控制的

The digital control of motor is the development trend of the motor control.

电动机的数字控制是电动机控制的发展趋势。

Applying the load of 50% STS1RM during STS movements increased knee moment and also improve anterior-posterior movement control in some children with spastic diplegia. The loaded STS training may be clinically used for strengthening and movement proficiency enhancement.

在坐到站动作过程当中，中度荷重可以有效增加膝关节之伸直力矩，并改善部分脑性麻痹儿童在前后方向的动作控制，故中度荷重坐站可以作为临床肌力训练和促进坐站动作控制的方式。

A modified method of direct torque control is proposed based on the analysis of convetional scheme.

通过对传统直接转矩控制的分析，提出了一种直接转矩控制的改进方法。

The main problem in the existing system is that maximum power control is separate from charging and discharging control.

上述系统主要的问题是缺乏最大功率跟踪控制和蓄电池充放电控制的统一考虑。

Present the research results about servo control error characteristics and a practical rule and method for error parameter distribution.

研究了APT伺服控制的误差特性，并提出了"针对伺服控制系统的误差分配准则和具体方法"。

After that, it talks about the connotation of internal domination of commercial bank, and establishes the principle of internal domination that should follow.

接着谈到商业银行内部控制的内涵，建立内部控制应遵循的原则。

DSTATCOM is designed with double loop control method of predictive current and 3 - level inverter for its main circuit.

DSTATCOM采用预测电流控制的双环控制方法和三电平逆变器的主电路设计。

It is proved that the control logic using PI controller based on driving wheel slip rate work efficiently in simulation.

基于驱动轮滑转率控制的PI控制方法经过仿真验证是有效的。

At last the actual image validates the control algorithm correctly and efficaciously.

最后给出增益控制的实际效果图，验证了控制流程的正确性和有效性。

A method to control the electrization of resistance welding machine s with a distributed control system is presented.

介绍对电阻焊机通电进行集散控制的方法，着重阐述中心控制系统的设计和使用方法。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。