接线

There is also considerable voltage drop in the consumer's internal wiring.

在用户内部接线中也存在相当的电压降。

This paper advances the idea of measuring power of three-phase load,by using one Wattmeter,and draws circuit.

系统研究、总结了通过使用一只瓦特表测量得出三相负载的总有功功率和无功功率的思路，并给出接线电路图。

Some noticeable problems in application of low power factor wattmeter are presented in detail, such as measure principle and readout method. The connection modes in various measured power are discussed.

详细介绍了低功率因数瓦特表在测量中应该注意的问题，给出了功率表的测量原理和读数方法，讨论了测量不同功率时的接线方式。

With this important concept which the reads of wattmeter was equal to the product of the effective value of the voltage across the potential coil, the effective value of the current flowing in the current coil, and the cosine of the phase-angle between the current and the voltage. It was speciled with some examples to determine the phase-angle measured between line voltage, line current in different connection.

围绕有功功率表的读数等于该功率表电压线圈所接电压的有效值、电流线圈所通过的电流的有效值以及电压与电流相位差余弦的乘积这一重要的概念，用实例说明在不同的接线情况下如何利用各电量的相量关系来确定所测的线电压、线电流之间的相位差角。

The American Wire Gauge system used in North America and the European Harmonized types.

在美式系统中，电缆是以接线号标称。

Ground the water heater by connecting the grounding wire from the electrical service ground to the ground screw located in the junction box .

热水器的接地通过从电气装置上将接地线连接到位于接线盒上的接地螺丝上实现。

Here is a wiring diagram for the star configuration that I have found from the net.

这里是一个接线图，为明星的配置，我发现从网。

Consider line 020 in the wiring diagram.

考虑接线图的020线。

Harry Beck's easy to understand design was based on an electrical wiring diagram.

哈利Beck的易于理解的设计是根据电气接线图。

Before attempting to wire the system together, create an accurate wiring diagram for the entire system.

在将系统连接在一起之前，请绘制一幅准确的系统接线图。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。