曲流
- 与 曲流 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
This patient received chemotherapy with DVCP,idarubicin and imatinib mesylate and was treated with sporanox and amphotericin B (Amb; including Amb-L) and cerebrotomy for drainage because the invasive aspergillosis occurred during myelosuppression.
患者在骨髓抑制期发生侵袭性肺、脑曲霉菌感染,给予伊曲康唑、两性霉素等抗真菌治疗,进行了开颅病灶引流术。
-
The results show that the flow stress decreases with increasing deforming temperature and increases with increasing strain rate. The flow stress of the alloy during hot compression deformation can be described by constitutive equation in hyperbolic sine function with a hot deformation activation energy of 196.27 kJ/mol. Partial recystallization takes place in the alloys deformed at a high temperature or at a low strain rate, and large number of dislocations and subgrains are observed in the alloy. The elongated grains observed in the samples coarsen with increasing temperature and decreasing strain rate. Correspondingly, the subgrain size increases and the dislocation density decreases. The main soften mechanism of the alloy transforms from dynamic recovery to dynamic recrystallization.
结果表明:Al-Cu-Mg-Ag耐热铝合金在热压缩变形中的流变应力随着温度的升高而减小,随着应变速率的增大而增大;该合金的热压缩变形流变应力行为可用双曲正弦形式的本构方程来描述,其变形激活能为196.27kJ/mol;在变形温度较高或应变速率较低的合金中发生部分再结晶,并且在合金组织中存在大量的位错和亚晶;随着温度的升高和应变速率的降低,合金中拉长的晶粒发生粗化,亚晶尺寸增大,位错密度减小,合金的主要软化机制逐步由动态回复转变为动态再结晶。
-
In this paper, a modified multi-zone coupling method is presented for simulating the integrated flowfield of annual combustors, the SIMPLE-ENC algorithm is presented to achieve higher accuracy, and the wall function method in arbitrary curvilinear coordinates for treating near wall region is given here.
针对燃烧室多连通域的特点,本文采用分区法生成网格,并且提出了一种即时传递信息的改进多区域耦合法求解燃烧室整体流场,该法已成功地应用于涡扇和涡轴发动机环形燃烧室整体流场计算;本文提出了计算流场的SIMPLE-ENC算法,显著提高了流场计算的收敛速度;本文详细描述了壁面函数在空间任意曲壁上的应用方法。
-
The results indicate that the flow stress of the alloy increases with increasing strain rate and decreasing deformation temperature. The flow stress increases with increasing strain until the stress reaches the peak value, then the flow stress remains constant, which indicates that dynamic recrystallization happens during deformation. The flow behaviors are described by the hyperbolic sine constitutive equation, and the activation energy calculated is 337.75 kJ/mol. The as-forged microstructure consists of refined α2/γ and γ grains, and the grains are much homogeneous than before. The B2 phase distributes uniformly at the grain boundary of α2/γ and γ grains. The B2 phase decreases with increasing deformation temperature.
结果表明:流变应力随着应变速率提高和变形温度降低而增大;在变形过程中,流变应力随着变形量增大而增大,当流变应力达到峰值后趋于平稳,表明合金在变形过程中发生了动态再结晶;热变形过程的流变应力可采用双曲正弦本构关系来描述,平均激活能为337.75 kJ/mol;从合金的组织演化过程中可以看出,合金中不均匀的原始组织得到明显均匀化,变形后的组织是由α2/γ层片晶团和γ晶粒组成的双态组织,在α2/γ层片晶团和γ晶粒的晶界交界处发现分布均匀的B2相,并且随着变形温度升高B2相数量逐渐减少。
-
Experiment: respectively measures the reaeration ability of the smooth overflow surface and roughened overflow surface(hemispheroidal surface and stepped surface), and analyses contrastively the effect and reason of reaeration improving after roughened modification.
曲线型溢流坝复氧室内模型试验:分别对光滑溢流面和糙化溢流面(粗糙溢流面及阶梯溢流面)的复氧能力进行了测试,对比分析了溢流面糙化后复氧增强的效果和原因。2。
-
Rubber dam laboratory model experiment: respectively measures the reaeration ability of smooth overflow surface and roughened overflow surface, then contrastively analyses the effect and reason of reaeration improving after roughened modification, and the reaeration effect between curve dam and rubber dam.
橡胶坝复氧室内模型试验:分别测量了光滑溢流面和糙化溢流面的复氧能力,对比分析了溢流面糙化后复氧增强的效果和原因,并对摘要比分析了曲线型溢流坝和橡胶坝的复氧效果。4。
-
A numerical model was established by combining the seven-flux model of light propagation with the two-dimensional hyperbolic heat conduction model in cylindrical coordinates. It showed that there exists a great discrepancy between the results obtained by treating the laser irradiation as volumetric absorption (i.e. taking laser scattering and absorption into consideration) and those obtained by treating the laser irradiation as the second boundary condition.
将激光传输的七流模型与圆柱坐标系内的二维双曲型导热模型相结合建立了理论模型;将激光照射处理为容积吸收(即考虑激光在生物组织中的散射和吸收)所得到的计算结果,与将激光照射处理为第二类传热边界条件所得到的计算结果相比,两者差别很大;考察了激光照射下散射系数和吸收系数对生物组织内双曲型导热的影响。
-
I was swept away by the vibrance of I Saw Three Ships. In a kick- up-your-heels irish romp, Schmidt's fingers dance an impromptu Riverdance. Schmidt's own arrangement, Christmas Morning, is an upbeat tune that celebrates all the best of Christmas morning: the anticipation of opening brightly colored packages, waking up early to that first cup of hot coffee, and being caught in the whirlwind called cooking the Christmas dinner. And, finally, his rendering of Silent Night struck just the right chord for me--reverent jubilation. His almost silent introduction builds to a joyful crescendo.
我被第三曲《 I Saw Three Ships》打动,Schmidt的手指即兴舞了一曲大河之舞,Schmidt为我们精心描绘了一幅蓝图:那是个欢乐的曲调,所有最好的庆贺都放在圣诞节的早晨,打开色彩明亮圣诞礼物包装盒时的期盼、清晨早早地醒来第一杯温热的咖啡、卷入烹饪圣诞晚餐的旋流,最后,他几乎诮无声息地带我们进入一个欢乐的高潮,Schmidt将他圣诞节的爱明显地表露在他的演奏之中。
-
E construction. The assembly forms terraces overflown by the water which performs a cheerful music of welcome.
玲珑多姿的大小彩池,梯列而连,丁冬的流水声如一曲曲欢快的迎宾曲,迎接远道而来的游客。
-
The procedure performed included 23 crossover saphenous vein bypasses 5 in situ saphenopopliteal bypasses 4 interventional therapies of iliac venous occlusion 2 muscular flap constructions on the popliteal vein 38 varicose vein strippings partly with the ligature of communicating venous and ulceration skingraftings 22 endovenous laser treatments of varicosis partly with ulceration skingraftings 17 simple ulceration skingraftings and 3 free flaps transfer for ulceration.
全组105例患者,共114条患肢,其中23条行大隐静脉交叉转流术, 5条行原位大隐静脉-腘静脉转流术, 4条行髂静脉介入治疗, 2条行腘静脉外肌袢形成术, 38条行曲张浅静脉剥脱术,部分联合交通静脉结扎和溃疡清创植皮术, 22条行曲张浅静脉腔内激光术,部分联合溃疡清创植皮术, 17条行单纯溃疡清创植皮术, 3条行溃疡清创联合游离皮瓣移植术。
- 推荐网络例句
-
I can not make it blossom and suits me
我不能让树为我开花
-
When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.
当温度高于 80 °C 左右时,滚道或滚动元件褪色是很常见的特征。
-
The lawyer's case blew up because he had no proof.
律师的辩护失败,因为他没有证据。