接线的

B. Make connections of wires to terminals of lamp holders and other accessories in a neat and workmanlike manner and which are electrically and mechanically secure, with no loose strands protruding.

B。光源灯座接线端子和其他附件之间的接线要采用灵活的便于手工操作的方式，并且要保证电气和机械上的安全，不得有松脱的现象。

An accident of protection maloperation of out-zone faults is discussed,which is caused by the misconnection of the secondary circuit.

通过对一次线路因保护二次误接线而引起的线路保护区外故障误动事件的经过及线路两侧保护动作情况所进行的详细分析，并结合RCS-902B保护的特点及接线方式探讨了保护动作的原因。

The selection of the main transformer's capacity is based on an eight-year development blueprint, and its overload capacities during normal operation as well as accidents have also been contemplated. The design adopts single inner-bridge connection for the 110kV voltage level, and sectionalized single-bus as the main connection for the 10kV voltage level.

主变压器容量根据8年的发展规划进行选择，并考虑主变压器正常运行和事故时的过负荷能力。110kV电压等级采用单内桥接线方式供电，10kV电压等级采用单母分段的主接线方式供电。

First removed the external electrical wiring, and do a good job in marking, for example, asynchronous motor, three-phase power should be prepared with the corresponding tag line for the DC motor, and Patrick do a good job should be winding, armature winding, etc. corresponding with the external wiring tags.

先拆下电机的外部接线，并做好标记，例如对于异步电动机，应做好与三相电源线对应的标记，对于直流电机，应分别做好并励绕组、电枢绕组等与外部接线对应的标记。

The design structure characteristics of the telephone connects the line box are two times parting planes with pin gate style, and side core-drawing structure.

本次设计分析了电话接线盒的塑件工艺特点，详细介绍了电话接线盒的结构设计和模具设计的过程以及要点。

Junction Box 1 is the outside junction box, while outside access, while access to the indoor circuit.

接线盒1是门外的接线盒，一边接外线，一边接通向户内的线路。

We provide you with the following high-quality components, you need to improve the reliability of the equipment: signal isolation / transmitter, relay / optocoupler, lightning / surge protector, switching power supply, with a total Line interface, filter / anti-modules, industrial connectors, sensor / actuator interface module, printed circuit board connector, on-site joint boxes, terminals, the button / indicator light, control / Bus cables and other products.

我们为您提供下述的高品质元器件，以提升您所需设备的高可靠性：信号隔离/变送器、继电器/光电耦合器、防雷/浪涌保护器、开关电源、总线接口、滤波器/抗干扰模块、工业用接插件、传感器/执行器接口单元、印刷电路板接插件、现场接线箱、接线端子、按扭/指示灯、控制/总线电缆等产品。

Parallel wiring provides for maximum amplifier output, while series wiring lets you configure multiple woofers to one amplifier at an acceptable impedance.

平行的接线提供最大放大器产品，当系列接线让您配置多台低音扬声器对一个放大器在可接受的阻抗。

The first and second power supply wirings are interlayer-connected by a first via at a crossing area where those power supply wirings cross each other.

该第一和第二电源接线通过位于这些电源接线相互交叉的交叉区域的第一通孔进行层间连接。

One structure of using V/v connection and three phase three leg converter under direct or BT supply, one structure of using two single phase converter and V/x connection under AT supply are both researched and simulated detailed.

系统整体结构设计后，以直接供电或BT供电方式下，采用V/v接线变压器和三相三桥臂变流器，及AT供电方式下，采用V/x接线变压器和两个共用一直流环节的单相变流器的系统结构为对象，分别进行详细研究和仿真。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。