无键的

A steel bar is washed and dried, and then put into a glass pipe which is sealed to obtain stirring magneton; a mixed solvent of Gamma-methacrylate oxide propyl trimethoxy silane and methanol is prepared and added with an organic base to obtain a pre-bonding solvent; the stirring magneton is immerged into the pre-bounding solvent, and the outer surface of the glass pipe of the stirring magneton is bonded with a layer of silane substance with alkenyl; a reactive monomer mixture and a pore-forming agent mixed solvent are evenly mixed and then added into a container, the stirring magneton after the pre-bounding is put into the container which is sealed and then put into a water bath; after reaction, the container is removed, the stirring magneton coated with a polymer is taken out and put into a extractor and extracted by using a solvent; or the stir bar is immersed into the solvent till no impurity can be checked in the solvent, thereby obtaining the product.

将铁条清洗干燥，放入玻璃管内，密封得搅拌磁子；配制γ-甲基丙烯酸氧丙基三甲氧基硅烷与甲醇的混合溶液，加入有机碱得预键合溶液，将搅拌磁子浸入预键合溶液，在搅拌磁子的玻璃管外壁键合一层带烯基的硅烷化物质；将反应单体混合剂和致孔剂混合溶液混匀后倒入容器中，将预键合后的搅拌磁子放入容器，密封后置于水浴中，反应后除去容器，取出涂有聚合物的搅拌磁子，置于提取器中，以溶剂提取，或将搅拌棒置于溶剂中浸泡至溶剂中无杂质检出，得产物。

The mechanical behaviour of anchorage foundations is then further studied by comparing that of a caisson without anchors. Meanwhile, the distribution of moment on anchor is analyzed; and the influence of anchors' embedded depth on the bearing capacity is studied.

在此基础上，通过无根键沉井基础和有根键沉井基础的受力特性对比，分析了根式基础的受力特性，对根键上的弯矩分布型式进行了研究，并探讨了根键沿深度位置分布对根式基础承载力的影响。

For the first time, the dynamics changing process of KGM chain in vacuum is proposed, We obtained the following results: polymerization degree influences the stability and shapes of the chain, the chain stability drops with the increasing of polymerization degree, for the high polymerization degree KGM, KGM chain takes on irregular curl state; acetyl group is not the main factor influencing chain conformation , during the course of dynamics movement KGM chain takes on irregular curl state before and after acetyl group was doffed, Extending and curling states change periodicity and has good flexibility.

首次提出了KGM链的动态模型，得到了以下结果：聚合度影响其链形态和稳定性，对于高聚合度的魔芋葡甘聚糖来说，其链呈现无规卷曲状态且稳定性下降，在整个动态运动过程中KGM链脱乙酰基前后都呈现无规卷曲状态，而且其伸展和卷曲的变化是周期性的，表现出了很好的柔性，说明乙酰基不是影响其链形态的主要因素，二面角能和静电作用是真空中影响单链构象的主要的键合作用力和非键合作用力，但是乙酰基对氢键作用的影响(来源：ABC6c论文网www.abclunwen.com)较大。

Number of loaded circuits DN Value Preload Method for Providing a Preload Type of guide 3 row 2.50 turns 70000 None None Ball Shaft process method Ball cage Splined portion Hollow shaft Recommended support unit on the Fixed Side type Precision None None None None Recommended support unit on the Supported Side type Types of Nuts Threading direction Spacer ball Rigidity in the axial direction None Single nut Right-hand, left-handmust be chec...

载荷钢球圈列数 DN值预压预压方法导轨型号 3列 2.50圈 70000 无无滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无无轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性无单一螺帽右螺纹，左螺纹，左右螺纹无 2520.0 螺纹条数防尘措施。。。

Number of loaded circuits DN Value Preload Method for Providing a Preload Type of guide 2 row 2.50 turns 70000 None None Ball Shaft process method Ball cage Splined portion Hollow shaft Recommended support unit on the Fixed Side type Precision None None None None Recommended support unit on the Supported Side type Types of Nuts Threading direction Spacer ball Rigidity in the axial direction None Single nut Right-hand, left-handmust be chec...

载荷钢球圈列数 DN值预压预压方法导轨型号 1row 2.50圈 70000 无无滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无无轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性无单一螺帽右螺纹，左螺纹，左右螺纹无 890.0 螺纹条数防尘措施。。。

Stroke Lead Ball center-to-center diameter Basic load rating Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm mm mm kN kN kg kg/m 70 1 6.2 0.54 0.94 0.017 0.14 Type using standard material Standard grease Standard seal Iron-based AFB-LF None Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer...

载荷钢球圈列数 DN值预压预压方法导轨型号 3列 1.00圈 70000 无无滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无 EK5， FK5 轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性无单一螺帽右螺纹无 60.0 螺纹条数防尘措施防尘罩形式 W清洁环与QZ润滑装置配用 1 无。。。

Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 20 90.1 294 12.68 35.81 Type using standard material Standard grease Standard seal Iron-based AFB-LF RR Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer of protru- sion with QZ a...

载荷钢球圈列数 DN值预压预压方法导轨型号 3列 2.50圈 70000 无无滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无无轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性无单一螺帽右螺纹，左螺纹，左右螺纹无 1860.0 螺纹条数防尘措施。。。

Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 1 0.59 0.93 0.02 0.07 Type using standard material Standard grease Standard seal Iron-based AFB-LF None Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer of protru- sion with QZ a...

载荷钢球圈列数 DN值预压预压方法导轨型号 1row 3.70圈 70000 无无滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无 EK4， FK4 轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性无单一螺帽右螺纹无 52.9 螺纹条数防尘措施防尘罩形式 W清洁环与QZ润滑装置配用 1 无。。。

Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 4 4.2 7.6 0.13 0.8 Type using standard material Standard grease Standard seal Iron-based AFB-LF RR...Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 2 1.5 2.9 0.045 0.47 Type using standard material Standard grease Standard seal Iron-based AFB-LF RR...

载荷钢球圈列数 DN值预压预压方法导轨型号 3列 1.00圈 70000 无无滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无 EK4， FK4 轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性无单一螺帽右螺纹无 35.0 螺纹条数防尘措施防尘罩形式 W清洁环与QZ润滑装置配用 1 无。。。

Stroke Lead Ball center-to-center diameter Basic load rating Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm mm mm kN kN kg kg/m 20 1 5.15 0.32 0.55 0.012 0.11 Type using standard material Standard grease Standard seal Iron-based AFB-LF None Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer...

载荷钢球圈列数 DN值预压预压方法导轨型号 3列 1.00圈 70000 无无滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无 EK4， FK4 轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性无单一螺帽右螺纹无 47 螺纹条数防尘措施防尘罩形式 W清洁环与QZ润滑装置配用 1 无无。。。

They weren't aggressive, but I yelled and threw a rock in their direction to get them off the trail and away from me, just in case.

他们没有侵略性，但我大喊，并在他们的方向扔石头让他们过的线索，远离我，以防万一。

In slot 2 in your bag put wrapping paper, quantity does not matter in this case.

在你的书包里槽2把包装纸、数量无关紧要。