晶体管

The limitation of power amplifier design in CMOS process is analyzed first. Then we construct and analyze the model of power transistor by using Matlab software.

首先分析了CMOS工艺对功率放大器设计的限制，然后使用Matlab对功放晶体管进行建模，分析其功率特性，通过仿真，提出了CMOS功率放大器的设计和调试方案。

A second development paralleling microprocessor advances was power metal-oxide semiconductor, field-effect transistor technology.

第二个发展并行微处理器的进展是电力金属氧化物半导体场效应晶体管的电源技术。

There is sufficient margin for a collector loss in a power transistor, and the high speed high fT transistor which was moreover excellent in the high region property is adopted.

的截止频率是90MHz的数量，并抑制这种晶体管的开关失真是无法避免公司一流的，而且，还实现了平坦的高区域相反应。

The harder you turn-on a power transistor, the longer it will take to turn off.

功率晶体管导通越快速，关断将越慢。

A novel zero-voltage and zero-current resonant pole soft-switching inverter was proposed to achieve zero- voltage and zero-current switching simultaneously when main power devices turn-on and turn-off. Therefore, turn-on capacitive losses could be reduced for devices which the intrinsic capacitor value cannot be neglected. Additionally losses caused by the tail current can also be reduced, when IGBTs are used as main switches.

提出一种新型的零电压零电流谐振极型软开关逆变器，可以在主功率器件开通和关断时，同时实现零电压和零电流，因此对于内部电容不能忽略的器件，可减小容性开通损耗，当绝缘栅双极型晶体管(insulated gate bipolar transistor，IGBT)作为主功率器件时，也可减小拖尾电流引起的损耗。

In this paper, common preamplifiers were introduced. To obtain the biggest output signal of the noise ration, we choose the low noise tube as the pre-amplifier according to best source resistance match principle.

本文以热释电探测器的前置放大电路为例，主要根据最佳源电阻匹配的原则选择低噪声晶体管，作为前置放大器，以得到最大的输出信噪比。

There are two Basic types Of distributor :(1) the type using contact points to close and open the coil primary circuit;(2) the type using a magnetic pick-up and a transistor; control unit to interrupt the current flow of the coil primary circuit.

分电器有两种基本形式：一种是使用触点关闭和接通初级线圈的电流，另一种使用磁传感器和晶体管控制装置来切断初级线圈的电流。

This process offers comparable performance to GaAs HBTs with the added advantages of mature and high producible Silicon wafer processing.

这一过程提供了性能与砷化镓异质结双极晶体管的成熟和高硅晶片加工可生产添加的优势。

As the design requirements of the voltage is not great, it can be enlarged and help drive push-pull switch transistor.

由于设计要求的电压不是很大，故可采用推挽放大又有利于驱动开关晶体管。

So we're going to use a little transistor radio and we're going to plug our connector from our transmitter into the radio...

现在，我们会用到一台小晶体管无线电并要将从传输器拉出的接头插入无线电中。。。

This paper discusses design and realizable methods of remote test output interface from logical design angle.

本文从逻辑设计的角度讨论遥测输出接口的设计及实现方法。

This also 星体投射plies to buildings, structures and geological features.

这也适用于建筑物和地质特征。