接缝宽度
- 与 接缝宽度 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Wooden floor installation checks and accept a standard: Material should accord with resident requirement and active product standard; The floor is installed should firm, breathed noise, without become loose; Wooden floor surface should plane burnishs, wait for a phenomenon without broken bits of dig mark, dig and burr, the floor of besmear varnish its design should clear; Juncture of floor spelling a flower is answered neat, aperture width is consistent, the surface is clean, without excessive glue phenomenon; Skirting board and floor connection are close; The edge on skirting board is flat, differ high endlong should not be more than ± 3 millimeter and metope are clingy, without aperture.
木制地板安装验收标准:材料应符合住户要求及现行产品标准;地板安装应牢固、无声响,无松动;木地板表面应刨平磨光,无刨痕、刨渣和毛刺等现象,涂清漆的地板其图案应清晰;拼花地板接缝应对齐,缝隙宽度一致,表面洁净,无溢胶现象;踢脚板与地板连接紧密;踢脚板上沿平直,全长高差应不大于±3毫米与墙面紧贴,无缝隙。
-
The contact condition of cement concrete 's face plate with denudation affect not only road's joint space and joint gap, but also road's early stage cracking.
水泥混凝土面板与基层接触状况不仅影响路面接缝间距和接缝宽度,同时也对路面早期开裂产生影响。
-
And the loading dock is that in the letter by shell layer between the upper and lower, stick a thread with the order of rtensite, General and mandril of the same width, punch holes in the 2 above.
和合装的装法是,在封壳里层的上下接缝处,各粘一条供穿线联订用的板条,一般与内芯订口的宽度相同,上面打孔2~3个。
-
By studying the processing properties of the self-leveling HM199 room temperature vulcanized sealant for airport runway joint ,it is revealed that the appropriate ratio of the sealant injection depth to the width of joint is 1∶2,but the injection depth should be no less than 6mm,and the recess from pavement to sealant is 3 mm to 7 mm.
阐述了机场跑道接缝密封剂和衬垫材料应具备的性能;通过对自流平型HM199室温硫化密封剂灌注工艺性能的研究,提出密封剂的灌注深度与接缝宽度的最佳比为1∶2,灌注深度最小不低于6 mm,密封剂顶部与道面的距离为3~7 mm。
- 推荐网络例句
-
So that more consumers can enjoy more delicious quality, technology is even better than wine.
让更多的消费者可以品尝到品质更为鲜美,工艺更为精湛的葡萄酒。
-
Open it in your favorite text editor .
在你最喜爱的文本编辑器中将它打开。
-
Bone skid in the ischial defect.
30°,将股骨端插入坐骨槽中。