无压的

It builds the whole liquid-cooling system mainly by the design of the liquid-cooling decalescence boxes(improve its bottom material from aluminium alloy to pure copper, enlarge its volume, better cooling effects, and strengthen pressurization), by the operations of cooling effect about the heat exchanger worked by its temperature adjustability of the ribs(diffuse the heat fleetly owing to the excellent diathermancy of the material of the ribs ,make effective diathermancy owing to ribs outside areas, and drive the heat of the ribs away by the fans), and by the water pump made up of the piezoelectric ceramic with the excellent performance-no electromagnetism interference, little cubage, little noise, light exterior, light weight, low consume, high flux, replacing the mechanical pump.

在液冷散热器的研究中，主要通过对液冷吸热盒设计不断地改进(使吸热盒底部的材料从铝合金变为纯铜材料，其整个体积有所变大，但其散热效果明显变好，且密封性得到了极大地加强)，综合地运用换热器中肋片的壁面温度调节作用产生的散热效果(肋片材料优良的导热性，快速地扩散了热量：肋片较大的与流体接触的表面积，使传热更加充分，对流热阻大大减小；再利用风扇对肋片上的热量进行吹散)，利用性能优良的压电陶瓷泵(该泵机电性能稳定，具有无电磁干扰、体积小、噪音小、外型轻薄、重量轻、低能耗。、高扬程等优点。)代替机械泵作为驱动源，搭建了整个散热系统。

The main results of the study are obtained as follows:1 In order to analyze and study the physical and mechanical characteristics of Lianyungang marine soft clay deeply, large numbers of basic mechanical characteristics tests and tri-axial shear tests are completed.2 In order to investigate the loaded and failure characteristics of the cement-soil, the cement-soils for the different ratio and different cure time are studied in the laboratory, and their unconfined compression tests and tri-axial shear tests are performed.3 Based on the solution of one-dimension consolidation, the one-dimension consolidation of the double-layered foundation is solved for two-grade loading in virtue of transcendental equation; Simultaneously, the one-dimension consolidation of the double-layered foundation is solved by means of Laplace transform for two-grade loading, and Stehfest numerical transform is applied in Laplace's inverse transformation; Furthermore, according to the practical foundation shapes, the consolidation models of the soil between piles and the substratum are built and solved respectively.4 The effect of each parameters on the consolidation of the double-layered foundation is discussed, and the solution of load transfer method for double-layered foundation is applied in A1-A4 section of Lian-Xu expressway. The results of calculating settlement of the double-layered consolidation theory are basic agreement with the measuring settlement results.

取得了以下几方面的研究成果：1针对连云港海相软土进行一维固结和三轴剪切试验，深入分析连云港海相软土的物理力学特性。2模拟水泥土搅拌桩施工，在室内制备不同配比、不同龄期的水泥土试样，并进行无侧限抗压试验和三轴剪切试验，揭示水泥土的受力特性及破坏特性。3运用超越方程，以双层地基一维固结解析解为基础，推导出二级加荷条件下双层地基的固结解析解；同时，通过荷载传递法并借助Laplace变换对双层地基的固结问题进行了数值求解；此外，根据实际的地基结构，建立了桩间土和下卧层的固结模型并分别进行求解分析。4分析探讨了双层地基中各参数对双层地基固结的影响程度，并运用荷载传递法的解答计算了连-徐高速公路A1-A4标水泥土搅拌桩处理段的六个断面，计算结果与实测数据有较好的一致性。

In view of constant pressure outside boundary double permeability composite oil reservoir model, the variable rate question dimensionless pressure distribution Laplace solution has been studied, and the corresponding application briefly derived.

针对定压外边界的复合双渗储层模型，研究了变流率问题的无因次压力分布的Laplace空间解，并简要地引导了相应的应用，是对试井分析理论的一种完善，对相应的试井分析软件的研制更具有深远的应用价值，对油藏数值模拟方法也具有指导意义。

This paper establishes mathematical models of unsteady and Non-Darcy low speed flow through the porous media and the double porous medium, and has obtained their solutions in an infinite reservoir through Laplace transformation, and their long time asymptotic solutions has been worked out, solutions on a bounded reservoir has also obtained through finite integral transformation and Laplace transformation.

从现场上各种水淹的实际资料来看，同一水动力的非均质油层系统中，渗透率相对较高的部分水洗之后，渗透率相对较低部分的油层却可以原封不动。而且，其渗透率可达达西级，含油饱和度可达80％以上。相对流动比(即同一水动力的非均质油层系统中，小层平均渗透率的最大值与其中不流动部分的小层平均渗透率的最大值相比)的比值在各种油层的生产实例中十分相近。一般的分布范围为3—7，常见的为4—6。实验室结果和生产实践基本相同。简单的注水和压裂对这一比值几乎无影响。

Blade according to claim 23, characterised in that the two bundles of rovings of the spar are pressed against one another by their portions (51a, 51b) passing through the blade footing (43), between the looped root portion (48) and the portions of the halves that are engaged and held applied against one another in the shell (44) so as to form the sole bundle (5) of the spar.

刀片根据索赔23 ，特点是在这两个捆无捻粗纱的SPAR公司是压一由他们的另一部分（ 51A条， 51B条），通过叶片的基础上（ 43 ）之间，环根部分（ 48岁）和部分该部分是从事和举行的适用对一另一个在蚬壳公司（ 44 ）从而形成唯一的束（ 5 ）的SPAR公司。

The following cases, to go with locator: 1, medium pressure high pressure big time; 2, valve diameter is large Forged Gate, Globe, Check Valves (DN 00); 3, high or low temperature control valve; 4, the action necessary to raise the speed control valve; 5, using standard signal, the operation of non-standard spring when the implementing agency (20 ~ 100KPa spring outside the range); 6, when used for sub-process control; 7, when the valve to achieve the reverse action (air to close each open-type gas conversion); 8, need to change the valve's flow characteristic time (you can change the positioner cam); 9, no spring actuator or piston actuator, the proportion of action to achieve the time; 10, electrical signals to operate pneumatic actuator must Distribution - gas valve positioner.

下列情况下，要配定位器： 1、介质压力高、压差大的时候； 2、调节阀口径大时（DN00）； 3、高温或低温调节阀； 4、需要提高调节阀的动作速度时； 5、用标准信号、操作气动管路截止阀非标准弹簧的执行机构时（20～100KPa以外的弹簧范围）； 6、用于分程控制时； 7、使阀门实现反向动作时（气关式和气开式互相转换）； 8、需要改变阀的流量特性时； 9、无弹簧执行机构或活塞执行机构，要实现比例动作时； 10、用电信号去操作气动执行机构时，必须配电-气阀门定位器。

The following cases, to go with locator: 1, medium pressure high pressure big time; 2, valve diameter is largeForged Gate, Globe, Check Valves (DN 00); 3, high or low temperature control valve; 4, the action necessary to raise the speed control valve; 5, using standard signal, the operation of non-standard spring when the implementing agency (20 ~ 100KPa spring outside the range); 6, when used for sub-process control; 7, when the valve to achieve the reverse action (air to close each open-type gas conversion); 8, need to change the valve''s flow characteristic time (you can change the positioner cam); 9, no spring actuator or piston actuator, the proportion of action to achieve the time; 10, electrical signals to operate pneumatic actuator must Distribution - gas valve positioner.

下面所开列情况下，要配定位器：一、介质压力高、压差大的时辰； 2、调节阀口径大时（DN00）； 3、高温或低温调节阀； 4、需要提高调节阀的动作速度时； 5、用标准旌旗灯号、操作气动管路截止阀非标准弹簧的执行机构时（20～100KPa以外的弹簧范围）； 6、用于分程节制时；七、使阀门实现逆向动作时（气关式和气开式互相转换）； 8、需要改变阀的流量特性时；九、无弹簧执行机构或活塞执行机构，要实现比例动作时； 10、用电旌旗灯号去操作气动执行机构时，必须配电-气阀门定位器。

We are the company .specialized in recycle plastics/chemical Now we can supply [PMMA + Aluminum Hydroxide AI3]powder , post industrial You can save money for purchasing acrylic /aluminium hydroxide powder, Which is needed in manufacturing acrylic solid surface.

EURO International Limited 您好：我们是专门从事再生塑料和化学制品的韩国公司，现在我们可以为您能提供压克力[聚甲丙烯酸基甲酯PMMA +氢氧化铝凝胶 Aluminum Hydroxide AI3 ] 原料粉末我们公司诚切希望用再生产品为您省去不必要的费用，以上的原料无乱哪一个都是制造丙烯酸树脂的坚实表面的重要原材料。

Sterilization in desinfection chamber and subcultures of collections ;②confection of fermentation media and sterilization technics;③influences to objective produce altering the fermentable conditions ,including the examinations of the parameters about remnant sugar、pH、growth of microorganisms and produce;④separations and distillations of objective produces in fermented broth,the distillation technics of filter press and ion exchange;⑤brief and operation techniques of automatic fermentation tank.

课程内容：本课程主要实验内容：①微生物无菌室灭菌及种子扩大培养技术；②微生物发酵培养基及配制及灭菌技术；③微生物发酵及发酵条件的改变对目的产物代谢的影响，包括菌体生长、pH、残糖和产物等发酵过程中各项参数的检测；④发酵液中目的产物的分离及提纯，板框压滤离子交换提取技术；⑤自动发酵罐的简介及操作技术。

The influence of thedifferent parameters, such as blank-holder condition, thickness of blank sheetand material pattern on the wrinkle and the crack is analyzed. FLD is used tojudge the crack on the multi-point forming process successfully. The predictionof crack accords with the experiment ones, which shows choosing the properparameters can eliminate or restrain the defects, and also benefits the MPFtechnique and the shaping analysis.

本文对使用弹性介质和无弹性介质的多点成形过程进行了对比，指出使用弹性介质时在满足成形精度的前提下可以明显改善工件的成形质量，并通过对不同厚度和弹性模量的弹性介质对压痕的抑制作用进行了对比分析，探讨了最佳的弹性介质参数。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。