摆动

A gear sector is mesh ed with the worm gear; rotation of the worm gear causes the gear sector to rotate.

蜗杆齿带动齿扇转动，齿扇与蜗杆齿啮合，这使的与齿扇相连接的转向摇臂左右摆动。

A pendulum vibrate s seconds.

钟摆以摆动计秒。

A pendulum vibrates seconds .

钟摆摆动计秒。

A pendulum vibrates seconds.

钟摆摆动计秒。不适合

A pendulum vibrates seconds.

钟摆摆动计秒。收藏

A pendulum vibrates seconds.

钟摆以摆动计秒。

A pendulum vibrating seconds.

钟摆以摆动指示秒数。

Shale, screen your worry from what you won't ever find Don't let it fool you Don't let it fool you...down Down's sitting round, folds in the gown Sea and the rock below Cocked to the undertow Bones blood and teeth erode, with every crashing node Wings wouldn't help you Wings wouldn't help you...down Down fills the ground, gravity's proud You barely are blinking Wagging your face around When'd this just become a mortal home?

唐氏症坐在轮，褶皱的长袍大海和岩石下面竖起的暗流骨骼和牙齿的侵蚀血液，每个节点崩溃翅膀不会帮助你翅膀不会帮助你。。。向下羽绒地面，重力的骄傲你仅仅是闪烁你的脸左右摆动这只是成为一个致命的家？

The principle that the cylinder drive swing lever to promote scraper plane rotation, so close to the blade surface Dryer (adjusted for normal 1-1.5mm) non-contact dryer, and then to the red balloon gas pressure, air pressure to promote post-marked increase on the blade Pressure, so that the blade surface close to Dryer.

其原理为，气缸推动杠杆摆动带动刮刀架转动，使刮刀靠近烘缸面（一般调为1-1.5mm）不接触烘缸，然后给气囊冲气加压，气囊推动后压标对刀片加压，从而使刮刀紧贴烘缸面。

Cut file, sawing skills by learning the grip, standing position, body movements, and many other points force factors and the impact of the traditional grip of the emergence of file-grip handle to stand up after slightly outside the site of the palm, when a file cut Force, after the file handle a gradual shift,"hold" to "grasp", resulting in the introduction file enough; saw grip handle full point higher than the thrust of the saw blade to install center hole of about 30mm, the high point of thrust is likely to result in the bow saw On both sides of the swing, resulting in a broken saw blade and saw seam askew.

锉削、锯削技能的学习是受握法、站立部位、身体动作、作用力点等诸多因素的制约和影响的，传统的握法出现握锉柄后顶住部位稍偏离手心，锉削时一用力，锉柄逐渐后移，&握&变成&抓&，造成锉刀推出力度不足；满握锯柄的推力点高于锯条安装孔中心约30mm，偏高的推力点很容易造成锯弓向两侧摆动，造成锯条折断及锯缝歪斜。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了