晶粒

In order to solve the experimental problem of tricrystal,elastic stress distribution of copper tricrystal under monotonical loading was analyzed by finite element method,the shear stress on slip system in each grain was analyzed.

采用有限单元法计算三晶体在单向拉伸载荷作用下弹性阶段的应力场，分析了三晶体中各晶粒主滑移系上的切应力分布，计算结果表明，当晶界平行于加载轴时，该晶界对其两侧晶粒有很明显的作用，较大程度的改变晶粒滑移系的形式，而且作用程度要超过三晶交点的作用，倾斜晶界则没有明显的作用。

After fired at 1600℃, with the increase of zircon addition the bulk density of the samples increases while apparent porosity decreases. When zircon addition is 4%, the strength is the best, and the photomicrograph of the sample exhibits a densely packed microstructure, with larger and better developed grains of periclase and spinel. Meanwhile, the direct bonding of solid phases is reinforced.

在1600℃热处理下，随着w(ZrSiO4)的增加，试样的体积密度增大，显气孔率变小，试样力学强度在w(ZrSiO4)为4%时达到最大值。w(ZrSiO4)为4%的试样整体显微结构致密，固相直接结合程度提高；并且方镁石和尖晶石晶粒的晶粒尺寸粗大，晶粒发育比较完整。

The Y-TZP nanoceramics with an average grain size of 60 nm and a relative density of 98% were prepared by pressureless sintering.

采用无压烧结获得了相对密度为98%、平均晶粒尺寸为60nm的Y-TZP纳米陶瓷。Y-TZP纳米陶瓷的显微硬度主要取决于陶瓷的相对密度、相结构和晶粒尺寸，即陶瓷的四方相质量分数越高，相对密度越大，晶粒尺寸越小，则显微硬度越高。

A steel plate having a tensile strength of at least about 930 MPa (135Ksi), a toughness as measured by Charpy V-notch impact test at least about 120 joules (88 ft-lb), and a microstructure comprising at least about 90 volume percent of a mixture of fine-grained lower bainite and fine-grained lath martensite, wherein at least about 2/3 of said mixture consists of fine-grained lower bainite transformed from unrecrystallized austenite having an average grain size of less than about 10 microns and comprising iron and specified weight percentages of the additives: carbon, silicon, manganese, copper, nickel, niobium, titanium, aluminum, calcium,rare earth metals, and magnesium, is prepared by heating a steel slab to a suitable temperature; reducing the slab to form plate in one or more hot rolling passes (10) in a first temperature range in which austenite recrystallizes; further reducing said plate in one or more hot rolling passes (10) in a second temperature range in which austenite does not recrystallize, quenching (12) said plate to a suitable quench stop temperature (16); and stopping said quenching and allowing said plate to air cool (18) to ambient temperature.

一种钢板，其抗拉强度至少约930MPa135ksi），在－40℃（－40°F）下，采用夏氏V型缺口冲击试验测定的韧性至少约120焦耳（88英尺－磅），并且其显微组织包含至少约90％体积的细晶粒的下贝氏体和细晶粒的板条马氏体的混合物，其中该混合物的至少约2／3由从平均粒径小于约10微米的未再结晶奥氏体转变而来的细晶粒的下贝氏体组成，而且，其中所述的钢板包含铁和特定重量百分比的添加元素：碳、硅、锰、铜、镍、铌、钛、铝、钙、稀土金属和镁，所述钢的制备过程为：将一钢板坯加热至一个适当的温度；在奥氏体可发生再结晶的第一个温度范围内，采用一个或多个热轧道次（10），将所述板坯轧制成板材；在奥氏体不发生再结晶的第二个温度范围，采用一个或多个热轧道次（10）进一步轧制所述板材；将所述板材淬火处理（12）至一个适当的淬火终止温度（16）；停止所述淬火处理并将所述板材空冷（18）至室温。

The influence of thickness d of ZnO varistors on the residual voltage ratio K \-r has been experimentally studied.It is showed that K \-r also has dimensioned effect. The results show that there is a residual voltage ratio K \-r decreases propor tonally with E \- 1mA ,and increase μ as grain mean size.

实验研究了厚度d 对ZnO压敏电阻片残压比Kr 的影响规律，表明残压比同样存在几何效应；实验还表明残压比Kr 随电位梯度E1m A成反比例下降，随平均晶粒尺寸μ的增大而增大；找到了一个综合微观结构参数平均晶粒尺寸μ和晶粒尺寸方差σ2 的乘积（σ2μ），能较好地反映电性能与微观结构参数的关系。

The results show that Fe0.13[Co20Ni80]0.87 alloy fibers are characterized with thin diameters between 0.3 and 2.0 μm, with high aspect ratio, dense and smooth surfaces. The crystalline size of the alloy fibers are mainly influenced by the thermal reduction temperature and are in the range of 20 to 50 nm with a corresponding reduction temperature range of 300 to 700 ℃. The magnetic properties of the alloy fibers are largely affected by the carbon content and crystalline sizes of the alloy fibers. With increasing thermal reduction temperature, the coercivity decreases while the saturation magnetisation value of the alloy fibers dramatically increases at lower reduction temperatures. The alloy fibers prepared at reduction temperature of 700 ℃ have a saturation magnetisation value of 120 Am2/kg and a coercivity value of 10.4 kA/m, respectively.

结果表明：Fe0.13[Co20Ni80]0.87合金纤维的直径为0.3~2.0 μm，表面光滑、长径比大；组成合金纤维的晶粒大小与还原温度密切相关，当温度为300~700 ℃时，晶粒尺寸由约20 nm增加到约50 nm；该合金纤维显铁磁性，其矫顽力主要受合金中C含量及晶粒大小的影响，随制备温度的升高而降低；饱和磁化强度则主要与合金的组分相关，随还原温度的升高和合金纯度的提高而增大；经700 ℃热还原后，合金纤维的饱和磁化强度 m s为120 Am2/kg，矫顽力 H c为10.4 kA/m。

The results showed that for both of the alloys grains were obviously refined to same extent with increase in Ti content, and the grain sizes were coarsened to some extent due to evident fading of Ti effect during melt holding period....

随着保温时间的延长，所有合金的晶粒尺寸均不同程度发生了粗化，Ti对晶粒的细化效果明显发生了衰退。电解加钛铝合金晶粒细化效果的抗衰退能力优于熔配加钛铝合金，这种趋势对Ti的质量分数为 0 。1%～ 0 。2 %的合金特别明显。

The experimental results show that microwave sintering promotes the densification of green compacts with higher heating rate and reduced sintering cycle. The sintered relative density of 99.8% can be achieved during microwave processing under appropriate conditions. In addition, microwave sintering improves the uniformity and homogenization of W grain size, and yet leads to growth of W grain. Fe sintering aid degrades the microstructure uniformity and further coarsens W grains. The present investigation demonstrates the feasibility of applying microwave sintering technique to consolidate W-Cu composites and its promising outlook in reducing production cycle and cost.

结果表明：微波烧结升温速度快，周期短，能促进W-Cu材料的致密化；在适当条件下，微波烧结能获得相对密度达99.8%的W-Cu样品；微波烧结能改善W-Cu样品中两相分布的均匀性和W晶粒尺寸的一致性，但引起W晶粒的快速长大；Fe烧结助剂导致W-Cu材料显微组织均匀性变差，并引起晶粒进一步粗化；微波烧结技术能够应用于W-Cu材料的制备，在缩短生产周期、降低生产成本方面具有潜在优势。

The results show that some twin crystals and honeycomb structures appear in the shear plane and many kinds of deformation mechanism exist such as extruding, kinking and so on. When annealed at 550 ℃ for 2 h, the recrystal gains are observed in the shear plane. Especially the side receives the cut of guillotine, the size of recrystal grain is very thin, corresponding with the recrystal grains obtained by cold rolling at 80% deformation rate.

结果表明：经剪切变形后，切面处形成一种独特的带状变形孪晶和蜂窝状变形组织，且存在挤压、扭折等多种变形机制的作用；合金在550 ℃退火2 h后，切面出现许多再结晶晶粒，且在承受剪床切口的一边再结晶晶粒非常细小，相当于冷轧变形80%后的再结晶晶粒尺寸。

There is the same tendency between CGHAZ grain size and the distribution of temperature gradient. The tendency of temperature distribution has the great effect on distribution of the final grain size. The microstructures in HAZ by DC flash butt welding were discussed.

模拟结果还表明温度梯度造成的&热钉扎&现象对HAZ晶粒长大有明显的阻碍作用，CGHAZ晶粒的大小与温度梯度的分布具有相同的趋势，并对最终的晶粒大小分布有重要的影响。

Fancy gold-plated dangling earrings with facetted White Opal crystals.

花式镀金悬垂耳环与facetted白欧泊水晶。

This essay chooses the study aim from biology teachers in middle school in Shi Jiazhuang which tells us that most of the middle school biology teachers in Shi Jiazhuang have the"burnout", lower successfulness, individualize.

本文选取石家庄市初中生物教师作为研究对象，运用问卷调查的方法对石家庄市初中生物教师职业倦怠的现状进行调查，调查结果发现，石家庄市初中生物教师这一群体普遍存在职业倦怠，情感枯竭程度偏高，成就感偏低，去个性化程度最为严重。