时

Reducing afterblowing and using the carburant with low nitrogen content are important measure. The kinetics of nitrogen removal from liquid steel under vacuum with reaction between carbon and oxygen was studied on the multi-function induction furnace. The following conclusions were obtained by experiments: The nitrogen removal was obtained by the nitrogen transfer through the liquid steel diffusion layer at 67Pa and 110Pa pressure, and by the gas-liquid surface chemical reaction at 2000P.

结果表明：真空度对脱氮机理有影响，67Pa～110Pa时脱氮为一级反应，2000Pa时脱氮为二级反应，1340Pa时为混合控制；即使在。1％的条件下，碳氧反应亦可显著提高脱氮速度常数促进深脱氮，在RH内通过加强碳氧反应来提高脱氮率理论上是可行的；当钢液内存在内生或外来固态粒子时，有利于钢液中CO及N〓气泡的形成及排除，这时气泡内p〓≈0，有可能使钢液中氮含量低干与系统真空度平衡的氮含量。

The hydrolysis yield of bleached pulp was lower than that of unbleached pulp under similar optimum conditions. Cellobiose concentration decreased during hydrolysis from 7.95 to 2.44g/L and from 6.59 to 3.11g/L at 6h and 72h for unbleached and bleached pulp, respectively.

水解产生的纤维二糖的质量浓度随反应进行逐渐降低，其中未漂浆的纤维二糖质量浓度由6h时的7.95g/L降到了72h时的2.44g/L，漂白浆的纤维二糖质量浓度由6h时的6.59g/L降到了72h时的

This course will mainly discuss on time-domain analysis and frequency-domain analysis of determined signal, description and characteristic of linear time-invariant system, as well as time-domain analysis and transformation domain analysis of signal via linear time-invariant system.

本课程主要讨论确定性信号的时域和频域分析，线性时不变系统的描述与特性，以及信号通过线性时不变系统的时域分析与变换域分析。

Influence of dry or wet bonding on microleakage of Ti alloy inlay;2. Influence of dry or wet dentin bonding surface on wet bonding strength: a microtensile study;3. To study the microstructural influence of dry or wet dentin bondin g surface on the dentin bonding interface, five wet bonding systems were used to bond Chrisma B20 resin with dry or moist dentin surface with scanning electron m icroscope.

结果湿粘结时5种粘结系统在粘结界面获得良好的渗透图象；干燥粘结时，两种以丙酮为溶剂的粘结系统在干燥粘结时形成的粘结界面，与湿粘结时有明显的区别，混合层较薄，并有明显的不完全渗透的结构和混杂层的形成；以酒精和水为溶剂的粘结系统在两种不同粘结状态时粘结界面的超微结构没有明显的区别。

Results:In ischemia group, the peaks of MPO activity and CINC conentr ation were 24 hour and 6 hour respectively after ischemia, which initially incre ased at 1 hour, In ischemia reperfusion group, the peaks of MPO activity and CIN C conentration were 72 hour and 6 hour respectively after ischemia reperfusion, which initially increased at 6 hour and 1hour down to normal at 24hour respectiv ely.

结果：单纯缺血组MPO活性增高始于缺血6h并于缺血72h时达高峰，为0.15±0.01U/ml； CINC水平增高始于缺血1h，缺血6h时达高峰，为0.05±0.05ng/ml，以后逐渐下降并于缺血48h后恢复正常。缺血1小时再灌注组MPO活性增高始于再灌注1h并于再灌注24h时达高峰，为0.42 ±0.12U/ml；CINC水平增高始于再灌注1h，再灌注3h时达高峰，为0.65±0.03ng/ml，以后逐渐下降并于再灌注24h后恢复正常。

Compared with the FFT-based computation to CAF, the presented method can scan the target only in certain circular sector instead of the whole ambiguity plane, which may decrease the computational load.

与基于FFT计算互模糊函数的方法相比，采用这种方法的优点是在检测目标时可以只扫描某个环形扇区而不用计算整个模糊平面，减小了计算量；另外，由于在计算互模糊函数时极角和极径的取样间隔可以任意选择，突破了时域采样间隔的限制，可在时延和频移上均得到高精度估计。

Otherwise, When ambient temperature falls, the pressure of the SF6 gas decreases, drives the indicator counter the clockwise rotation, but at the same time, the mouth of the bimetal compensation system "the U shape" reduces, then impels the indicator to along the clockwise rotation, when two kind of strength be equilibrium, the ambient tempera

反之，当环境温度下降时，虽然容器内SF6 气体的密度未发生变化但其压力减小，带动指针向逆时方向转动，而当温度下降时，双金属补偿装置的"U 形"口缩小，则推动指针向顺时针方向转动，当两种可运动个起表针的偏转量相抵销时，无论环境温度如何变化，指针都不会发生偏转。

This invention relates to one MIMO-OFDM system simultaneous method, which comprises the following steps: a, processing relative computation by received local sequence and local ones to get relative peak and its side; b, processing filter on peak value and sides through one degree impact without limit; c, in the non integral digital sampling, the said peak value and its side are ordered to keep their position as time lag information; d, in the integral code sampling, it orders the peak value and its side and removes the sides and keeps relative peak position as time lag position to realize the simultaneous process.

本发明公开了一种MIMO-OFDM系统的同步方法，所述方法包括步骤：(1)将本地序列与接收到的序列进行相关运算，得到相关峰值及其旁瓣；(2)将所述相关峰值及其旁瓣通过一阶无限冲击响应数字滤波器进行滤波；(3)当所述MIMO-OFDM系统处于非整数倍码片抽样时，对所述相关峰值及其旁瓣进行排序，保留相关峰值及其旁瓣相应位置作为时延位置信息；(4)当所述MIMO-OFDM系统处于整数倍码片抽样时，对所述相关峰值及其旁瓣进行排序，并去除相关峰值旁瓣，保留相关峰值位置作为时延位置信息，从而实现同步。

Results KoA for urea varied with dialyzer model, but the effect of Qb, Qd. Urea KoA did not change significantly when Qb increased from 300 to 500 ml/min at Qd of 500, 800 and 1000 ml/min.

结果 透析液流量保持恒定时（分别为500，800，1000 ml/min），尿素KoA在血流量从300增加到400，500 ml/min时，KoA并不增加；但在血流量保持恒定时（分别为300，400，500 ml/min），尿素KoA在透析液流量从500增加到800，1000ml/min时，尿素KoA显著增加。

In order to testify our whether correction to Rossi's exchange term andthe potential of electron and nucleus is reasonable, we calculate 〓 moleculeelastic differential scattering cross section by electron impact on 100eV, ourresult is obviously better than Rossi's. Then we calculate elastic differentialscattering cross section at 150eV. In order to check the program thatcalculates molecule excitation cross section by electron impact, we calculatehydrogen excitation cross section from ground state to 〓 state at 20eVand 30eV, oxygen excitation cross section from ground state to 〓 state at15eV and 20eV. These calculations are in agreement with other theoreticresults, and experiment measure. Finally, we calculate sulfur moleculeexcitation〓 cross section by electron impact at5eV,7eV,9eV, 11eV, 13eV,15eV, and draw curve of excitation total crosssection corresponding to incident electron energy.

为了核对我们修改的计算激发态的程序是否正确，计算了电子与氢分子碰撞从基态激发到〓态入射能量分别为20eV和30eV时的微分截面以及电子与氧分子碰撞从基态激发到〓态入射能量分别为15eV和20eV时的微分截面，与别人的理论计算结果、实验的测量值基本一致，最后计算了电子与硫分子在5eV、7eV、9eV、11eV、13eV、15eV时的碰撞激发〓截面，作出了电子的入射能量与激发总截面的关系曲线，找出了总截面最大时对应的电子入射能量大约是11电子伏。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。