无管的

The positive expression both of p14ARF and mtp53 protein in NSCLC tissues were significantly different from that in nonmal lung tissues and tissues adjacent to the cancer (P.01).The expression of p14ARF protein was correlated with pathological degree（P＜0.01）,but it was uncorrelated with pathological staging,lymphaden metabasis and vessel invasion(P＞0.05).The expression of mtp53 protein was correlated with clinical pathology staging,pathological degree and vessel invasion(P＜0.05 or P＜0.01),but it was uncorrelated with lymphaden metabasis(P＞0.05).(2) The coexpression of p14ARF and mtp53 was 36.7％,their consistency was 38.8％,but the expression of p14ARF protein were negatively correlated with the expression of mtp53 protein(r=-0.3553,P＜0.001).Conclusion The results suggest that the decrease of p14ARF and the increase of mtp53 protein may play an important role in the genesis and development of NSCLC.

结果 (1)在正常肺组织、癌旁组织和NSCLC中p14ARF蛋白的阳性表达率分别为93.3%、83.3%、55.1%，mtp53蛋白的阳性表达率分别为6.7%、44.4%、79.6%；p14ARF蛋白和mtp53蛋白在NSCLC中的表达与正常肺组织和癌旁组织比较均有显著性差异(P＜0.01)；p14ARF蛋白表达与临床病理分期、有无淋巴结转移、有无脉管浸润无关(P＞0.05)，而与病理分化程度有关（P＜0.01）；mtp53蛋白表达与临床病理分期、病理分化程度(P＜0.01)及有无脉管浸润(P＜0.05)有关，而与有无淋巴结转移无关(P＞0.05)；(2)在NSCLC中，pl4ARF与mtp53蛋白共表达为36.7％，一致性为38.8％，二者表达呈负相关(r=-0.3553，P＜0.001)。

Approach is to dip cotton balls ethanol scrub, scrub the parts, including LED, lens and mirrors, photosensitive surface, it is necessary to pay attention to ethanol must be pure, or else they will become more dirty washing, but also can use water After ethanol washing, the lens at the lens and reflectors Oh breath and then gently wipe clean swab until unabated until smooth.

处理方法是用棉球沾无水乙醇擦洗，擦洗的部件包括发光管、透镜及反光镜、光敏管表面，要注意无水乙醇一定要纯，否则会越清洗越脏，也可以在用无水乙醇清洗后，对准透镜及反光镜片呵一口气，然后再用干净的棉棒轻轻擦拭，直到光洁如初为止。

Approach is to dip cotton balls scrub ethanol, scrub the parts, including LED, lens and mirrors, photosensitive surface, it is necessary to pay attention to ethanol must be pure, or else they will become more dirty washing, but also can use water After ethanol washing, the lens at the lens and reflectors Oh breath and then gently wipe clean swab until unabated until smooth.

处理方法是用棉球沾无水乙醇擦洗，擦洗的部件包括发光管、透镜及反光镜、光敏管表面，要注意无水乙醇一定要纯，否则会越清洗越脏，也可以在用无水乙醇清洗后，对准透镜及反光镜片呵一口气，然后再用干净的棉棒轻轻擦拭，直到光洁如初为止。

Results Some spermatocytes all in model and clomiphere groups were denatured or death and spermatid did not develop.

结果：实验对照组的曲细精管上皮中多数精母细胞变性、死亡，精子细胞不发育，无精子形成，管腔中无精子，支持细胞有明显病变。

Results:There were no abdominal pain and fever,jaundice faded away gradually postoperation.Biliary drainage was 300ml-1000ml/d more or less.Colour of bile changed into normal by degrees.Intra peritoneal drainage was open and the colour was light bloody.Amount of drainage dropped off day after day.Whole blood cell test, serum glutamic pyruvic transaminase,serum glutamic oxalacetic transarninase,total serum protein,serum albumin and serum globulin returned to normal in first week postoperation.Serum bilirubin,serum glutamyltranspetidase and serum alkaline phosphatase declined gradually in first week postoperation.T-tube was clipped at twelfth day postoperation.T-tube Cholangiography was clear at 24~ day postoperation.

结果：术后无上腹部绞痛、高热，黄疸逐渐减退，每日引流胆汁300ml-1000ml不等，由淡黄色混浊、内有胆泥过渡到金黄色清亮的正常胆汁，腹腔引流通畅，引流液为淡红色，量从最初的200ml迅速过渡到10ml，血常规、血清谷丙转氨酶、谷草转氨酶、总蛋白、白蛋白、球蛋白等1周内均恢复正常，血清总胆红素、直接胆红素、间接胆红素、谷氨酰转肽酶、碱性磷酸酶逐渐下降，术后12d夹闭T管，术后24d T管造影提示左、右肝管及胆总管下端通畅，无狭窄。

Methods Ninety elective patients undergoing general anesthesia for hysterectomy were randomly assigned to two equal groups. GroupⅡreceived endotracheal intubation protected by sterilized transparent sleeve while groupⅠcorrespondingly adopted unprotective classical endotracheal intubation. Endotracheal swab sampling and bacterial counting were performed on the principle of aseptic processing before endotracheal intubation and extubation, respectively.

90例在全身麻醉下行择期全子宫切除术的患者随机分为两组，每组45例，Ⅰ组采用传统的气管插管操作方法，Ⅱ组采用无菌透明隔离套保护的气管插管操作方法，在气管插管前和拔管前分别按照无菌操作原则实施气管内试子取样，进行菌落计数。

Type of guide Loading method Block mounting direction Ball retainer Ball Cage Ball 4-way Equal Load Type Top surface mount None None LaCS is available Plate cover / steel tape is available Dust cover type Seal Resistance Value Seal types for seal resistance value None None None 19.60 UU Dedicated cap for the LM rail mounting hole Applicable to QZ Lubricator Lubrication method Grease brand Nipple, plumbing fixture type C...

导轨型号负荷方式滑块安装方向防止滚珠脱落用保持器球保持器滚珠 4方向等负荷型从上安装无无与LaCS配用可选用紧绷薄钢带/粘接薄钢带防尘罩形式密封垫片阻力值各种阻力值的密封垫片无无无 19.60 UU LM轨道安装孔专用防尘盖可配用QZ润滑装置润滑方式润滑脂品牌螺纹接口、配管接头型式 C12 无脂润滑。。。

Type of guide Loading method Block mounting direction Ball retainer Ball Cage Ball 4-way Equal Load Type Top surface mount Yes None LaCS is available Plate cover / steel tape is available Dust cover type Seal Resistance Value Seal types for seal resistance value None None None 3.90 UU Dedicated cap for the LM rail mounting hole Applicable to QZ Lubricator Lubrication method Grease brand Nipple, plumbing fixture type Non...

导轨型号负荷方式滑块安装方向防止滚珠脱落用保持器球保持器滚珠 4方向等负荷型从上安装有无与LaCS配用可选用紧绷薄钢带/粘接薄钢带防尘罩形式密封垫片阻力值各种阻力值的密封垫片无无无 3.90 UU LM轨道安装孔专用防尘盖可配用QZ润滑装置润滑方式润滑脂品牌螺纹接口、配管接头型式无无脂润滑。。。

Type of guide Loading method Block mounting direction Ball retainer Ball Cage Ball 4-way Equal Load Type Top surface mount None None LaCS is available Plate cover / steel tape is available Dust cover type Seal Resistance Value Seal types for seal resistance value None None None 0.80 UU Dedicated cap for the LM rail mounting hole Applicable to QZ Lubricator Lubrication method Grease brand Nipple, plumbing fixture type No...

导轨型号负荷方式滑块安装方向防止滚珠脱落用保持器球保持器滚珠 4方向等负荷型从上安装无无与LaCS配用可选用紧绷薄钢带/粘接薄钢带防尘罩形式密封垫片阻力值各种阻力值的密封垫片无无无 0.80 UU LM轨道安装孔专用防尘盖可配用QZ润滑装置润滑方式润滑脂品牌螺纹接口、配管接头型式无无脂润滑。。。

The simulation results of the cylinder-block model were given in the article, consistent with that of Middlemen"s. It was shown that the block part could improve the uniformity of the flow distribution. The analysis of the flow field of some materials with different power-law factor in the die designed by Mckelvey was close to that of Mckelvey"s. It was shown that the flow distribution was uniform in the die that can producesheets with 1200mm in width. During the analysis the flow channel was divided into several parts to get the details about the fluid flow in each area. A conclusion was drawn after analyzing the influence of the die pressure on the flow distribution, that the higher pressure is good for the output and bad for the uniformity of the distribution. Simulation of the die applying the cylindrical main runner showed the fact that when the cylinder replaced the cone the change of uniformity was trivial. The uniformity of the non-block flow channel was so poor that the block in the proper position of the die channel was necessary. The project of the die for the wider sheet was put forth, and the analysis of the fluid flow in the die was shown.

本文模拟了圆柱管缝隙流模型的三维流动场，得到了与Middlemen结论一致的流动均匀性，并通过模拟直观地展示了采用阻尼块可以改善挤出均匀性的现象；分析了多种幂率指数的流体在Mckelvey等人设计的流道模型中的流动分布，得到了与Mckelvey的分析结果接近的压力降和流量偏差；本文建立了1200mm幅宽机头流道的三维有限元模型，并逐个分析各个区域和多个截面的流动分布状况，由此揭示了1200mm幅宽L-型机头流道内的流北京化工大学硕士学位论文动分布基本均匀，并在分析了机头压力对于挤出流动分布的影响后得出结论：较高的机头压力可以获得较大的产量，但是不利于物料均匀分布；模拟了采用圆柱管主流道时机头流道内的流动分布，得出结论：主流道由圆锥管改为圆柱管时对流动均匀性影响不大，通过设置适当的阻尼仍然可以达到挤出平衡；模拟了两端进料式圆柱管无阻尼流道的流动均匀性后得到结论：两端进料式无阻尼结构的流动均匀性较差，宽机头中仍然有必要设置阻尼块；确定宽幅机头流道的基本方案，并设计了一种宽幅防水卷材挤出机头流道的结构，通过流动模拟表明该种结构的流动均匀性较好；考察了宽幅机头对于不同厚度片材的挤出适应性，得到结论：当生产不同厚度的片材时，阻尼块高度需要调整。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐