最佳

The factors to influence fatigue life of chain plate are concluded by experimental methods.

用试验方法确定了挤孔对链板疲劳寿命的影响，从理论上分析了在最佳挤孔量下，链板疲劳寿命提高的因素，用有限元法计算了 16 A链板的最佳挤孔量，并与试验结果进行了比较。

BSI Group integrates internal pricing resources among Southern China, Eastern China, Northern China and South-western China and provides best logistic solution to meet clients' request on efficiency, space protection, clearance, competitive rates, more choices, fast safe handling and etc.BSI Group has developed a professional, skilled and high-educated team and provided best services to customers with its research in freight forwarding field and most efficient freight management system. BSI Group has used EDI system to connect airlines system, port terminal system and customs system, which can update cargo status to customers in time.

BSI的集团整合内部资源的定价中国南部，东部中国，中国北部和西南部中国，并提供最佳的物流解决方案以满足客户的要求，提高效率，空间的保护，清除，竞争力的价格，更多选择，快速安全处理等 BSI的集团制定了一个专业，熟练和高学历团队，并提供最佳的客户服务与研究领域中的货运代理和最有效的货运管理系统。

This kind of new combustion control method can guarantee the best air/fuel ratio and make furnaces always working in the best buming state.

由于每个烧嘴阀门的开度可以事先选择，即选择最佳的开度，使燃料与空气的比例达到最佳。

The best combination of anode and cathode flow channel flow was anode flow channel cross-finger, the flow field composed of the cathode flow channel cross-refers was the best combination of flow field.

阳极流道与阴极流道的最佳组合为阳极交指流道、阴极交指流道组成的流场为最佳组合流场。

At first, we made up an appropriate configuration of design and determined which factors might have effect on slim products. Then we determined control factors and standards of control factors that were set according to the standard of Dr. Taguchi's experimental orthogonal array. With the bigger the better of orthogonal array, L9(3^4), we conducted confirmation procedure on operating factors by use of cypress essential oil on slim cosmetics. The experiment was used to obtain best combination of parameters by S/N ratio and characterizations that were based on the data constructed by Taguchi Methods.

首先，决定配方中的控制因子以及控制因子的水准，依照田口方法中直交表的设定，配合实验之望大特性，利用L9(3^4)直交表所建立的数据资料别以S/N比及品质特性两方面进行最佳化参数组合之求取，並依照所决定出之最佳化参数进行確认，最后再以变异分析来確认重要因子的存在性。

Finally, we confirmed the consistency between forecast values and experimental values by variance analysis and confidence segregation. The results were that better slim effect would be obtained by higher cypress essential oil concentration with compound essential oil and more massage. The results showed S/N ratio were improved from 8.8 to 11.68 after parameters optimization. The best formulation obtained from experiments was 15 drops of cypress essential oil adding 5 drops of compound essential oil and 55 cc base oil plus 10-minute massage.

实验结果发现，檜木精油欲发挥其瘦身作用除了比例要提高之外，还需搭配复方精油及较长时间的按摩，才能达到较佳的瘦身效果，此效果经实验设计所得到的S/N比由原本的8.80，经由最佳参数组合后提升为11.68得到证实；而实验之最佳配方则是50cc的基础油中，加入檜木精油15滴、复方精油5滴，按摩时间10分钟。

This paper begins with an analysis of the bearing force of the door-shaped hanger and the trajectory courses, and then makes a detailed study of the different causes for the crevices in them.

从门型吊承轨梁的受力分析入手，研究剖析了原结构产生裂纹的诸多原因，通过理论计算，做出了承轨梁与桁架连接接点的最佳设计，提出了符合现场实际情况的更换承轨梁的最佳方案，为类似设备改造提供了可借鉴的经验。

Energy requirement for drying could be reduced by a dryer with a heat recovery device. In order to analyze the optimum operation conditions, the effect of fan speed on the temperature, airflow distribution and effectiveness of the heat recovery device was investigated in the drying system. The optimum fan speed would be at maximum speed during initial heating stage and at lower speed during steady stage in order to improve the performance.

具有热能回收装置的乾燥系统能降低乾燥所需的能量，为了分析此乾燥系统的最佳操作条件，测试其风扇转速对於乾燥室内温度、风速和热能回收装置效能的影响，归纳出风扇最佳运作应是在加热启动阶段应用最快转速，到达稳定阶段后，以较低转速可提升乾燥机的性能。

Secondly, to start with the distribution of temperature field, pressure field and dryness fraction along the injector well, the paper built a steam heat loss forecast model of the injector well, obtains condition the best steam injection pressure and steam injection speed under certain formation.

其次，从蒸汽沿注汽井井筒的温度场、压力场以及干度的分布入手，建立了注蒸汽井井筒的热损失计算模型，得出一定地层条件下的最佳注入压力和注汽速度。确立了井筒的最佳注汽压力和速率。

After rescreened,a strain F00 (named temporarily F00, the same to the following),with highest flocculating activity was picked up.Using optimized and orthogonal tests, the optimum culture conditions are: Sugar as source of carbon, Cargamide as source of nitrogen,added P, Mg, K, Zn, Mn mineral elements, initial pH value 6.5, inoculation 4-5 x 104spores/ ml, temperature 30癈 and aerations 80 rpm.

通过用它作接种量、培养基优化及最佳发酵条件正交试验，确定F_(00)产生絮凝剂最佳条件：发酵培养基以蔗糖作碳源，尿素作氮源，辅加磷、镁、钾、锌、锰等矿质元素，初始pH值6.5，接种量为每毫升发酵液起始含4～5×10~4个孢子，发酵温度30℃，摇床转速80rpm。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。