提取公因子
- 与 提取公因子 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Factor analysis showed that each module was abstracted four factors and the total contribution rate was more than 50%, the result after varimax rotation was consistent with the theory.
因子分析结果显示:各个模块分别提取4个公因子,累计贡献率均在50%以上,采用方差最大旋转后的结果与理论构想一致。
-
Farther apply FactorAnalysis, principle of pick-up is latent root>1, using Varemax and Equamax to rotatefactor. We get 10 factors, combined with medical knowledge, based above result,clinical manifestation of sub-health status can split into 7 types, such as typesociety(Factor 6), type psychology(Factor 1), type fatigue(Factor 3,Factor 4,Factor 9),type discomfort of eye and mouth(Factor 7), type abnormity of stool and urine(Factor2), type menoxenia(Factor 5) and type consticution(Factor 8 and Fator 10). Thisprovide basis for classification, prevention and cure of sub-health status.
进一步应用因子分析,以特征根大于1为公因子提取原则,应用最大方差正交旋转法进行因子旋转,共得到十个共因子,结合医学知识,根据上述结果亚健康状态的临床表现可分为社会型(公因子6)、心理型(公因子1)、疲劳型公因子3、公因子4(来源:23ABC论文网www.abclunwen.com和公因子9、眼口不适型(公因子7)、二便异常型(公因子2)、月经不调型(公因子5)以及体质型(公因子8和公因子10)等七个亚型。
-
Methods Measure the T scores of pilots.Extract six common factors of P,N,I,M,A,F with major com ponent analysis and get the loading matrix and factor construction by varimax or thogonal rotation.
测查MMPI的飞行员T分值,采用主成分分析法提取P、N、I、M、A、F6个公因子进行方差极大旋转,得出因子负荷矩阵和因子结构状况。
-
Results:Test retest reliability,half division reliability,Cronbach α coefficient,θ and Ω coefficient of A DQOL are 0 823 6,0 796 3,0 869 9,0 906 0 and 0 916 3 res...
结果 :A-DQOL 的重测信度为 0 。82 36 ,折半信度为 0 。796 3,克朗巴哈α系数为 0 。86 99,θ系数为 0 。90 6 0 ,Ω系数为0 。916 3;规定提取 3个公因子,利用主因子因子分析法进行分析表明,A- DQOL 具有良好的结构效度。
- 推荐网络例句
-
However, as the name(read-only memory)implies, CD disks cannot be written onorchanged in any way.
然而,正如其名字所指出的那样,CD盘不能写,也不能用任何方式改变其内容。
-
Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.
镀锌钢托盘多用于出口,替代木托盘,免薰蒸,符合欧盟、北美各国对出口货物包装材料的法令要求;喷涂钢托盘适用于重载上货架之用,托盘表面根据需要制作成平板状、波纹状及间隔形式,满足不同的使用要求。
-
A single payment file can be uploaded from an ERP system to effect all pan-China RMB payments and overseas payments in all currencies.
付款指令文件可从您的 ERP 系统上传到我们的电子银行系统来只是国内及对海外各种币种付款。