid, concentration of acid and agitating time were discussed.

通过正交实验找出最佳参数，探索了酸化处理的粉煤灰处理印染废水的机理和效果。

Computer simulation for the metal, silicon dioxide, gallium arsenide by the different thickness of surface plasma waves generated by analysis and comparison done by analysis of surface plasma waves to find the best angle and resonance absorption.

电脑模拟时针对金属、二氧化矽、砷化镓在不同厚度时所产生的表面电浆波做分析与比较，藉由分析表面电浆波找出共振角与最佳的吸收度。

Processing study of sodium copper chlorophyll production from water lettuce leaves ;2. This paper studied the technological process of the preparation of sodium cobalt Chlorophyllin from water lettuce leaves .

本文报道了以水浮莲叶为原料制取钴叶绿酸钠的方法及其最佳的工艺条件为：用95％乙醇在70℃提取1h，5％NaOH皂化60min，20％CoCl_2溶液钴代，2％NaOH溶液成盐。

The technological optimum conditions of Dietary fiber in podding alfalfa was extracted by adding 2.0%α-amylase at the conditions of pH6 and 65℃for 60min ,the ratio of material and liquid 1∶1 4 and 0.05%β-amylase at the conditions of pH6.5 and 65℃for 30min and 4.2% papain at the conditions of pH8.5 and 65℃for 60min.

结荚期苜蓿膳食纤维制取的最佳工艺组合为：料液比1∶14+加酶量2.0%+处理温度65℃+PH值为6+水解时间60min；糖化酶量0.05%+温度65℃+PH值6.5+处理时间30min；加木瓜蛋白酶4.2%+处理温度65℃+pH值为8.5+处理时间为60min。

The effect of roasting temperature and time,and kind of sodium agent and proportioning on the roasting of Panzhihua V-Fe concentrate was studied.

研究了焙烧温度、焙烧时间、钠化剂种类、配比等对攀枝花钒铁精矿焙烧的影响，得出了焙烧阶段最佳条件为焙烧温度为1 300℃、焙烧时间为120 min、Na2CO3含量为6%。

And the optimum fermentation conditions were determined as follows: inoculation of 0.10 % YWBY in saccharifying mash, the ratio of material to water was 1∶1.0 and 9 d fermentation at 25 ℃ during chief fermentation stage, then 20 d fermentation at 22 ℃ in late fermentation stage.

确定草菇糯米甜酒的最佳发酵工艺条件：主发酵工艺条件为在糖化醪中接入0.10 %YWBY，料水比1∶0.8，25 ℃下发酵9 d；后发酵工艺条件为22 ℃下发酵18 d。

All process factors that influence the composite thermochomic materials including the molar ratio of ester to water, pH value, reaction temperature, aging temperature, the dosage of thermochomic materials were carefully researched to have successfully acquired the optimal formulation.

重点研究了制备工艺各因素如酯水摩尔比、pH值、反应温度、陈化温度和变色材料用量等对热敏变色复合材料的影响，得出最佳工艺。

In this paper,APPL develop language in the finite element softem ANSYS be used to write programs carry out parameter analysis,each alley wind-speed with deferent seat of dirersion plate in oven will be calculated.Through deal with data to find the best seat of diversion plate,thus to simulate ineal wind-speed Fluid State.

这里采用有限元分析软件ANSYS内置APDL开发语言，编写程序进行参数化分析，计算出导流板不同位置形式时的烘箱各层巷道中风速，再通过数据处理找出导流板最佳位置，从而仿真模拟出理想风速流态。

Heat radiation thermometer is most suitable for monitoring the surface temperature of concrete slab in deicing or snow-melting.

在综合考虑各种复杂因素后，提出导电混凝土用于融雪化冰时表面温度的最佳监测方法是辐射法。

The optimization reaction condition is that using the mixture catalyst of phosphorous acid ester and dihydrogen phosphate, and toluene as solvent, at 105 oC and refluxing 30 hours, the yield is 90% with purity over 95%.

在最佳条件下，即在混合催化剂亚磷酸酯/磷酸氢盐的作用下，以甲苯为溶剂，在105 ℃反应30 h，酯化收率90%，纯度95%以上。

The concept of equivalent rotationally rigidity is offered and the formula of rotationally rigidity is obtained.

主要做了如下几个方面的工作：对伸臂位于顶部的单层框架—筒体模型进行分析，提出了等效转动约束的概念和转动约束刚度的表达式。

Male cats normally do not need aftercare with the exception of the night after the anesthetic.

男猫通常不需要善后除了晚上的麻醉。