晶体管

In other words, transistor emitter current will closely equal diode current at any given time.

或者说，晶体管发射极电流随时都接近二极管电流。

The symbol for a PNP transistor has an arrow on the emitter indicating the diredtion of current flow, always towards the base.

PNP晶体管有一个表住在发射极的箭头符号用来指示电流的流向，总是围绕在基极的。

By means of the ballast effect of the vertical resistor of this non-crystalline Si layer, inject current crowding at emitter edge can be overcome.

与通常晶体管相比，FFJ的有效发射极面积对基极面积之比值提高2～3倍，输出功率-阻抗乘积提高5～10倍。

Following this rationale, if we were to hold the base-emitter voltage of a transistor constant, then its emitter current should likewise be constant, given a constant temperature

根据这个基本原理，如果我们能保持晶体管发射结电压恒定，当温度恒定时，发射极电流也将保持恒定。

Current flow between the emitter and base controls the current flow between the emitter and collector.the emitter of the transistor is the most heavily doped so it has the most excess electrons or holes.

由发射极到基极间的电流控制发射极到集电极间的电流，晶体管的发射极是重掺硅型的，所以它有过量的电子或空穴。练习翻译？遇到难题？快来翻吧

Note 4: Assumes that the external PNP pass transistor has negligible B-E reverse-leakage current when the emitter is biased at 0V and the base is biased at 4.2V.

注4：假设的外部PNP晶体管已经成为微不足道的反向漏电流时，发射器是在0V和有偏见的基础是偏颇于4.2V。

This constant emitter current, multiplied by a constant α ratio, gives a constant collector current through Rload, provided that there is enough battery voltage to keep the transistor in its active mode for any change in Rload's resistance.

这个恒定的发射极电流，乘以恒定的系数α，就得到流过负载Rload的恒定的集电极电流。前提是电池电压足够高，不论Rload如何变化，晶体管都能工作在放大区。

Issues added: GTO below the opening of the process and shutdown process: Located GTO anode forward voltage electric pressure, when the increase in positive gate trigger current IG, through N1P2N2 transistors amplification makes its collector current IC2 and emitter current IK increase.

问题补充：下面分析GTO的开通过程和关断过程：设GTO阳极电压力正向电压，当在门极加正向触发电流IG后，通过N1P2N2晶体管的放大作用使得其集电极电流IC2和发射极电流IK增加。

In the power supply circuit, series power supply and the adjustment of the series load, the load current flows through all of the adjustments, and transistors Guozainaili worse, once output overload or short circuit, the input voltage increases in the full set of adjustment an emitter, the current surge to adjust the fierce heat, if not over-current protection measures at this time, the adjustment will be burned, power Zhengliuguan also will be greatly threatened or damaged.

中文摘要：在稳压电源电路中，串联型稳压电源的调整管与负载串联，负载电流全部流经调整管，而晶体管的过载能力较差，一旦输出端过载或短路，输入电压全部加在调整管集---射极间，其电流剧增，使调整管猛烈发热，如果此时没有过流保护措施，调整管就要被烧坏，电源整流管也将受到巨大威胁或损坏。

In paper the phase noise L of the transistor is taked as function of Te, Re and R_(L1) for the first time, where Ie is emitter current, Re is resistor of emitter degeneration feedback and R_(L1) is aseismatic resistor on the collector.

文中得出了晶体管的发射极电流I_e、发射极反馈电阻R_e和集电极防振电阻R_(L1)与相位噪声L或Sφ

This paper discusses design and realizable methods of remote test output interface from logical design angle.

本文从逻辑设计的角度讨论遥测输出接口的设计及实现方法。

This also 星体投射plies to buildings, structures and geological features.

这也适用于建筑物和地质特征。