显微镜的

Objective To evaluate the value of ultrasound biomicroscope in the diagnosis of retinal detachment.

目的 评价超声生物显微镜在视网膜脱离诊断中的价值。

The microstructure of studied alloy was observed by scanning electron microscope and optical microscope and the mechanical, dezincification and cutting properties were studied.

利用扫描电镜、光学显微镜等手段对易切削黄铜的微观组织进行观察分析，并对其力学、脱锌和切削性能进行研究。

After developing 48 hours, hepatocytes enters 2.0 mM t-butyl hydroperxide or 2.0 mM diamide to induced cell blebbing. The samples collected at 0, 15, 30, 60 minutes to analyze cell about membrane protein thiol deletion; the leakage of lactate dehydrodenase; the change of glutathione; the lipid peroxidation; the variation of actin and tubulin, and use Confocal fluorescent microscope to observe the change of actin and tubulin in rat hepatocytes.

肝细胞在48小时培养后，分别加入2.0mM t-buty1 hydroperoxide或2.0 mM diamide诱发细胞膜小泡生成，并分别於0、15、30、60分钟取样，分析细胞膜硫醇流失程度；乳酸去氢□渗漏；□胱甘□浓度变化；脂质过氧化；肌动蛋白与管蛋白变化；并利用雷射共轭焦萤光显微镜观察肝细胞中肌动蛋白及管蛋白的变化。

The structure and morphology of the composites were investigated by X-ray diffraction and scanning electron microscopy.

利用X射线衍射和电子扫描显微镜对共聚物复合材料的结构和形貌进行了分析和表征。

The surface morphology and microstructure of products was characterized by scanning electron microscope and X-ray diffraction.

利用扫描电子显微镜和X射线衍射对样品的表面形貌和微结构进行了分析表征。

The phase compositions and the microstructures of the samples were investigated by an X-ray diffractometer and a scanning electron microscope, respectively.

利用X射线衍射仪和扫描电子显微镜分别对试样的相组成和显微结构进行分析。

The microstructure, magnetic properties, and surface image of samples have been measured and analyzed by X-ray diffractometer and vibrating sample magnetometer and atomic force microscope.

样品的结构、磁性及表面形貌分别用X射线衍射仪、振动样品磁强计和原子力显微镜进行了表征。

The histopathological changes were evaluated through light microscope after disarticulation sections H.E.

组织病理学上的变化则经膝关节切片后以伊红性洋苏木素染色於光学显微镜下观察。

These are simple microscopes, consisting of one lens only and intended mainly for dissecting work.

这是一台简单的显微镜；只有一个透镜，主要用于解剖工作。

Analyzing the causes of surface crack of GCr15 bearing steel wire with metallurgical microscope, Brinell and Vickers Durometer, the result shows that the surface of wire rods has no crack, which comes from the course of drawing .

运用金相显微镜、布维氏硬度仪等分析手段，对GCr15轴承钢盘条经拉拔成钢丝后成品表面产生间断裂纹进行分析，结果表明盘条表面无裂纹，成品钢丝的裂纹主要产生于拉拔工艺过程。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。