斜度

The spiral angle of graduated circle was rough estimated by measuring the addendum circle diameter and modified on milling machine.

介绍了精确测绘单一斜齿圆柱齿轮齿形参数的简便方法，即测量公法线长度计算基圆齿距从而查表确定模数和压力角；测量齿顶圆直径估算分度圆螺旋角，用分度头在铣床上修正分度圆螺旋角，并进行误差分析。

Aiming at plastic parts with oblique angle concave and convex stage,a novel die oblique core pulling bodies——slider mechanism with lifter body was put forward.

针对带有斜角度凹穴、凸台的塑料件，提出一种新颖的模具斜抽芯机构——"斜顶式"滑块机构。

Results the safe angle range for needling yamen (gv 15) were: 16.27±7.68～29.46±7.23 degrees for males and 18.46±4.81—33.61±7.83 degrees for females; the danger angle of upward oblique insertion was negatively correlated with the extension of bowing and raising the head, that is, the larger the angle of backward raising the head, the smaller the range of danger angle of needling into the great occipited foramen.

结果：得出哑门穴安全针刺角度，男性为16.27±7.68～29.46±7.32度，女性18.46±4.81～33.61±7.83度。且向上斜刺的危险角度范围与头颅俯仰程度呈负相关，即头颅后仰角度越大，刺入枕骨大孔的危险角度范围越小。

Surface electromyographic activity was recorded bilaterally from the sternocleidomastoid, anterior scalene, cervical extensor and UT muscles.

记录胸锁乳突肌两端、前斜三角肌、颈伸肌及上斜方肌的表层肌电活动度。

The sloping plate can provide sufficiently the under-cooling for nucleation and lay a foundation for heterogeneous nucleation to form lots of nuclei of crystal internally and on the sloping plate surface, thus causing the melt to nucleates eruptively. Under the action of both metal flow and vibration, the nuclei formed on the sloping plate surface can move freely and disperse into the melt, and they are able to maintain the direct growth in spherical shape in the homogeneous composition and temperature fields.

倾斜板为形核提供足够大的过冷度和异质形核基础，大量晶核在斜板表面和内部形成，使熔体爆发形核，在流动和振动作用下斜板表面形成的晶核游离，弥散到熔体内部，晶核在均匀的成分场与温度场条件下，可以保持直接球状生长。

Results show that amplitude of displacement excited by vertical incidence wave is larger than that excited by inclined incidence wave and not influenced greatly by the incidence angle. In vertical incidence, amplitudes of displacement of two points at the same altitude along each cavern are basically identical and maximum relative displacement occurs between top and bottom point of the cavern. While in the case of inclined incidence, displacement amplitude on sides meeting the wave is larger than that on leed sides, and maximum relative displacement occurs on left skewback and bottom of the cavern.

结果表明，位移幅值受入射角度的影响不敏感，竖直入射比斜入射情况要大；竖直入射时，各洞室两侧同一高程处的位移幅值基本相同，相对位移差最大部位为洞顶与洞底，而斜入射时迎波面比背波面一侧位移大，且相对位移差最大部位为洞室迎波面的左拱座与洞底。

We chose 30 type milli-needle as tools after routine sterilization. Usually we pick levelly 0.5-0.8 inch at Baihui, 1. 5 inch at Jiaji, 1-1. 5 inch inclinedly to the nose tip at Fengchi, 1-1. 5 inch inclined at Jianjin, 1-1. 5 inch at Shousanli. After obtaining gas by rotating method, we used moxibustion at Baihui by lighting the moxa strip, and put the acupuncture and moxibustion therapeutic instrument (made in shanghai, G6805-Ⅰ) at other acupuncture points. We chose thin and dense wave and adjust the current strength according to endurance of the patients, and 20 minutes each time, one time every other day, 15 times a course.

操作：患者俯卧位或坐位，选30号毫针，常规消毒，管筒进针，进针后百会穴平刺0.5～0.8寸，夹脊穴直刺1.5寸，风池穴针尖微下，向鼻尖斜刺1～1.5寸，肩井斜刺1～1.5寸，手三里直刺1～1.5寸，行捻转法得气后，将艾条点燃后于百会穴上行温和灸，其余各穴接上海产G6805-Ⅰ型针灸治疗仪，用疏密波，电流强度以病人能耐受为度（其中风池穴的电流强度以偏小为宜），每次20分钟。

This investigation shows that exotropia was found more frequently in distance lateral phoria in myopes. Stereopsis acuity negatively correlated with the degree of my-opia and subjects with a lower stereopsis acuity had a higher degree of myopia. There was no significant correlation between distance lateral phoria and stereopsis acuity.

本组近视眼视远时水平隐斜视中，外斜偏多；立体视锐度与近视屈光度呈正相关，立体视锐度较差者多分布于近视眼度数较大患者中；近视眼人群中视远时水平隐斜视和立体视锐度无显著相关。

When selecting well location and optimizing design plan, the authors advocate sticking to the following principles including restricting hole deviation, barefoot interval and horizontal displacement in the scope of 35 degrees, 400 meters and 200 meters respectively, trying to decrease the work of changing direction and hole deviation to ensure smooth borehole and increasing the quality of sidetracking and cementing wells and the results of oil increase.

在进行井位筛选和优化设计方案时应遵循的原则是：将井斜、裸眼段长、水平位移分别控制在35度、400米、200米之内，尽量减少变方位变井斜的工作量保证井眼平滑，提高侧钻井固井质量和增油效果。

The baroclinicity was enhanced by the complex mountains (steepened the isentropic surface), which made the enhancement of vorticity concentrated downward at the low troposphere and so reinforced the development of surface cyclone.

阿尔泰—萨彦岭山地通过对低层冷空气的阻滞使山地上空等熵面更为陡立，加强了对流层低层的斜压强迫，从而使斜压强迫的涡度增长向低层聚集，导致气旋发展强度增强。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。