晶

The results show that the glass-ceramics with fibroid structure is produced after definite heat treatment, the main crystallization phase is hedenbergite and anorthite is the minor crystallization phase. The optimal process of heat treatment shows as follows: the nucleation temperature is 850 ℃ and hold time is 100 min, and the crystallization temperature is 980 ℃ and hold time is 80 min. With increasing heat treatment temperature, the FT-IR absorption bands appear obvious split, the aluminum-oxide polyhedron in the glass network changes from [AlO4] to [AlO6]. The titanium ion in the glass network gradually transforms to the 6-coordinated, moreover forms minicrystal of MgTi2O5 and Fe2TiO4 which provides the position of heterogeneous nucleation for the growth of crystal.

结果表明：在一定的热处理条件下可以以基础玻璃制备出主晶相为钙铁透辉石，次晶相为钙长石的纤维状结构的微晶玻璃；最佳的热处理工艺为：850 ℃核化100 min，980 ℃晶化80 min；随着热处理温度的升高，红外吸收带发生明显的分裂；玻璃结构中的[AlO4]向[AlO6]转化；网络结构中的钛离子逐渐转变为六配位，形成微晶相——钛酸镁和钛铁晶石，为晶体的生长提供非均匀形核位置。

Study on bond and diamond of diamond core drill bit for reinforced concrete;2. Also glass ceramic is used as the bond of CBN grinding wheel by examining the properties of new bond .

研究了微晶玻璃中加入低熔物、成核剂后对微晶玻璃热处理曲线、微晶量及微晶体尺寸的影响，并通过测试改性微晶玻璃的软化温度和热膨胀系数对CBN磨粒的把持强度，进而将微晶玻璃用作CBN砂轮结合剂的作用作了研究，经过在数控凸轮轴磨床上的试验证明，微晶玻璃结合剂的CBN砂轮的磨削效果很好。

Under the high frequency vibrating action, the crystal grain formed on the surface of the crystal nucleus eradiation equipment would be broken and peeled off, thereby ejected to zinc molten pool continuously and served as crystal nucleus source of equiaxed grain during solidification.

结果表明，当一种带有冷却结构且进行高频振动的晶核发射器插入锌液内时，锌液在晶核发射器表面迅速形核且长大，在高频振动作用下表面形成的晶粒将被折断剥离，从而连续不断地弹射到锌液中，成为凝固过程中形成大量等轴晶的晶核来源；采用带有水冷和气冷结构的晶核发射器对锌液进行振动激发形核处理后，锌凝固组织中的等轴晶率可分别提高到65%和80%。

Result The XRD peak of nano-crystalline was very wide at 350, 400 and 450℃, which indicated that its crystal form was indefinite form at those temperature. And the XRD peak of nano-crystalline was high and cuspate at 500, 600 and 700℃.

结果］在350、400和450℃时纳米晶的XRD峰非常宽，说明此温度下其晶型为不定型；在500、600和700℃时纳米晶的XRD峰高而尖；EuTiNiO4Cl纳米晶的粒径随温度的升高而增大，其晶型由不定型变为多晶型。

The Si/Al ratio of NaY molecular sieve was determined by an empirical formula of lattice constant obtained by extension function method of X-ray diffraction and framework Si/Al ratio of NaY molecular sieve determined by solid nuclear magnetic resonant spectrum method.

前言晶胞参数是决定晶体结构的重要参数之一，Na Y超稳分子筛属立方晶系，由于 Na Y超稳分子筛骨架硅铝比受许多条件的影响，如投料比、晶化温度、晶化压力和晶化时间等。通过研究发现分子筛骨架的硅铝比与其晶胞参数相关，而分子筛的硅铝比可作为合成分子筛产品质量的控制指标 [1] 。

In the present paper, two new hypotheses are proposed that the outward normal of the dendrite surface is parallel to the gradient of the actual supercooling, and that the dendrite growth is capable to minimize the solute transfer .

但是，以往的研究中，枝晶组织和枝晶生长这两个密切相关的问题一直被分隔开来进行研究；在稳态枝晶生长理论研究中，由于枝晶界面真实形状问题没能解决，迄今为止，比较有希望的理论模型都是建立在"枝晶界面的旋转抛物面假设"这样一个早已被认定不是枝晶界面真实形状的"基础"上。

The results point out that the values of kinetic parameters are altered with the addition of Ti and C, which change the crystallization type from difficult nucleation and easy growth pattern to easy nucleation and difficult growth pattern, and this difficult nucleation and easy growth pattern may be the main reason why fine and even microstructure is gained in Ti and C doped alloys.The influences of Nd content, B content, partial substitution of Nd by Pr on the microstructure and magnetic properties have also been researched.

文章从动力学理论的观点揭示了合金显微结构与合金晶化动力学特性之间的关系，指出Ti和C添加改变了Nd9.4Fe79.6B11合金晶相析出时的动力学参量值，使合金晶化时晶相的析出方式由难形核易长大型加热管转变为易形核难长大型，这种易形核而难长大的晶化动力学特征，是Ti和C添加合金获得细小均匀的纳米晶结构的根本原因。

If θ=0?＃, it means that whisker axis is perpendicular to crack face, the energy dissipation caused by whisker-bridge join in zone of crack end achieves its maximum and the reintoughening effect of material achieves the best of all; along with growth of angle θ, the maximum principal stress in the matrix of whisker roots increases, when it achieves its limit, the whisker will be broken and orientation effect will be weakened.

当添加晶须与裂纹面法向形成角度θ时，随角度θ的增加，裂纹尖端拉应力增加。当添加角度较大时，晶须根部基体承受了较大的应力，易遭到破坏性崩裂。同时，晶须内部主应力与晶须轴向之间的角度也随角度θ的增加而增加，造成晶须折断，致使造成晶须拨出的体积分数φap减小，降低了增韧效果。

The crystal-lization of this amorphous alloy is a multi-stage continuous nucleation up to saturation process. The local crystallization energy decreases gradually indicating that the thermal stability of the residual amorphous matrix becomes weak at the steady crystallization stage, which is ascribed to the diffusion of boron atoms at elevated temperatures.

进一步研究发现，该非晶合金的晶化为多阶段的连续形核直至饱和的过程；当进入稳定晶化阶段时，剩余非晶的局域晶化激活能逐渐下降，非晶基体的热稳定性降低，这是由B原子的高温扩散导致的。

Microscopic characteristics of cladded crystal fiber are analyzed by X-ray diffraction, Laue X-ray diffraction and scanning electron microscopy, it is found that magnesium-ion indiffusion does not affect the single crystal structure and the domain structure of the magnesium diffused crystal fiber. It is found for the first time that MgO-rich layer in the magnesium diffused LiNbO〓 surface layer exhibits the crystal structure of an unknown compound from the Li-Mg-Nb-O ternary system and MgNb〓O〓. It is proposed for the first time that this unknown compound and MgNb〓O〓 in MgO-rich layer are the real sources of magnesium-ion indiffusion LiNbO〓. Their appearance indicate that MgNb〓O〓 is in the surface layer of MgO-rich layer, the unknown compound is in the subsurface layer and beneath where the MgNb〓O〓 is located, and these compounds have obviously preferred orientation.

通过镁离子内扩散法，首次在国内实现了具有阶跃和抛物折射率分布的c轴LiNbO〓单晶光纤和a轴Nd：MgO：LiNbO〓单晶光纤的芯—包层波导结构，为我国在该项目的研究填补了空白；建立了晶纤损耗的测量系统，提出了利用单模石英光纤作为晶纤入射光耦合器的思想；通过对晶纤损耗的测量，得到了包层晶纤比未包层晶纤损耗降低约14倍的好结果，并实现了低次模传输：对经镁离子内扩散实现包层后的晶纤的微观特性，利用X射线衍射，劳厄照相和扫描电镜表征发现，晶纤并不因镁离子的内扩散而影响其单晶结构和镁的扩散层畴的变化。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。