断开的

Irrespective of disconnection of a fan, control of the exhaust steam pressure, must be maintained.

注意ATTENTION：必须保持风机不被无端的断开，排气压力在控制之下。

ONLY AFTER "END" MESSAGE YOU SHOULD DISCONNECT YOUR DEVICE AND MAKE HARD RESET !!!

只有在"结束"信息后，你应该断开你的装置然后重新启动，这很重要。

The shape of the tooth is an involute helicoid.

牙的形状是断开线螺旋面。

Hyphenate without inquiry specifies that you will never be asked to manually hyphenate words that the hyphenation dictionary does not recognize.

自动分开指定将不会向您询问要求手动断开断字字典不认识的字。

The data were analyzed by using D-optimization method. Results show that lead styphnate, nickel hydrazine azide and BIPb3O4 are ignited by the SCB heat; lead picrate, lead azide, nickel hydrazine nitrate and barium styphnate are ignited by the SCB plasma.

通过研究示波器采集半导体桥引爆起爆药时的信号，获取了半导体桥释放能量、电压－时间曲线中二次峰持续时间、光信号出现时间以及电压断开时间等数据，并利用D最优化法程序对数据进行了处理。

The data were analyzed by using D-optimization method. Results show that lead styphnate,nickel hydrazine azide and B/Pb3O4 are ignited by the SCB heat; lead picrate,lead azide,nickel hydrazine nitrate and barium styphnate are ignited by the SCB plasma.

通过研究示波器采集半导体桥引爆起爆药时的信号，获取了半导体桥释放能量、电压-时间曲线中二次峰持续时间、光信号出现时间以及电压断开时间等数据，并利用D最优化法程序对数据进行了处理。

All this elements are disconnected from the floor and create the levitation effect, in which the project is floating.

所有这些元素是从地面断开，创造磁悬浮效应，该项目是浮动的。

A low-low pressurizer稳压器water level signal deenergizesall heater before they are uncovered to prevent heater damage.

在水位底发生之前，一个低的低稳压器水位信号断开所有加热器，以阻止加热器受损。

Disconnect differs inasmuch as a 'reasonable' default behaviour requires only that the mailslot handle be closed.

断开不同，因为作为一个'合理的默认行为只要求邮筒处理被关闭。

"NOW!" he yelled, as both Victor and Leonus leapt through the portal, and finally, Themesz himself, breaking his concentration long enough to make a dive for the faltering gateway.

"现在！"他喊道，莱昂纳斯和维克托立刻跳进传送门，终于斯么思也断开魔法连接，投入了吞吐的传送门。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。