时

Results In the condition of obturation and humidity, Neisseria gonorrhoeae in the leucorrheas survived longer in middle quantity than in few and mass. The survival time of Neisseria gonorrhoeae was short in dryness. In a few quantity (10/ml), karyote could phagocytize Neisseria gonorrhoeae and shorten its survival time, but in the quantity above 300/ml, karyote could prolong its survival time.

结果 在密闭保湿状况下，白带标本中的淋球菌在中量时存活时间长，少量或大量时其存活力相对较低；在干燥状况下，淋球菌存活时间短；在菌量很少(10/ml)时，有核细胞可以吞噬淋球菌而导致淋球菌存活时间减少，但在菌量较多时（大于300/ml）时，有核细胞可以延长淋球菌存活时间。

The guaranteed cost controller design problem of the systems with time-varying uncertain networked-induced delay and polytopic uncertainties was studied.

针对一类具有时变网络诱导时延的不确定网络控制系统，研究了一种可以对时变时延进行补偿的保性能控制器的设计问题。

The guaranteed cost controller design problem of the systems with timevarying uncertain networkedinduced delay and polytopic uncertainties was studied.

针对一类具有时变网络诱导时延的不确定网络控制系统，研究了一种可以对时变时延进行补偿的保性能控制器的设计问题。

Methods:The RP-HPLC method was applied and protocatechuic aldehyde was used as the internal standard substance.

采用RP-HPLC法，以原儿茶醛为内参照物，色谱柱：Luna C_(18)柱(250mm×4.6mm，5μm)，流动相：0.05%磷酸水溶液-乙腈，梯度洗脱程序为：0min时A-B(100∶0)，80min时A-B(67∶33)，85min时A-B(60∶40)，100min时A-B(60∶40)，流速：1.0mL·min~(-1)，检测波长：280nm。

The 352 valid samples were analyzed by SPSS. The results showed there was no distinct corresponding relationship between the product attributes and reaction time. The different key attributes from questionnaire importance rating and the shortest reaction time standards were used to regressively analyze the results of customers' overall rating (such as overall satisfaction,objective quality, recommend intention).The results indicated that the coefficiency of regression of the special attributes chosen from reaction time to overall rating was distinct, while the coefficiency of the special attributes chosen from importance rating to overall rating was not. The main conclusions are: 1. Regarded attributes can be obtained by the reaction time of brand performance rating.

本实验的有效样本为352个，通过SPSS软件进行分析统计，数据统计结果显示，在品牌表现评价反应时与其重要性问卷评定结果的相关系数的检验中，并未发现品牌表现评价反应时与品牌属性重要性评定结果之间的显著相关；将由问卷重要性评价最高标准所得到的关键属性与通过品牌表现评价反应时最短的标准所选取的关键属性的品牌表现分别对消费者的总体评价结果（如&总体满意度&、&主观质量&、&推荐意向&）进行回归分析，发现通过品牌表现评价反应时方法选取的特殊关键属性（与问卷重要性评定法选取不一致的关键属性）的品牌表现对总体评价结果的回归系数显著，而重要性评定问卷法选取的特殊关键属性（与品牌表现评价反应时法选取的不一致的关键属性）的品牌表现对总体评价结果回归系数不显著。

The calculation results shows that ,(1) when the rotor rotates at the working speed, a local regurgitant whirlpool that is rightabout to the rotor"s rotating direction appears in the classifying region, which makes the separated granules come back to the outside of the classification district and influences the classification efficiency of the turbine classifier;(2) in the condition of a low rotating speed of turbo rotor, ultrafine particles can follow the gas phase by and large, but when the rotating speed increases, a phenomenon of velocity slippage between two phases appears evidently;(3) A operating parameter, air flow rate is so important that can directly influence the stability of flow field in classifying chamber, the bigger the air flowrate is , the steadier the flow field is;(4) Compared with straight blades, the new shape of blades with backward crooked elbow are helpful to improve the stability of flow field and form whole stream easily, also beneficial to advance the classification accuracy and classification efficiency;(5) The motion trace of particles are very complicated when the turbo rotor rotates at a high speed, the constant bounce of the particles appear between the blades and the coarse particles are even bounce back from the inlet, only the finer can pass through the classification area from the oulet;(6) Along with the increase of the rotor"s rotating speed, radiah axial and tangential velocity all begain to fluctuate repetitively like sine-wave, the smaller the particles are, the more violently they fluctuates.

数值模拟结果表明，(1)在涡轮达到工作转速时，在分级区域形成了一个与涡轮旋转方向相反的局部回流涡，它使得分离出来的细粒重又被带回分级轮外边缘，从而严重影响分级机的分级效率；(2)粉尘粒子在涡轮低速运动情况下，基本上能跟随气体运动，但随着转速加大，两相之间出现了明显的速度滑移现象；(3)分级机工作时的风量也是一个比较重要的操作参数，它可以直接影响到分级机内腔流场的稳定性，风量越大，流场越稳定；(4)同直叶片形状相比较，带后弯导板的叶片，有利于改善流场的稳定性，流场容易形成整体流，对提高分级效率和分级精度都非常有利；(5)粒子轨迹线在涡轮转速较高时十分复杂，有的出现了反复的弹跳现象，大颗粒不能通过分级区域而从进口返流了，只有细小的颗粒才从出口处流出；(6)涡轮转速加大时，粒子的径向、轴向和切向速率出现了明显的类似于正弦波的脉动现象，颗粒越小，脉动程度越为剧烈。

During open/close movement, the distance of condylar movement is smaller than normal occlusion(P.05). During protrusion/retrusion movement, protrusion extent increase,the distance of condylar movement is bigger than normal occlusion(P.05). During lateral excursion, the trace in sagittal plane of the non-working side condyle is more incline than protrusion movement trace and the distance of the left non-working side condylar movement is larger than the right. During mediotrusion/right movement, the left biggest space distance is larger than normal occlusion and the transversal condylar inclination is smallar than normal occlusion when the distance of condylar movement is 5mm, the difference is statistically significant.

在开闭口运动时，双侧髁突运动幅度减小、位移量小于正常牙合者(P.05)；前伸后退运动时，前伸幅度增加，位移量大于正常牙合者(P.05)；侧方运动时，非工作侧髁突在矢状面上的轨迹较前伸轨迹向前下方倾斜度增加，非工作侧髁突空间位移左侧大于右侧，向右侧方运动中，左侧髁突空间位移大于正常牙合者，髁突位移5mm时水平面髁突倾斜度小于正常牙合者，差异有统计学意义。

When pump starts, the lower impeller lifts the solution up step by step. And the extreme centrifugal force from the enlarged higher impeller stops the solution as it entering the higher impellr. At the same time, the full solution in the chamber stops the air mixed with the solution in the chamber to go down. This way masterly eliminates both big problems of vertical sealless pump, overflow at high pressure and bubbles at big flow.

塑宝SV泵剖面结构SV Super Series Analytical cross section SV泵剖面结构泵开始运转时，底部叶轮将液体逐步上推，待液体进入上部叶轮时，即受加大之背叶的强大阻力而无法上升，但上部叶轮所卷入液体中的空气，却受阻於水室中贮满的液体而无法下降，如此巧妙地排除了立式无轴封泵高压时溢流，或大流量时吸入空气的两大难题。

Some states could formulate domestic conflict of law meets the gauge settledly when assigns based on the conflict law to be suitable a national the law, when the solution of conflict of laws changes according to around the law respective country related law, this conflict of law center applicable law and according to law vassal state solution when has the possibility not to be inconsistent with the interregional conflict of laws, so it possibly produces one new kind "the conflict of norms"- conflict of lawsof the court country and the intertemporal conflict of laws of the state which the applicable belongs to.

有的国家在制定国内冲突法时会规定当依据冲突法指定适用一个国家的法律时，当解决法律冲突适用准据法所属国家的相关法律前后发生变化时，该冲突法中的适用规则和准据法所属国解决时际法律冲突的规则就有可能不一致，这样就可能产生一种新的&法律冲突&——法院地国冲突法和准据法所属国时际私法之间的矛盾。

The correct rates and the mean response latencies were subjected to ANOVA with repeated measures. Result:In both supraliminal and subliminal affective priming tasks, the mean response latencies were significantly longer for affectively incongruent trials, as compared to those for affectively congruent and control trials. The correct rates for affectively incongruent trials were the lowest.Subjects were relatively slower to respond to positive target pictures than to negative target pictures(96.9%/95.3%,97.6%/95.8%).In subliminal affective priming task, there were no differences of correct rates and latencies between alexithymics and nonalexithymics. In supraliminal priming task, the latency of alexithymics was longer than that of nonalexithymics (536.3ms/496.4ms).

结果：在阈下和阈上启动任务中的正确率，情绪启动状态的主效应均显著（F=14.38，P=0.000，F=3.28，P=0.042），启动和控制状态的反应正确率均高于非启动状态（阈上：启动状态97.3%/非启动状态96.1%，阈下：启动状态96.8%，控制状态96.8%，非启动状态94.7%），而启动状态的平均反应时则均短于非启动状态（阈下：启动，537.2ms；控制，550.8ms；非启动598.4ms；受试对负性图片的反应正确率显著高于正性图片（如阈下：96.9%/95.3%，阈上：97.6%/95.8%，对负性图片平均反应时显著短于正性目标图片；在阈下启动任务中，述情障碍组与非述情障碍组在正确率和平均反应时上均无显著性差异；在阈上启动任务中，述情障碍组的平均反应时显著长于非述情障碍组（536.3ms/494.4ms）。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。