曲线

The integrative usage of network optimization algorithm, cubic B Spline curve and Genetic Algorithm finds optimal and flyable curve .

考虑导弹飞行特点及机动能力的约束，利用网络优化算法、三次 B-样条曲线以及遗传算法寻找出性能指标最优的可飞行样条曲线；最后根据所求出的最优样条曲线给出导弹航路点。

In the long time creep tests, by regressive analyses, the creep curve of glauberite at different stress level is obtained: at 50% of its compressive strength, the creep curve is ε 0.009t0.3265, at 80% of compressive strength, the creep curve is ε=0.0098ln-0.0014. It is clear from the creep curves of the rock mass, that the creep rate at high stress level is higher than that at the lower stress level.

通过长时间的蠕变实验，回归出钙芒硝盐岩蠕变在不同应力水平下随时间变化的曲线，其抗压强度50%时的曲线方程为ε=0.0098ln-0.0014，抗压强度80%时的蠕变曲线方程为ε=0.012ln-0.0056，应力水平高时其蠕变速率高于低应力水平的蠕变速率。

As KKД-500 gyratory crusher has large nip angle,linear steep crushing chamber profile,different throughputs of cross sections along the chamber height,it has poor crushing performance and short liner service life.Based on the structural analysis of the original crushing chamber,in the design principle of variable nip angle,the curve equations for moving cone lining and the fixed cone lining were setup by multi-stage fitted curves.

针对KKД-500旋回破碎机大啮角、直线陡锥破碎腔型，沿破碎腔高度各个截面的通过能力不尽相同，其破碎性能差，衬板使用寿命短的情况，在分析原旋回破碎腔型结构的基础上，按照变啮角设计原则，采用多段二次拟合曲线分别建立动锥衬板和定锥衬板曲线方程，利用计算机绘制衬板曲线，确定衬板结构，并优化破碎腔型。

As kkд-500 gyratory crusher has large nip angle,linear steep crushing chamber profile,different throughputs of cross sections along the chamber height,it has poor crushing performance and short liner service life.based on the structural analysis of the original crushing chamber,in the design principle of variable nip angle,the curve equations for moving cone lining and the fixed cone lining were setup by multi-stage fitted curves.lining curves were plotted by computer,the lining structure determined,and the...

针对kkд-500旋回破碎机大啮角、直线陡锥破碎腔型，沿破碎腔高度各个截面的通过能力不尽相同，其破碎性能差，衬板使用寿命短的情况，在分析原旋回破碎腔型结构的基础上，按照变啮角设计原则，采用多段二次拟合曲线分别建立动锥衬板和定锥衬板曲线方程，利用计算机绘制衬板曲线，确定衬板结构，并优化破碎腔型。通过对铝土矿的破碎试验表明，采用新型破碎腔型，其破碎性能和破碎产能显著提高。

So, some researches are present in this paper: 1 In this paper, a finite element model of curved box girder jointless bridges supported on piles is brought forward, considering the interaction between structure and soil.

本文就无伸缩缝曲线箱梁桥剪力滞效应的分析开展了如下的研究： 1、考虑桩土效应，建立无伸缩缝曲线箱梁桥有限元模型，研究在不同荷载下无伸缩缝曲线箱梁桥剪力滞系数的分布规律。

Finally, since a lot of valuable achievements in p-y curve model have been made and put into practice in the overseas design of pile foundations on liquefiable grounds whereas the domestic research is still at the start with focuses laid on experiments, some thoughts and understandings on the p-y curves are put forward in this review to elucidate effective technical approaches.

液化土p-y曲线的模型研究国外已取得不少很有价值的科研成果并开始用于桩基设计中，而国内才刚刚起步且以试验研究为主，基于这个事实，提出了对曲线模型研究的若干建议与认识，为曲线模型研究提供一些技术思路。

The properties of liquid crystal light value, including the response curves between input and projection beam in real, inversed, and differential state, also the relationship between the transmission of the liquid crystul and the working voltuge when different input beam lumination provided, are measured by facile method.

用简便易行的方法对液晶光阀的工作特性曲线作了测量，包括光阀在正像、反转像和微分像状态读出光强与写入光强的响应曲线，以及不同写入光照度下液晶层透过率与工作电压的关系曲线。

Flatten uroflow curves were seen in all patients with marked meatal stenosis. A bell-shaped flow curve was obtained in most patients after urethroplasty using oral mucosa graft combined with a local flap. The peak flow was within the normal range. The flow curve was obviously flat in patients with urethral stricture. The maximum flow rate was low and the voiding time prolonged apparently.

尿流率曲线低平的患者，均伴有明显的尿道外口狭窄；口腔粘膜片移植与局部皮瓣耦合再造尿道修复尿道下裂的患者，多数恢复了接近正常的钟形尿流率曲线，最大尿流率在正常范围：尿道下裂术后尿道狭窄的患者排尿曲线明显低平，最大尿流率降低，排尿时间延长。

When manufacture part which with curved surface by of contour machining,the shape of profile modeling is not as same as the part,they also without simple relation of minify or magnify.

仿形车、铣加工曲面零件，主要是通过靠模曲线来实现的，靠模曲线形状通过带有滚轮的靠模触头传递到刀具上，加工出零件所需的曲面形状。靠模曲线与零件曲面有什么样的关系？

According to AD curve with AS curve nodical decision is real always yield and the general and balanced principle of price total level, be described like can correct ground and analyse each years of AD, the actual mobile contrail of AS curve, will conduce to the settlement of above difficult problem undoubtedly.

根据AD曲线与AS曲线的交点决定真实总产出和价格总水平的一般均衡原理，如能正确地描述和分析各年AD—AS曲线的实际移动轨迹，无疑将有助于以上难题的解决。

And discuss some key point of integrated management system design, include hazard identification and risk assessment and risk control in the occupational health and safety management, the measure of satisfaction target of customer, the flawlessness of law system, the integration of the integrated management system and enterprise standardization system, unify lead institution and work orgnization, integreted internal audit and integrated management review.

同时，论述了一体化管理体系构建中的几个主要问题，包括职业健康安全管理中的危险源辨识、风险评价和风险控制、顾客满意度的科学监测、法律、法规体系的完善、一体化管理体系与企业标准化体系的有机结合、统一的领导机构和工作机构、一体化的内部审核和管理评审。

Deepwater Taranaki is investigated for its petroleum potential, using all available seismic data tied to shallow-water wells.

运用与浅水井相关的现有全部震波探测数据考察了深海区塔拉纳基盆地的油藏前景。