英语人>网络例句>无孔的 相关的搜索结果
网络例句

无孔的

与 无孔的 相关的网络例句 [注:此内容来源于网络,仅供参考]

The mesoporous sieve of the M41S family has framewoks with pore diameters withinthe mesoporous range(2~10nm), huge surfaces areas about 1000cm2/g and amorphism porouswall tent to incorporate hetero atom so that has been used abroad in big moleculer catalysisand separation, life science and environment protection fields and so on.

M41S系列介孔分子筛具有2~10nm左右的规整孔道、大约1000cm~2/g的高比表面积和容易引入杂原子的无定形孔壁等独特优点,被广泛应用在大分子催化、分离和生命科学、环境保护等热点领域。

Our process capability: Plates: FR4, High TG FR4, high CTI FR4, high frequency materials, halogen-free materials, aluminum and other low-rise Materials :2-20 layer of finished copper thickness :0.5-5 OZ finished thickness: 0.2 -6.0mm Minimum line width: 3mil Minimum line spacing: 3mil smallest shape tolerances:+/-0.1mm minimum finished diameter: 0.1mm maximum thickness aperture ratio: 12:1 wide minimum solder bridge: 4mil characters minimum line width: 5mil Minimum height of characters: 30mil Solder Mask Color: Green, black, blue, white, yellow, purple characters such as color: white, yellow, black and other surface processes: spray tin, lead-free HASL, Electroless gold plating Shuijin, OSP, chemical Shen tin, silver and other chemicals Shen Process: Goldfinger, blue gum, Blind-via/Buried-via, characteristic impedance control, rigid-flexible combination of reliability testing such as: Open / Short testing, impedance testing, solderability testing, thermal shock testing, metallographic analysis of micro-slice curvature Isoptera: 0.7% flame retardant Level: 94V-0

我们公司的制程能力:板材:FR4、高TG FR4、高CTI FR4、高频材料、无卤素材料、铝基材料等层数:2-20层成品铜厚:0.5-5 OZ成品板厚:0.2-6.0mm最小线宽:3mil最小线间距:3mil最小外形公差:+/-0.1mm最小成品孔径:0.1mm最大板厚孔径比:12:1最小阻焊桥宽:4mil最小字符线宽:5mil最小字符高度:30mil阻焊颜色:绿色、黑色、蓝色、白色、黄色、紫色等字符颜色:白色、黄色、黑色等表面工艺:喷锡,无铅喷锡、化学沉金、电镀水金、OSP、化学沉锡、化学沉银等其它工艺:金手指、蓝胶、盲埋孔、特性阻抗控制、刚柔结合等可靠性测试:开/短路测试、阻抗测试、可焊性测试、热冲击测试、金相微切片分析等翅曲度:≤0.7%阻燃等级:94V-0

Palatal fistulae were repaired by this method, 4 pedicled superior-anteriorly and 14 pedicled posteriorly, 7 of which got velopharyngeal incompetence correction at the same time. Results All of the patients got satisfactory fistula closure except 3 complications. One flap got partly necrosis and two got fistulae at the hard palate. However, the fistula sizes were reduced greatly and one has been re-repaired well by the transferred buccinator musculomucosal flap one year later.

结果:共修复腭瘘患者18例;其中15例腭部瘘孔获得关闭,颊肌黏膜瓣成活良好,无感染、腮腺导管损伤或阻塞、面神经损伤,无张口受限、瘢痕挛缩及咀嚼障碍;2例因岛状颊肌粘膜瓣远端愈合不良再次出现硬腭前端瘘口,但面积较原来明显减小,其中1例再发腭瘘应用已转移到腭部的颊肌粘膜瓣组织行二次手术修复后愈合;1例岛状颊肌粘膜瓣部分坏死。

Other diagnostic features include the presence of a crest along the anterodorsal midlines of the premaxillae,the edentulous maxilla,the presence of a groove-like trough along with the anterolateral margin of the maxilla on the ventral surface,the presence of six conical premaxillary teeth,and no more than six conical dentary teeth which are restricted to the anterior portion of the dentary.

其他主要特征有:前颌骨沿前背中央有一隆嵴;上颌仅前颌骨有6枚圆锥形齿,无上颌骨齿;上颌骨沿前腹侧缘有一沟槽;下颌齿骨齿都集中在前端且至多不超过6枚。依据上述这些特征很易把短吻贫齿龙与其他已知海龙相区别。短吻贫齿龙头骨顶面松果孔大且很前位,头骨腭面的锄骨和翼骨均无齿,它的颈较长(至少可以辨认出13个颈椎)。

Male flowers: around apical pore, nearly always subtended by 2 bracteoles,± sessile; stamens (1 or)2, filaments joined at base; anthers mucronate; pistillode usually absent.

雄花: 在顶端的孔周围,近总是被2小苞片包着,多少无梗;雄蕊(1或者)2,花丝在基部连接;花药短尖;退化雌蕊通常无。

The result of clustering based on quantitative data of vessel elements suggests that the Sonneratia species evolved into two clades, one including S. caseoalris and S. paracaseolaris that has the wider vessel and lower pore density suggesting a high conducting efficiency, the other including S. alba, S. ovata, S. apetala and S. hainanensis that has the narrower vessel and higher pore density resulting in high conducting safety.

导管数量特徵的聚类分析可以推测海桑属植物沿两支进化,一支进化为水分输导效率高的种类(即导管直径宽和输导面积大,管孔密度小,如海桑和拟海桑),另一支进化为水分输导安全性高的种类(即导管直径窄、输导面积小,管孔密度大,如杯萼海桑、卵叶海桑、无瓣海桑、海南海桑)。

The result of clustering based on quantitative data of vessel elements suggests that the Sonneratia species evolved into two clades,one including S. aseoalris and S.paracaseolaris that has the wider vessel and lower pore density sug esting a high conducting eficiency,the other including S.alba,S. ovata,S.apetala and S.hainanensis that has the narrower vessel and higher pore density resulting in high conducting safety.

导管数量特征的聚类分析可以推测海桑属植物沿两支进化,一支进化为水分输导效率高的种类(即导管直径宽和输导面积大,管孔密度小,如海桑和拟海桑),另一支进化为水分输导安全性高的种类(即导管直径窄、输导面积小,管孔密度大,如杯萼海桑、卵叶海桑、无瓣海桑、海南海桑)。

There was no significant difference between the length of the tentorial edge exposed via subtemporal keyhole approach and traditional subtemporal approach.

量化研究显示颞下锁孔入路中小脑幕缘显露长度与传统颞下入路无显著差异;脑干腹侧面显露长度与去颧弓颞下入路无显著差异,但大于保留颧弓颞下入路中的显露长度(p <0.05)。

Stem leaves narrowly oblong to narrowly elliptic, glabrous or sparsely short strigose abaxially; pedicel to 0.2 cm; calyx pubescent along midvein; corolla limb 5-7 mm wide; abaxial aperture of nutlets ca. 0.6 mm

缺乏茎生叶狭长圆形到狭椭圆形,无毛或疏生背面;花梗到0.2厘米;花萼短柔毛沿中脉;花冠瓣片5-7毫米宽;小坚果的背面的孔约0.6毫米 14 Microula oblongifolia 长圆微孔草

The bearing inner ring and the axis tight fit, the outer ring bearing hole is a more loose with the non-separation-type bearings installed, press the bearings can be installed on the shaft, then shaft with bearings packed together into the bearing hole inside, if the bearing is small, can also be lighter than the soft metal hammer blow set

对无油轴承内圈与轴时紧配合、外圈轴承座孔是较松配合的非分离型轴承进行安装时,可用压力机将轴承先安装在轴上,然后将轴连同轴承一起装到轴承座孔内,若轴承较小时,也可用较软的金属锤轻击套

第10/26页 首页 < ... 6 7 8 9 10 11 12 13 14 ... > 尾页
推荐网络例句

She gently rebuff ed him, but agreed that they could be friends

她婉言拒绝了,但同意作为朋友相处。

If in the penal farm, you were sure to be criticized.

要是在劳改农场,你等着挨绳子吧!

Several theories about reigniting and extinguishing of the arc have been refered.

本文综合考虑了几种电弧重燃和熄灭理论。