旁路

Open needle valves "A" high side and "C" bypass to vent air from bypass hose.

开启针形阀"A"高端和"C"旁路，从旁路软管排放空气。

There were 344 shunts placed without cardiopulmonary bypass, 287 shunts with bypass, 323 Norwood procedures, and 50 Sano procedures.

有344台分流术没有心肺旁路， 287台分流术用旁路， 323 台Norwood手术和50台Sano手术。

The suggested general bypassing model can also be used in design bypassing network in superscalar and VLIW processors.

本文的通用旁路模型不但适用于复杂标量流水线的旁路设计，而且可以扩展到多发射处理器数据旁路网络的分析。

However 20(39%) patients appeared obvious T wave change among th e 52 patients with non-conceal assessory pathway after RFCA,including the 19 pa tients they passed through cmplete accessory pathway (QRS duration≥140 ms) and only one patient is incomplete accessory pathway (QRS duration ＜140 ms).

结果：80例隐匿性旁路在射频消融术后无1例出现心脏复极改变，52例显性旁路中有20例(占39 %)术后出现女性明显 T波变化，其中完全性旁路(QRS≥0.14 s)占19例，而不完全性旁路(QRS＜0.14 s)仅占1例。

RESULTS:Amo ng the 80 patients with conceal accessory pathway,no one had episodes of T wave change by RFCA. However 20(39%) patients appeared obvious T wave change among th e 52 patients with non-conceal assessory pathway after RFCA,including the 19 pa tients they passed through cmplete accessory pathway (QRS duration≥140 ms) and only one patient is incomplete accessory pathway (QRS duration ＜140 ms).

结果：80例隐匿性旁路在射频消融术后无1例出现心脏复极改变，52例显性旁路中有20例(占39 %)术后出现明显T波变化，其中完全性旁路(QRS≥0.14 s)占19例，而不完全性旁路(QRS＜0.14 s)仅占1例。

In Jiawang PFBC pilot plant,the gas bypass is a safety pass while the system starts up,or the gas-turbine has malfunction and reduced load.The attemperator and the depressurizer are the key equipments of the bypass.

贾汪 PFBC- CC燃煤联合循环发电中试电站的烟气旁路系统是机组启动或烟气轮机甩负荷和发生故障时高温高压烟气的安全通道，旁路中的减温减压装置是其关键设备。

The effects of spouting velocity, fluidizing velocity and height of draft tube above distributor plate on gas bypassing have been investigated.

实验还得到固体颗粒循环量和气体旁路量随喷动气量和流化气量变化的规律，并对喷动口直径和导流管安装高度的变化对固体颗粒循环量和气体旁路量的影响作了研究。

What this invention has function of take a breath one kind publicly is wall hung inhaler, include: Noumenon, air suction opening, filter component, send fan, outside air blowhole, bypass, fender and eduction mouth; Outside air blowhole is formed go up in noumenon; Bypass is formed at the back of what the component filters inside noumenon, form outside air to flow to the passageway that sends fan directly; Fender setting is filtering on the face of have a common boundary of component and bypass, its position prep above filters component; Eduction degree of lip-rounding is become in noumenal before the bottom of face plate.

本发现亮相了一类具备换气效能的璧挂式空气air筛选器，包含：本体、吸进口、筛选零件、送扇子、外面空气air通气眼、旁路、档扳和排岀口；外面空气air通气眼产生在本体上；旁路产生在本身体之内筛选零件的后头，型成外面空气air直接流向送扇子的路线；档扳设定在筛选零件与旁路的边界面上，其位置高于筛选零件；排岀口产生在本体的前头扳的下部。

The operating pinch point was studied for a given HEN, and the change of operating pinch point was qualitatively analyzed.Bypass optimal control was proposed and the bypasses were placed around the operating pinch point.

本文从操作的角度求解并分析换热网络结构已定或网络正在运行情况下的操作夹点，定性分析操作夹点的变化规律，并提出在操作夹点附近设置旁路实现网络的旁路优化控制，从而将夹点技术应用于换热网络旁路优化控制中。

Operation analysis and investigation show that it is caused by the inappropriate design of hot vapor bypass control system, so the revamping has been carried out as follows: The diameter of hot vapor bypass pipeline has been enlarged from DN 40 mm to 80 mm, and the pressure difference of hot vapor bypass adjusting valve decreased from 50 kPa to 35 kPa; A vent pipeline for non-condensable gas fro.

改造的措施主要有：增大了热旁路管道的直径(由DN40mm增大到DN80mm)，并降低了热旁路调节阀的压差取值(由50kPa降低到35kPa)；增设一条自冷凝器壳程出口至回流罐的不凝气放空管道；对脱丁烷塔分程控制系统进行了改造，即将调节器输出信号的0-45%，55%%-100%分别用于控制热旁路调节阀和放空阀。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。