显微镜的

Method］osteoarthritis condyles of femur (n=21) were collected from knee joint replacement and the paraffin sections were prepared after fixation and decalcification.after stained with safranin o/fast green, the shape structure of calcified cartilage zone was observed by microscope.

方法］标本均来源于临床诊断为膝关节退行性骨关节炎患者，共21例，其中，男1例，女20例。股骨髁负重区取材、修剪、固定后，常规制备石蜡切片，番红o／固绿染色，显微镜观察。［结果］本研究收集的标本平均年龄

The effect of scandium addition on microstructure and corrosion properties of Al-5.3Cu-0.8Mg-0.6Ag-0.2Zr alloy was investigated using optical microscope, scanning electron microscope, transmission electron microscope, intergranular corrosion and exfoliation corrosion.

通过金相显微镜、扫描电镜、透射电镜、晶间腐蚀及剥落腐蚀等实验方法，研究钪对Al-5.3Cu-0.8Mg-0.6Ag合金的组织和腐蚀性能影响。

A measurement system with He-Ne laser scattered light was set up to detect the laser-induced damage threshold of optical thin films.

目前国内外检测激光损伤的主要判定方法有相衬显微镜观测法[4]、等离子体闪光法[5]、光热偏转法[6]等。

The irritated sclera was observed by light microscopy and scanning electron microscopy.

应用光学显微镜和扫描电镜观察激光作用后巩膜的形态学变化，并用Nd：YAG激光作为对比。

METHODS: The rib trabeculae were resected and broken, trypsinizated and washed completely by PBS. Bone surface and non-adhesive floating cells in cleaning fluid were observed with inverted microscope. Rib trabeculae was washed by DMEM culture medium once, and cultured in culture bottle. The culture liquid was replaced by new one once a week. The osteoblast was moved from the sclerite a week later. The cells were fused monolayer and could be subcultured 4 to 6 weeks later.

切下人肋骨骨小梁剪碎，胰酶消化后以PBS彻底冲洗直至于倒置显微镜下观察骨片表面及清洗液中无粘着及漂浮的细胞，以DMEM完全培养液清洗骨小梁1次，移入培养瓶内培养，每周更换培养液1次，1周后可见成骨细胞自骨片移出，4~6周细胞融合成单层可作传代培养。

By means of the scanning electron microscope and the Shore sclerometer, the microstructure and the Shore hardness of the materials were analyzed.

本文采用扫描电子显微镜、肖氏硬度计对碳/碳复合材料的表面微观形貌及显微硬度进行观察和测定。

There are sound physical and chemical inspection equipment, optical microscope, universal test machine, desktop sclerometer.

还有完善的理化检验设备，金相显微镜、万能性试验机、台式硬度计。

The microstructure, mechanical properties and hardness of Mg-2% Mn-x%Y alloy were analyzed by optical microscope, mechanical apparatus and sclerometer.

用光学显微镜、力学万能试验机和显微硬度仪等分析了Mg-2% Mn-x% Y合金的显微组织和力学性能。

The effects of common heat treatment and cryogenic treatment on microstructure and mechanical properties of 3Cr13 steel were studied using a SLX-30 cryogenic box with program control, and metallography microscope, SEM and HRC sclerometer.

利用SLX-30程序控制深冷箱、金相显微镜、扫描电镜和洛氏硬度计，研究了刀剪材料3Cr13钢经普通热处理、深冷处理后的微观组织及力学性能变化。

Rarely, a sample of skin scrapings or a small sample of skin will be sent to the laboratory for examination under a microscope.

很少，样本皮肤scrapings或小样本的皮肤将被送到实验室检验在显微镜下观察。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。