时...时...

Two cylinders drive the tipping unit, loading the bars; one asynchronous motor drives chain motion mechanism, implementing the feed and back off movement of bars; bar lifting movement in the process of chamfering and blanking movement after machining are carried out by another two cylinders; one asynchronous motor rotates the bar and one cylinder swings the wheel head when grinding; the feeding of the wheel head is accomp...

它通过控制两套汽缸驱动翻爪完成上料，一台异步电动机驱动链条式多轮运动机构完成磨削前的进料和磨削后的退料，两套汽缸完成磨削倒角加工时的预料和加工完成后的落料，一台异步电机在磨削加工时驱动棒料旋转，一个汽缸驱动磨头在加工时摆动，一台步进电机驱动磨头实现磨削进给，两套汽缸驱动翻爪完成下料，而磨头是用一台异步电机驱动砂轮旋转的机构，并给出了控制系统原理图及程序流程图，解决了控制器输入点数相对不足的技术问题。

6 Batteries, as described in 4.25.10, and battery chargers.(1) Battery connectors must be constructed of material with a V-0 flame rating or have a glow wire ignition rating of 750°C.(2) The battery charging system shall not present a risk of fire due to a short-circuit condition applied to any point in the length of a charger/battery interconnecting cable when tested inaccordance with 8.19.7.(3) During charging, battery-charging voltages shall not exceed the recommended charging voltages when tested in accordance with 8.19.6.(4) Battery chargers must be certified to the appropriate current national standard, for example UL, CSA, or equivalent standards body. 8.19.6 Battery Overcharge Test—Each battery shall be charged with its intended charger continuously for 336 h. The test shall not result in the release of electrolyte, or cause explosion or fire. 8.19.6.1 If the battery can be charged in the vehicle, place the battery in the vehicle and connect it to the charging circuit. Drape the charger, cable, and battery with a double layer of cheesecloth. The test shall not result in ignition of the cheesecloth or in the release of electrolyte.

4.25.10.6 电池(如4.25.10中的描述)和充电器(1)电池的连接器必须是使用UL94V0防火等级的材料做成的，或使用燃点为750度的发热线(2)按照8.19.7测试时，当在充电器和电池间的导线上的任意一点发生短路时，电池充电系统不允许出现着火的危险(3)充电时，按照8.19.6的测试方法，充电电压不允许超过推荐的充电电压(4)电池充电器必须通过相应的现行国家标准的认证，比如UL，CSA或等同的标准机构 8.19.6电池过充测试---每个电池都需要采用其默认的充电器连续充电336小时，测试不允许导致电极的泄露，导致爆炸或火灾 8.19.6.1若电池可以在交通工具上使用时，将电池放到交通工具上，并将之与充电电路连接起来，用双层粗棉布将充电器，连接线和电池遮挡起来。

This was because its flow velocity changed little in direction than the other one. However, the Z-like tube was a little better than the U-like tube when without blowing.

结果表明：不吹气时，管道结构对流场的影响远小于气体吸热对流场的影响；吹气时，管道内气体流速较大，管道结构对流场分布的影响比较明显；吹气时，U形管道对光束的影响比Z形管道对光束的影响要小。

Base Station type Software versionTypes of carrier frequency board adoptedTypes of combiner adoptedWhether had obtained the network license or notIndoor type or outdoor type Whether the master port is separated from the remote-port The maximum carrier frequency capacity of single cabinet The maximum supportable sector numbers of single cabinetWhether it is dual-carrier frequency board or notMust it be paired configuration if it's dual-carrier frequency board (namely, the type of single carrier frequency station could only configure the dual-carrier frequency on hardware) The maximum achievable configuration of a single station of the single cabinetReceiver sensitivity The maximum expand capacity of a single base station (the maximum number of TRX in configuration / the number of cabinets which is required)(fill in according with the three sectors) Top box transmitted power (given separately a grade one combine and a grade two combine) The maximum output power of amplifier (voice, a single logical carrier frequency) The maximum output power of amplifier (EGPRS, a single logical carrier frequency)Whether it has tower-interfaceWhether it has built-in lightning protectionWhether it support the ultra-long cover / whether it need for software support (give simple description that how hardware and software could achieve this) The supporting condition of EGSM (it should be supported including by the carrier frequency, combiner) Dual-band carrier wave (whether it supports the mixed use of 900 M/1800M in the same cabinet) The commonality of duplicate parts Whether it can built-in transmission unitThe single cabinet size (high × width × deep) Installation method Whether it can place against the wallThe basic frame full-configured weight and the supportable number of carrier frequencyThe expansion frame full-configured weight and the supportable number of carrier frequency

基站型号软件版本号采用载频板型号采用合路器型号是否已取得入网许可室内型or室外型是否是主远端分离单机柜最大载频容量单机柜最大支持的扇区数是否是双载频板如是双载频板，是否必须成对配置(即单载频站型只能硬件配置双载频)单机柜可达到的单站最大配置接收机灵敏度单基站最大扩展能力(最大配置TRX数/需机柜数)(按3扇区填写)机顶发射功率(分别给出一级合路与两级合路)功放最大输出功率功放最大输出功率(EGPRS，单个逻辑载频)有无塔放接口有无内置避雷装置是否支持超远覆盖/是否需要软件支持(简单描述软硬件如何实现)EGSM支持情况(包括载频、合路器均应支持)双频段载波（是否支持900M/1800M在同一机柜内混合使用）备件通用性是否可以内置传输单元单机柜尺寸安装方式可否靠墙放置基本架满配重量及支持载频数扩容架满配重量及支持载频数是否支持基本架与扩容架跨扇区满配功耗满配时重量供电方式机柜进出线方式合路器损耗合路能力：几合一单扇区最大支持几载频合路到一副天线/采用几个合路器单扇区载频达到需要增加一副天线时，是否支持两级合路换以不增加天线如两级合路插损为是否支持基带跳频和合成跳频每单个合路器在从低载频数向高载频数扩容时，是否还需要增加硬件可用性指标MTBFMTTR系统中断服务时间硬件是否支持EGPRS本次报价软件版本号开始支持EGPRS的软件版本号其他特点注： 1 应分别填写出来按照本次报价要求所采用的全部BTS型号和采用的合路器型号 2 列出本报价要求的全部室外型基站与高功放单元

The dish washer includes one washer body with inside washing tank, rotary door in the front of the washer body, and one sealing latch set between the washer body and the door to raise the sealing property of the door. The sealing latch includes one hook unit set inside the hole on the washer body side, one sealing unit exposed outside the washer body and contacting closely to one side of the door in close state, one central slot for telescoping the hook unit, and one expansion joint in the joint part to avoid concentration of stress.

本发明包括洗碗机内部具备了洗涤槽的本体，设置在本体的前面转动的门，设置在本体前面和门之间，当关闭门时提高门和本体前面的封闭性的碰销；其中碰销包括：在本体前面一侧形成的插入孔中设置的挂钩部，露出于本体外部，在门关闭时，紧贴门一侧面的密封部，为了使挂钩在插入孔内直径方向伸缩，而在其中央部位形成的切缝，其特征在于密封部上形成了与切缝相通，防止挂钩伸缩时应力集中到挂钩部和密封部之间结合部位上的伸缩槽。

RESULTS:① Gross observation: At 2 weeks, there were no differences between the two groups, and the materials were connected to bone bed with fibrous tissues. At 4 and 8 weeks, there was more new callus in biologic active bone group than in biologic bone group. At 12 weeks, some bionic biphasic ceramic-like biologic active bone were absorbed and new bone regenerated in biologic active bone group, being similar to appearance of host bone, but there were few callus in biologic bone group.

结果：①大体观察：生物活性骨组和生物骨组术后2周时无明显差别，材料与骨床间为纤维组织连接。4周及8周可见生物活性骨组断端周围新生骨痂较多，将材料包绕，12周时可见材料部分吸收，新生骨长入，修复段塑型较好，基本接近宿主骨外形。12周时，生物骨组仅在骨折端有少量骨痂连接。

In order to improve the tower crane working efficiency, windlass mechanism has a set of gear change mechanism, are devided into high speed,mid speed and low speed, the gear change mechanism gained three speed through connecting 2 DLM5-40A and 1 DLM5-63A brake, control 3 brake by LHK switch,when it with the function of low-speed heavy-load, get through the model DLM5-63A brake; when it with the function of mid-speed mid-load and high-speed light-load, get through the model two DLM4-40A brake, and the operator can choice the good position as the weight of the goods, when change the speed, must be cut off the motor, 26 FUSAN CONSTRUCTION MACHINERY CO.,LTD PDF 文件使用"pdfFactory Pro"试用版本创建 www.fineprint.cn FUSHAN TOWER CRANE OPERATINGINSTRUCTIONS-QTZ125G(FS6016) no change speed when driving it.

为了提高塔机的工作效率，卷扬机构设有一套变速装置，分重，中，轻三档，变档装置是通过分别接通两个 DLM5-40A 和一个 DLM5-63A 电磁离合器来获得三种速度。用转换开关 LHK 控制三个电磁离合器，重载低速时，接通 DLM5-63A 电磁离合器，中载中速和轻载高速时，分别接通其余两个 DLM5-40A 电磁离合器，司机可根据物品的重量选择合适的档位，换档时，必须使电机断电，不允许在电机运行过程中换档。

Tang ago, to the west of Qinzhou Ming Yao no records, enter the customs Qinzhou, and Yuan Wei at the time of customs clearance in the kiln, to see TANG Ding kiln at (Shaanxi Jingyang this territory), Song Yaozhou, which has burned out celadon kiln , White, green and pan-green, and other miscellaneous Blue and White Porcelain.

唐以前，秦州以西再无名窑记载，秦州进入关中，又有元魏时的关中窑，唐时看鼎窑，宋时耀州窑等，这些窑先后烧出青瓷、白瓷，泛黑青、绿等杂釉瓷。

By using catalysts based on sodium nitrite, hydrochloric acid and sodium nitrite, cerium dioxide and sodium nitrite, and cupric nitrate and sodium nitrite correspondingly.

结果表明，用亚硝酸钠作催化剂乙醛酸产率为73.9%，盐酸和亚硝酸钠作催化剂时乙醛酸产率为84.6%，二氧化铈和亚硝酸钠作催化剂时乙醛酸产率为80.2%，硝酸铜和亚硝酸钠作催化剂时乙醛酸产率为78.2%。

The contribution of water concentration on the growth of carbon nanotubes was investigated. Scanning electron microscopy results showed that the grown CNTs in CH4/H2 gas mixure had chain-shaped structure and the diameter was about 40—90nm. With the addition of proper amount of water, the diameter of CNTs became uniform, and the surfaces of nanotubes were fully covered with nano-sized node-like structures. When more water was added, branched carbon nanotubes were synthesized.

场发射扫描电子显微镜结果表明，不加水时，制备出的碳纳米管直径不均匀，分布在40—90nm之间，呈链节状的结构；加入少量水时，制备出的碳纳米管直径比较均匀，集中在70nm左右，表面为瘤状结构；当水的流量进一步增加时，得到的碳纳米管表面光滑，出现了枝状结构。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。