改变位置

The multi-blade cutting which exceeded two-blade occurred for the reason of matching among parameters of speed of rotation, forward velocity, and numbers of blades, and it could be avoided; different oblique angle would lead to different passing through distance of the blade, and it is equivalent to different blade thickness in cutting; different position of sugarcane to basecutter would influence on the stress of the stubble when being cut.

给出了甘蔗受到多刀切割和重复切割刀数的计算公式，出现多于两刀切割的现象主要是由于刀盘转速、收获机前进速度和刀片数之间的匹配问题，是可以避免的。刀片安装角度影响刀片切入甘蔗所经历的路程，并且相当于改变了实际切入甘蔗的刀片厚度。甘蔗和根切器的相对位置影响根茬与刀片之间的作用力。

When the moon changes it position, so do the orientation of the tide-generating forces and the position of the equilibrium tide.

当月亮的位置改变时，引潮力的取向和平

The three-wire configuration simplifies connection, and makes reversing the motor's direction simply a matter of switching the position of two leads.

三线配置简化了连接过程，只需要准换一下两根导线的位置就可以改变电机的运转方向。

If changing the position or method of grounding doesn't correct the problem, the porosity can usually be eliminated by placing a one-inch tack weld at the finish before welding the seam.

如果改变接地的位置和方法还不能解决这个问题，我们可以在焊接这前在尾部增加一块收弧板这个问题就可以排除了。

The space-filling curve and the method of fixed row layout are used to reduce the searching spaces. The methods of two-stage layout and fixed row layout are used to solve the problems of irregular shape of departments. It is assumed that department area to be variable within some extent for implementing the exchange of department locations with different area among different floor.

提出用&定行法&和&空格填充线法&缩减搜索空间，用两阶段法（优化位置-调整面积形状）和&定行布置法&解决部门面积形状不规则的问题；对于多层厂房优化布置，提出按固定楼层布置顺序、改变部门布置顺序的方法缩减搜索空间；假设部门面积可在一定范围偏差，实现楼层间不同面积部门对调。

The space-filling curve and the method of fixed row layout are used to reduce the searching spaces. The methods of two-stage layout and fixed row layout are used to solve the problems of irregular shape of departments.

提出用&定行法&和&空格填充线法&缩减搜索空间，用两阶段法(优化位置-调整面积形状)和&定行布置法&解决部门面积形状不规则的问题：对于多层厂房优化布置，提出按固定楼层布置顺序、改变部门布置顺序的方法缩减搜索空间；假设部门面积可在一定范围偏差，实现楼层间不同面积部门对调。

The results show that:(1) The space-charge fields(include dc space-charge fields and ac space-charge fields) have important effect on the beam-wave interaction output power, make the saturated output power lower, saturated position delay;(2) The back-radio excited by the electron beam has little effect on the output power, and can be ignored;(3) The transverse motions of electron beam has some effect of the output power;(4) The means of phase velocity taped and bunch compression can improve the relativistic TWT efficiency, especially bunch compression can greatly improve the efficiency.

五、分析了相对论行波管三维非线性特性，分析结果表明：(1)空间电荷场（包含直流和交流空间电荷场）对注波互作用输出功率影响很大，会造成饱和输出功率减小，饱和位置推后；(2)电子注激发的反向辐射对输出功率影响比较小，基本上可以忽略不计；(3)电子注横向运行对注波互作用的直接影响比较大；(4)通过改变耦合腔内半径来调节慢波结构相速，采用相速跳变和预群聚的方法可以改善相对论行波管的效率，特别是采用预群聚方法，可以尽量提高相对论行波管的效率。

Bone strength, determined using quantitative ultrasound measurement of bone speed of sound at the middle left tibial shaft, decreased significantly in the control group from 2,892 30 m/sec at baseline to 2,799 26 m/sec at four weeks. However, bone SOS of the exercise group remained stable (2,825 32 m/sec at baseline and 2,827 26 m/sec at four weeks). Despite improvement in bone SOS with exercise, there were no accompanying changes in markers of bone formation and resorption.

研究使用超音波测量骨骼声波速度来数量化评估骨骼强度，测量的位置是婴儿的中间左侧胫骨干，研究显示，对照组的婴儿显著减少了骨骼强度，从基线2，892 ± 30 m/sec降到四周时的2，799 ± 26 m/sec，但是锻炼组的骨骼SOS维持稳定(基线：2，825 ± 32 m/sec，四周：2，827 ± 26 m/sec)，虽然锻炼可以改善骨骼SOS，但是骨骼形成和再吸收指标并没有跟著改变。

The simulation outcomes show that the control strategy is very effective to Shunt-wound APLC. 3. This chapter analyzes vibration of a traditional servo motor include relay with place and time lag, and brings forward fuzzy control scheme, changes the time of control action in the place delay zone, When reaching the balance point, system will be freedom movement. Theory analysis and simulation outcome all prove that control arithmetic is right.

针对一类带位置、时间滞后的继电器型伺服系统，分析其产生抖动的原因，并在此基础上提出了改善一种特定的带有继电器的伺服电机模糊控制策略，在继电器空间滞后区改变控制作用时间的大小，在靠近平衡点附近引入自由运动。

Mechanical manufacturing process, every change the shape, size production target, location and nature, make the finished product or process known as process of semi-finished products.

机械制造生产过程中，凡是改变生产对象的形状、尺寸、位置和性质等，使其成为成品或半成品的过程称为工艺过程。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。