损耗

With the technical information of the Transistor used, the loss calculating method is given in this paper.

结合电源电路采用的各管子的技术资料，给出了计算损耗的方法，并在分析这些主要损耗的基础上，通过采用软硬件结合的方法，有效解决了损耗问题。

Measures for decreasing the elec ˉtrode loss are put forward,which has certain significance to the improvement of cavity machining quality by EDM and to the realization of high-efficiency and low-loss machining.

从吸附效应、极性效应以及电参数的合理匹配等方面分析了影响电极损耗的因素，提出了降低电极损耗的措施，对提高电火花型腔加工质量、实现"高效低损耗"加工具有一定意义

This paper analyses the coupling wastage in columniform wave guide gas laser,and gives the function between the coupling wastage of laser guide modulo EH11 and the position and radius of reflector.

分析了圆柱形波导气体激光器中的耦合损耗，给出了最低阶波导模EH11的耦合损耗与反射镜位置、曲率半径的函数关系。研究表明：反射镜的位置和半径存在着最佳值，在取得最佳值时，可得到最低的耦合损耗

However,the analysis and design of parallel windings are more complicated.Parallel windings including litz wire,litz PCB,twisted and common parallel PCB are evaluated,then respective eddy current loss analytical models were built and systematical algorithm were also proposed for the loss models programming.

与采用单根导体的线圈比较，并联线圈不论损耗模型还是设计技术都有很大的不同，其线圈涡流损耗频率特性影响因素多[1-3]，很复杂，特别是对应用于平面变压器的并联PCB线圈，很难根据对高频涡流效应的直观理解和已有的高频功率变压器线圈损耗模型对其进行设计分析。

The impact of pump depletion on gain spectrum is analyzed by comparing the gain spectra in pump depleted and pump undepleted regimes.

通过比较考虑抽运光损耗与忽略抽运光损耗增益谱的差别，分析了抽运光损耗对增益谱的影响。

The results of bend loss measurements for polymer optical fiber composed of different cores and claddings are tes-ted.

测试了不同材料和纤芯半径的塑料光纤中弯曲损耗随光纤弯曲半径和弯曲圈数的变化规律，结果显示弯曲损耗呈现随弯曲半径增加而下降的趋势，纤芯直径越大，临界半径越大，弯曲半径小于临界半径时，弯曲损耗呈现指数规律。

This invention discloses a duplexer and a multiplexer of the communication system and a method to realize them on a PCB circuit, which applies a 3db bridge and a low pass filter to constitute a hopstreet duplexer without waste band channels, in which, the signals are shunted and combined by the design of the circuit structure and power distribution of the 3-db bridge and phase offset function, the band filter of the low pass filter and the reflection function of a stopband to make up of a costless duplexer in theory to merge the two channels of different frequencies and reduce loss to increase volume and working bandwidth, then a multiplexer is formed by cascading multiple duplexers.

本发明涉及通信设备，公开了一种通信系统双工器和多工器以及双工多工方法，使得双工器和多工器能够在PCB电路上实现，并且体积小、损耗小、成本低、容量大。本发明中，采用三分贝电桥、低通滤波器构成无损耗频带信道合路的双工器，其中通过电路结构的设计并利用三分贝电桥的功率分配和相位偏移功能将各路信号进行分路和组合，利用低通滤波器的频带滤波和阻带反射功能联合三分贝电桥构造一个理论无耗的双工器，使两路不同频率的信道合路，降低的损耗、提高容量和工作带宽。通过多个上述双工器的级联构成多工器。

The impact of the bending radius and operating wavelength on the bending loss of monomode fibers is discussed and the macrobend loss model compared with the conventional core-infinite cladding model,which indicates that the cladding of the monomode fiber has an evident effect on the bend loss.

文章还讨论了弯曲半径及工作波长与单模光纤弯曲损耗之间的关系，并把这种关系与传统的弯曲损耗模型进行了比较，比较结果表明，单模光纤包层对弯曲损耗有很大的影响。

According to Some users investigation the cost to buy this machine can be paid off within one month by saving 3 or 4 working hrs a day through reducing waer of drill, grinding wheel, etc… Taking into consideration of that a standard reground drill can improve working speed and quality , its economic benefit will be greater than above mentioned.

据使用单位抽样调查考证，使用本机后，公节约磨钻头的自身损耗及砂轮损耗，工时损耗和钻头耐用度的提高，按每天使用3~4小时计算，一个月就收回了买机的成本。如果考虑到磨好的标准钻头，可提高工效，减少废品损失等因素，其经济效益更不可估量。

High strength: Aluminum-magnesium-silicon alloy wire possesses high strength, its min value of tensile strength is 170% of the value of general hard and round aluminum wire(H8), is a fine armored material;②Low loss:as a non-magnetism material, no eddy current loss will happened on aluminum-magnesium-silicon alloy wire; when under 20℃, itsunit resistance corresponding to 52.3~53.0%IACS (international annealed copper wire standard), so that, the heat loss caused by induced current is very low;③Light weight: the density of aluminum-magnesium-silicon is only 2.7g/cm3 it largely reduced the total weight of armored cable.

该电缆突出的优点是：①高强度：铝-镁-硅合金丝具有较高的强度，其抗拉强度的最小值都是普通硬圆铝线（H8）抗拉强度的170%，是一种较好的铠装材料；②损耗小：铝-镁-硅合金丝为非磁性材料，不存在涡流损耗；其在20℃时的电阻率相52.5~53.0%IACS，因此由感应电流产生的热损耗很小；③重量轻：铝-镁-硅合金丝的密度仅为2.7g/cm3，明显降低了铠装电缆的整体重量。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失