操作者

Because of this difficulty in closing, operators commonly use wrenches and other persuaders on the valves.

由于关闭困难，操作者一般都在阀门上使用扳手和其它强制性工具。

They should not be operated on an unrestricted, high speed air drill. The tufts will flare outwards which may destroy the tool and could cause injury to the operator.

请勿在无速度限制的高速风钻上使用，否则可能产生火花，损毁工具、甚至造成操作者的损伤。

It adopts sliding lever thread take-up,vertical rotating hook,precise gear for driving arm shaft and hook shaft.With 178 mm height of post -bed and rolling feet,it gets a wide work space and easy operation.

高度178mm的柱式缝台，配合滚轮压脚，令操作空间宽敞，缝制回旋翻转灵活，旋钮式针距调节装置及杠杆式倒缝装置，使操作者更轻松。

Xi'an Housing Bank, the development momentum is very good, but how to learn from others, learn from others, this pole banner curb, the operator should be the focus of the problem.

西安的房屋银行，发展的势头应该是很不错的，但如何借鉴他人，取长补短，把这杆旗帜打下去，应该是操作者的重点把握的问题。

Air wrench operation speeds up cycle time on high gear ratio bevel gears however, the mechanical advantage available from bevel gearing enables the operator to damage the valve.

气动扳手操作加快了高齿轮传动比伞齿轮装置的循环速度，但是，其伞齿轮的机械增益使得操作者可能对阀门造成破坏。

Axotomized, turn the paper of the cam disconnect switch on the side of the circuit, forcing 3XK press paper cutter and a loss of power, but the operators have not yet had enough time to release the button, turn the paper cutting of the cam over the limit switch 3XK, 4J and 1 c was electric pick-up, gnashing paper cutter does not reset, in this case, a rotating cam on the other side lost your limit switch XM, intermediate relay 5J load-disconnected.

纸张切断后，转动的凸轮一侧断开行程开关3XK的回路，迫使压纸和切纸断电，但是操作者还未来得及松开切纸按钮，转动的凸轮滑过行程开关3XK后，4J和1C仍得电吸合，造成切纸刀不复位，这时，转动的凸轮另一侧断开了行程开关XK，中间继电器5J失电断开。

Appropriate nimble power the FMTS-PON of science and technology cooperates Anritsu MP1763C to use in rear control the 1/8 Channel on electric board and the pattern that produces PON, and control the relevant Timing Sequence that it offers, depend on besides the rate of OLT receiver, in pile up a test by accident applicable also in Anritsu MP1764C or MP1632C, because the handlers of this MP1764C and MP1632C borrows,can upgrade immediately by FMTS-PON.

宜捷威科技的FMTS-PON配合Anritsu MP1763C操纵在后方节制电板上的1/8 channel而发生PON的模式，而且节制它供给的相干timing sequence，除此之外取决于OLT领受器的速度，在误码测试也合用在Anritsu MP1764C或MP1632C，是以MP1764C与MP1632C的操作者借由FMTS-PON能够立即进级。

Therefore I say:'O Mother, I am the machine and Thou art the Operator; I am the chariot and Thou art the Driver.

因此我说：'母亲，我是机器，你是操作者；我是战车，你是车夫。

11 Operators reexamine their counting result to the identical plate, its difference should in 5%, but other people to this plate iteration count, its difference should in 10%.

4.5.11 操作者对同一平板复核自己的计数结果，其差异应在5％之内，而其他人对这一平板重复计数，其差异应在10％之内。

In addition to the above reasons, the cutting speed is too slow, cutting torch and the workpiece vertical degrees, as well as the operator of the plasma cutting machine familiarity with the operational level, have affected the stability of the plasma arc, the user should pay attention in these areas .

除以上原因外，切割速度过慢，切割时割炬与工件的垂直度，以及操作者对等离子切割机的熟悉程度，操作水平等，都影响等离子弧的稳定性，使用者应在这些方面注意。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失