整机

The flexible projecting shaft is long, can reduce rigidity of transmission system greatly, improve joggle state of gears, reduce failure rate of gear pair and transmission system, and enhance reliability of whole machine.

所述柔性悬臂轴较长，能够显著降低传动系统的刚度，改善齿轮的啮合状态，降低齿轮副乃至传动系统的故障率，提高整机可靠性。

The whole equipment is with the 40-pin AT89C51 MCU produced by the American ATMEL company at the core, introduced take it as the control system LED lattice electron display monitor dynamic design and the development process.

整机以美国ATMEL 公司生产的40脚单片机AT89C51为核心，介绍了以它为控制系统的LED点阵电子显示屏的动态设计和开发过程。

The whole equipment is with the 40-pin AT89C51 MCU produced by the American ATMEL company at thecore, introduced take it as the control system LED lattice electrondisplay monitor dynamic design and the development process.

整机以美国ATMEL公司生产的40脚单片机AT89C51为核心，介绍了以它为控制系统的LED点阵电子显示屏的动态设计和开发过程。

The whole equipment is with the 40-pin AT89C51 MCU produced by the American ATMEL company at thecore, introducedtake it as the control system LED lattice electrondisplay monitordynamic design and the development process.

整机以美国ATMEL公司生产的40脚单片机AT89C51为核心，介绍了以它为控制系统的LED点阵电子显示屏的动态设计和开发过程。

Based on the principle of light-pen mode non-track three dimensional coordinate measuring technology, the paper uses PSD as the photoelectric receiver and point light modulated by frequency to measure coordinates.

本文通过对光笔式无导轨三坐标测量的研究、提出了以PSD(Position Sensitive Detectors，位置检测传感器)作为光电接收传感器，用高频调制光作为点光源，进行位置坐标测量的新思路，以提高整机的精度。

If entire machine overload 2%-5%, motion crossbeam limiting position, hydraulic system overpressure protection and so on

如整机超载2%～5%、移动横梁极限位置、液压系统超压保护等

Subsequently describes in detail the method of motion simulation of complete machine and the setting of motion analysis's scheme and the setting of link and the setting of motion drivers of joints.Also discusses the adjustment methods of the working part apa...

同时，详细阐述了整机运动仿真的方法和运动分析方案及连杆和运动副运动驱动的设置；介绍了工作部件距地面高度的调整方法，建立了机具前进速度、工作部件旋转速度与棉株间距之间的关系，为机具的设计提供必要的理论依据。

The miniature and capable products will play an important role in linker market.

随着整机系统的小型化，未来小型RF产品将在连接器市场上占有重要的地位。

The simulation results of the blade root load and the power curve of aerodynamic performance on the wind turbine are obtained.

使用这些全攻角翼型气动性能数据，在Bladed软件中建立风电机组的叶片模型，分析计算该叶片的气动性能、整机功率曲线等性能。

Computer-control is utilized and working parameters of bearings, such as load, displacement,...

通过100余万次的试验考核证明整机性能良好，运行可靠，能够满足国内主机厂家对离合器分离轴承模拟试验的要求，具有较高的推广和应用价值。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。