无压的

Broken-rollers and stepless blad type double facer adopts combined structure which effectively overcometraditional low heat efficeency because of concave heat box when work,which improve work speed and qualit,decrease wasted board,especially suitable for light weight board.

其中碎辊式无级压载双面机采用碎辊结构，有效克服传统压载，因加热箱工作时下凹，导致热板上表面传热效率差的缺点，避免了传统压辊不平衡对纸板的冲击，从而提高了生产速度和质量，降低了废品率，更加适合克重纸板生产。

Based on the integral hydraulic model test of SHANGHAI CHANGQIAO waterwork s water-transport pumping station,some research on the hydraulic characteristics of the pressurized forbay has been done in the paper.

本文基于上海长桥自来水厂改造工程送水泵站整体水力模型试验，对有压前池的水力特性进行了研究，研究的主要内容如下： 1、无导流措施的有压前池在不同供水组合及不同机组开机组合条件下的水力特性，并分析了流态较差的原因； 2、加设导流墩后有压前池的水力特性，以及加设导流墩流态改善的原因； 3、有压前池进气临界条件的试验研究； 4、水泵进气以后水泵性能的讨论。

The affected factors to the whisht intensity of pipeline is analysed in two aspects: defectiveness and non. In the non-defectiveness aspect, the tranversing pipeline is considered as thin-wall container, and the annulus stress emerged from inner pressure as main stress on base of stress influence colligated with temperature and inner pressure, then amends it with the axis orientation stress, with the 4th intensity theory, we can calculate the whisht intensity of river tranversing oil pipeline.

从有缺陷和无缺陷两个方面对管道静强度的影响因素进行了分析，在无缺陷穿越管道的静强度分析中，是将穿越管道视为薄壁容器，并在综合考虑温度和内压对管道的应力影响的基础上，把由内压引起的环向应力当作主要应力，再用轴向应力加以修正，根据强度理论计算相当应力，从而实现了穿越河流输油管道的静强度计算。

The ionomer membrane under the conditions of 20℃ and 0.05 MPa shows better permeaselectivities that the permeability coefficient of CO_2 and CO_2/ N_2 separation factor are 223 Barrer and 65.70, respectively, while CO_2 / CH_4 separation factor is only 14.70. An obvious increase in P_(CO_2) with decreasing pressure difference exhibits a characteristic of facilitated CO_2 transport, which is not disappear and almost unchange after two months. There is no this behavior for N_2 and CH_4. Hence, P_(CO_2) and α_(CO_2/N_2) and α_(CO_2/CH_4) can be enhanced simultaneously.

该离聚体膜显示出良好的CO_2渗透性能，在20℃和0.05MPa压差下，CO_2渗透系数P_(CO_2)和CO_2/N_2分离系数αCO_2/N_2分别高达223 Barrer和65.70.P_(CO_2)和αCO_2/N_2随CO_2压差的降低而明显增大，显示出促进输送特征，这一行为即使在膜放置2个月之后并不消失，渗透分离性能变化不大。N_2和CH_4无此性能，因此在气体压差较低时，P_(CO_2)和αCO_2/N_2、αCO_2/CH_4可同时提高。

The ionomer membrane under the conditions of 20℃ and 0.05 MPa shows better permeaselectivities that the permeability coefficient of CO_2 and CO_2/ N_2 separation factor are 223 Barrer and 65.70, respectively, while CO_2 / CH_4 separation factor is only 14.70. An obvious increase in P_(CO_2) with decreasing pressure difference exhibits a characteristic of facilitated CO_2 transport, which is not disappear and almost unchange after two months. There is no this behavior for N_2 and CH_4. Hence, P_(CO_2) and α_(CO_2/N_2) and α_(CO_2/CH_4) can be enhanced simultaneously.

该离聚体膜显示出良好的CO_2渗透性能，在20℃和0.05MPa压差下，CO_2渗透系数P_(CO_2)和CO_2/N_2分离系数αCO_2/N_2分别高达223 Barrer和65.70.P_(CO_2)和αCO_2/N_2随CO_2压差的降低而(来源：e2b2A2bBC论文网www.abclunwen.com)明显增大，显示出促进输送特征，这一行为即使在膜放置2个月之后并不消失，渗透分离性能变化不大。N_2和CH_4无此性能，因此在气体压差较低时，P_(CO_2)和αCO_2/N_2、αCO_2/CH_4可同时提高。

With the different laboratory compaction method and the real pavement, the study of particle stability and density indicated that Marshall compacted specimen can not simulate the real pavement, the rolling and gyratory compacted specimen are the most similar with real pavement, vibrating compacted specimen is second similar with the real pavement.

针对不同试验室压实方法成型试件和实际路面，从集料颗粒的稳定性和密实程度两个角度的对比研究表明，马歇尔击实成型试件法无法有效模拟实际路面，表现在其粗集料颗粒主轴取向无统计规律且与实际路面不具相关性；轮碾压实和旋转压实试件具有与路面最接近的稳定性和密实程度；振动压实次之，虽然表现出具有使颗粒较好均匀分散成型的特点，但其粗集料颗粒骨架的稳定性不够理想，致使其密实程度相对不高。

Exerting surrounding pressure can prevent crack growing in a uniaxially compressed concrete specimen. The behavior of concrete in which there is no crack propagation (called ideal state without damage growth) is researched in this paper.

通过对混凝土施加围压，使单轴受压混凝土的裂缝发展受到限制，从而研究混凝土在接近无裂纹发展状态下的受压性能。

By Ensemble-averaged Method, the mean field was got to show the 3D structure of flow. By Phase-locked Averaged Technique, the periodic mean field was got to reflect the periodic unsteady characteristic. The 3D structure and the periodic unsteady characteristic of the unsteady flow within the vaneless and vaned diffuser were discussed through analyzing the mean field and the periodic mean field.

离心风机扩压器内非定常流动的实验研究本文完成了离心风机两种结构条件下无叶扩压器、有叶扩压器内部的非定常流动瞬态全流场的实验测量，获得了不同运行工况下PIV的瞬态流谱，为研究扩压器内部非定常流动提供了基础实验资料。

Type of guide Loading method Ball retainer Ball Cage LaCS is available Ball 4-way Equal Load Type Yes None None Plate cover / steel tape is available Dust cover type Seal Resistance Value Seal types for seal resistance value Dedicated cap for the LM rail mounting hole None None 3.90 UU C6 Applicable to QZ Lubricator Lubrication method Grease brand Nipple, plumbing fixture type Preload grade None Grease lubrication, oil...

导轨型号负荷方式防止滚珠脱落用保持器球保持器与LaCS配用滚珠 4方向等负荷型有无无可选用紧绷薄钢带/粘接薄钢带防尘罩形式密封垫片阻力值各种阻力值的密封垫片 LM轨道安装孔专用防尘盖无无 3.90 UU C6 可配用QZ润滑装置润滑方式润滑脂品牌螺纹接口、配管接头型式预压等级无脂润滑，油润滑，其它。。。

According to the principle of elasticity-viscoelasticity, equations of stress and strainfor EMP surface layer under the load of different indenters and indenter contact whilesliding were calculated separately. The indenters contain sphere, cylinder and taper.

粘弹性对应原则，计算出了受一般外形压头法向无摩擦力作用下和受球、圆柱平头、圆锥形压头法向载荷作用下，以及在滑动过程中相应压头形态接触作用下EMP表层的应力、应变方程。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。