接线

Responsible for cabling according to the scheme, and also be capable of fulfilling the system test at jobsite.

在工地，负责按图纸完成设备的接线工作，并能对整套设备进行调试。

These days, other more modern termination devices (such as Krone Boxes, 110-connecting blocks, and even 66- blocks) are replacing binding posts.

如今，其它更为先进的终端设备（如Krone接线盒、110连接块和66连接块）替代了原来的接线柱。

A resistor is connected between the output end of the live wire and the output end of the earth wire, another resistor is connected between the output end of the null line and the input end of the earth wire, a neon lamp in a photoelectric coupling switch is connected at the two ends of the earth wire switch in parallel after being connected with the resistors in series, one end of a light sensitive resistor in the photoelectric coupling switch GR2 is connected with the anode DC+ of an integrated circuit IC power in the creepage protector, the other end of the light sensitive resistor is connected with the anode of a diode D3, the cathode of the diode D3 is connected with the triggering pole of the silicon-controlled rectifier SCR in the creepage protector, the neon lamp and the light sensitive resistor are positioned into a dark box, and a small hole which avoids the light sensitive resistor is formed on the dark box.

一种防止地线触点未导通的全能安全插头，包括各带开关的地、零、相三线接线和由零序互感器、脱扣器、放大器、整流器、试验回路和可控硅组成的漏电保护器，所述的火线输出端、地线输出端间连接电阻，所述的零线输出端、地线输入端间串接电阻，光电耦合开关内的氖灯与电阻串联后并联在地线开关两端，光电耦合开关GR2内光敏电阻的一端与漏电保护器内的集成电路IC电源正极DC＋连接、光敏电阻的另一端与二极管D3的正极连接，二极管D3的负极与漏电保护器内的可控硅SCR触发极连接，氖灯和光敏电阻置于暗箱中，暗箱上开一避开光敏电阻的小孔。

After being connected with a resistor in series, the primary input end of a transformer is connected with the output end of the live wire and the output end of the null line in parallel, the secondary output end is connected with the two ends of the earth wire switch in parallel after being connected with another resistor in series, one end of a neon lamp in a photoelectric coupler is connected with the input end of the earth wire E and a secondary end of the transformer, the other end of the neon lamp is connected with the centers of the two resistors, one end of a light sensitive resistor in a photoelectric coupling switch is connected with the anode of an integrated circuit power in the creepage protector, the other end of the light sensitive resistor is connected with the anode of a diode, the cathode of the diode is connected with the triggering pole of the silicon-controlled rectifier in the creepage protector, the neon lamp and the light sensitive resistor are positioned into a dark box, and a small hole which avoids the light sensitive resistor is formed on the dark box.

防止地线触点未导通的全能安全插头，包括各带开关的地、零、相三线接线和由零序互感器、脱扣器、放大器、整流器、试验回路和可控硅组成的漏电保护器，变压器初级输入端串联电阻后并接在火线输出端和零线输出端，次级输出端与电阻串联后并联在地线开关两端，光耦内氖灯的一端与地线E输入端和变压器次级的一端连接，氖灯另一端与二电阻的中心连接，光电耦合开关内光敏电阻的一端与漏电保护器内的集成电路电源正极连接、光敏电阻的另一端与二极管的正极连接，二极管的负极与漏电保护器内的可控硅触发极连接，氖灯和光敏电阻置于暗箱中，暗箱上开一避开光敏电阻的小孔。

The Lowboy Heaters will be wired inter -locking (non-simultaneous) 240 volt/3-phase operation with 4500 watt elements (can be converted to singlephase operation at terminal block as well as simultaneous operation).

矮式热水器电源配置交互锁定240伏；3相、4500瓦的加热棒(在接线盒里，可以转换为单相运行方式和同步运行方式)。

Source Module to provide digital modulation module base-band and bit synchronization signal BS (in experimental circuit board connected Link without manual wiring).

信源模块向调制模块提供数字基带信号和位同步信号BS（已在实验电路板上连通，不必手工接线）。

Use megohmmeter of 2500V for measurement,the megohmmeter must be checked and was ok , supply power to phase need testing and measure 12 insulation,write down the measurement values in 15"and 60",the ratio of R60 and R15 is namely the absorption ratio;stop measuring after 1 minute,make discharging for phase tested,measure insulation resistance for the other two phases.

3.6.2 测量绝缘电阻与吸收比： measure insulation resistance and absorption ratio 采用 2500V 兆欧表进行测量，兆欧表校正无误后，接通被试相进行绝缘测定，并分别记录 15"和 60"时的兆欧表示值，R60 和 R15 之比值即为吸收比， 1min 后停止测量，并对被试相放电后，改接线测量另两相的绝缘电阻。

If everything was ok,first test the test circuit without load in the conditions of parts to be tested not being connected,the test voltage will be increased by stages according rated voltage,each stage will be kept for 1 minute, write down the measurement values of microampere meter,then reduce voltage to zero and switch off power,make discharging for phase tested, measure insulation resistance for the other two phases.

并对被试相放电后，改接线测量另两相的绝缘电阻。在规定的试验电压下，各相泄漏电流的差别应不大于最小值的 100%。

Design of graphic software for power network diagram based on common information model in IEC

基于IEC 61970公用信息模型的电网接线图形软件的设计。

Yes, operator. I'm trying to call New-York.

是，接线生，我要打到纽约。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。