显露

It is found that from bond population calculation results, the bonding strength of Al—O bond of faces (011) and (011) of gibbsite are stronger than that of face (001). If the proportion of unfold of (001) surface is decreased and the proportion of unfold of (011) and (011) surfaces is increased to same possible extend, the bonding strength of Al—O bond of gibbsite would be more strong.

键布居分析结果表明，整体上氢氧化铝的(001)面的Al—O键的结合力不强，(011)和(110)面的Al—O键的平均键布居数较高，结合力较强；若小幅度降低(001)面的显露比例，并使(110)和(011)面较多显露，就有可能提高氢氧化铝表面的Al—O键的结合力。

The wrath of God is being revealed from heaven against all the godlessness and wickedness of men who suppress the truth by their wickedness,Romans1:18-32

神的震怒，从天上向所有不虔不义的人显露出来，就是向那些以不义压制真理的人显露出来。罗马书1：18-32

In Hangchow it has four generations each year and the time of its occurrence is well synchronized with that of the scale.

根据测定，隐斑瓢虫对日本松干蚧各虫态的捕食能力较强，一头成虫的日平均捕食量为：显露若虫13.33头，雌成虫4.27头，卵囊3.67个(每个卵囊内平均有卵265.5粒)，雄蛹28.27只；一头幼虫全期(或2—4龄和3—4龄)分别能捕食显露若虫39.20—105.56头，雌成虫40.80—47.79头，卵囊39.38—41.79个，雄蛹220.50只。

This said, he sat; and expectation held His look suspence, awaiting who appeer'd To second, or oppose, or undertake The perilous attempt; but all sat mute, [ 420 ] Pondering the danger with deep thoughts; and each In others count'nance read his own dismay Astonisht: none among the choice and prime Of those Heav'n-warring Champions could be found So hardie as to proffer or accept [ 425 ] Alone the dreadful voyage; till at last Satan, whom now transcendent glory rais'd Above his fellows, with Monarchal pride Conscious of highest worth, unmov'd thus spake.

V1：一席话说完，他坐下，眼光里显露期待的神情，等待众人的赞成或反对，或起而表示自己甘冒风险一试。可是大家都默坐，相视无言，思虑那危险而面面相觑，各从别人的脸上照出自己的心惊胆战。就是在天战中最勇敢的精英，也没有一个自告奋勇承担起这个可怕的远征。直到最后，撒旦，那时他的荣光超群，自恃力量最大，俨有寡君的骄矜，神态自若地开口说道： V2：这样说后，他坐下，眼光里显露期待的神情，等待谁来赞成，或反对，或起而表示自己甘冒风险一试。可是大家都默坐，噤若寒蝉，沉思那危险而面面相觑，各从别人的脸上照出自己的心惊胆战。就是在天战中最勇敢的精英，也没有一个自告奋勇敢于承担这个可怕的远征。

It only needs the laminectomy of L1 and a 6cm incision on the skin to expose the operative region.

仅处理L1椎板即可满意显露所需处理的神经根。6 cm皮肤切口即可达显露要求。

Based on the retrosigmoid approach, the suprameatal tubercle and partial petrosal apex were drilled. The CT and the manual measurements were used for determining the extension of the suprameatal tubercle and petrosal apex in three dimensions before and after the resection of them. The exposed field of the middle fossa and superior clivus and the length of the exposed trigeminal nerve were also measured.

经乙状窦后入路开颅，磨除内耳道上结节和部分岩尖，采用实体和CT相结合的方法测量内耳道上结节、岩尖的切除范围，记录内耳道上结节、岩尖切除前后颅中窝、上斜坡的显露面积和三叉神经的显露范围。

The petrosal apex could be only partially resected.

颅中窝扩大显露范围为（144.6 ± 13.9） mm2，上斜坡扩大显露（90.3 ± 16.7） mm2。

The splenius capitis muscles and upper part of semispinalis capitis muscle was exposured while preserving a cuff of the formers upper attachments for closure, and reflecting them medially exposes the longissimus capitis muscle and semispinalis capitis muscle.

并显露枕下三角，枕下三角由三条肌肉围成：上内侧为头后大直肌，上外侧为上斜肌，下外侧为下斜肌。开放枕下三角，完整显露颅颈交界区的骨性结构。

Objective General evaluation of the degree of exposure and damage to the cerebellopontine angle region by the postlabyrithine approach and suboccipital retrosigmoid approach, being familiar with anatomic structure of this region and providing theory reference for the choice of the clinical operative approach.

方法在显微镜下对5例(10侧)国人成人头颅灌注湿性标本进行模拟经迷路后入路和经枕下乙状窦后入路的手术操作，观察区域解剖结构、按Ammirat标准进行评价两种入路对桥小脑角区的显露程度，测量并用Horgan法计算出显露面积，并按损伤程度的评分评价两入路对桥小脑角区的损伤程度。

Methods The clinical data of 810 cases of thyroid operation in which the RLN was exposed in 252 cases and was unexposed in 558 cases were analyzed.

分析810例甲状腺手术中252例甲状腺手术中显露RLN和558例术中未显露RLN患者的临床资料。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。